WenmarOpen by Wenmar Pro

Service bulletins for the 2011 Mazda Mazda3

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

284 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
01-013-18-34782018-07-02. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. Some vehicles may exhibit the check engine light on with DTC P0456 stored in the PCM memory. P0456: EVAP system leak detected (very small leak)The concern is most likely the result of the customer not getting the fuel cap completely closed after fuelingthe vehicle. This causes a small fuel vapor leak and turns DTC P0456 on.
04-003-18-34552018-05-14. Service bulletin. ENGINE AND ENGINE COOLING. Some customers may report a slight clunk/bang/buzz noise or jolt from the front of the vehicle. This concern will most likely occur during the vehicles first forward movement after starting the engine. This is a normal operating noise of the Anti-Lock Brake System (ABS). Do not attempt any repairs. If you encounter a customer complaint for this concern, explain that the noise comes from the ABS/TCS/DSC "Malfunction Detection Function" initial check and that there is no problem. This initial check is a necessary function to ensure the normal operation of the ABS/TCS/DSC system. It occurs when the vehicles first moves forward under the following conditions. NOTE: Some customers may describe that the noise does not occur all the time. It does occur all the time, but the sound is more likely to be heard on a slow start and not on a quick start (quick acceleration) when engine noise is louder.
SSPA92017-08-25. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ENGINE AND ENGINE COOLING. Mazda Motor Corporation is extending the warranty coverage for specific repair of instrument panel on certain 2010-2013 Mazda3 vehicles produced from May 6, 2010 through July 19, 2013. The warranty coverage for instrument panel replacement due to warping or a gap is extended to 7 years (84 months) from the original New Vehicle Limited Warranty (Normal Warranty) start date or April 30, 2018 whichever is later, with no mileage limitation. On certain 2010-2013 Mazda3 vehicles, the instrument panel just above the information display may be warping, generating a gap between the instrument panel and information display, if exposed to heat under high ambient temperature.
SSPA92017-08-25. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ENGINE. Mazda Motor Corporation is extending the warranty coverage for specific repair of instrument panel on certain 2010-2013 Mazda3 vehicles produced from May 6, 2010 through July 19, 2013. The warranty coverage for instrument panel replacement due to warping or a gap is extended to 7 years (84 months) from the original New Vehicle Limited Warranty (Normal Warranty) start date or April 30, 2018 whichever is later, with no mileage limitation. On certain 2010-2013 Mazda3 vehicles, the instrument panel just above the information display may be warping, generating a gap between the instrument panel and information display, if exposed to heat under high ambient temperature.
01-014-14-29322017-05-04. Service bulletin. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP; ENGINE. SOME VEHICLES MAY EXHIBIT THE CHECK ENGINE LIGHT ON WITH DTC P0456 STORED IN THE PCM MEMORY.• P0456: EVAP SYSTEM LEAK DETECTED (VERY SMALL LEAK) THE CONCERN IS MOST LIKELY THE RESULT OF THE CUSTOMER NOT GETTING THE FUEL CAP COMPLETELY CLOSED AFTER FUELING THE VEHICLE. THIS CAUSES A SMALL FUEL VAPOR LEAK AND TURNS DTC P0456 ON.
01-021-12-2695B2017-04-25. Service bulletin. ENGINE. SOME VEHICLES MAY EXHIBIT A SQUEAK NOISE FROM THE ENGINE COMPARTMENT WHEN THE VEHICLE STARTS MOVING AND/OR AT THE TIME OF TRANSMISSION SHIFTING. THIS IS CAUSED BY STICK-SLIP NOISE OCCURING AT THE CONTACT SURFACES BETWEEN THE NO. 4 ENGINE MOUNT RUBBER AND THE NO. 4 ENGINE MOUNT BRACKET WHEN THE ENGINE SHAKES BACK AND FORTH. TO CORRECT THE PROBLEM, THE NO. 4 ENGINE MOUNT IS REPLACED AND GREASE IS APPLIED ON THE CONTACT SURFACES OF THE NO. 4 ENGINE MOUNT BRACKET.
01-005-13-2738A2017-04-24. Service bulletin. ENGINE. SOME VEHICLES MAY EXPERIENCE DIFFICULTY WITH ENGINE STARTING IN THE WINTER (CRANKS BUT NO START), BUT CAN BE STARTED USING THE DE-CHOKE MODE WITH NO DTC RECORDED. THIS IS CAUSED BY IMPROPER CONTROL LOGIC OF THE PCM. TO CORRECT THE PROBLEM, THE CONTROL LOGIC OF THE PCM HAS BEEN CHANGED.DE-CHOKE MODE1.FULLY DEPRESS THE ACCELERATOR PEDAL AND CRANK THE ENGINE FOR 4 TO 5 SECONDS.2.TURN THE IGNITION SWITCH TO THE LOCK POSITION AND RELEASE THE ACCELERATOR PEDAL.3.START THE ENGINE WITHOUT DEPRESSING THE ACCELERATOR PEDAL.
01-013-13-27912017-04-14. Service bulletin. ENGINE. SOME VEHICLES MAY EXHIBIT A SQUEAK NOISE FROM THE ENGINE COMPARTMENT WHEN THE VEHICLE STARTS MOVING AND/OR AT THE TIME OF TRANSMISSION SHIFTING. THIS IS CAUSED BY STICK-SLIP NOISE OCCURRING AT THE CONTACT SURFACES BETWEEN THE NO. 4 ENGINE MOUNT RUBBER AND THE NO. 4 ENGINE MOUNT BRACKET WHEN THE ENGINE SHAKES BACK AND FORTH.
01-005-13-27382017-04-13. Service bulletin. ENGINE. SOME VEHICLES MAY EXPERIENCE DIFFICULTY WITH ENGINE STARTING IN THE WINTER (CRANKS BUT NO START), BUT CAN BE STARTED USING THE DE-CHOKE MODE WITH NO DTC RECORDED. THIS IS CAUSED BY IMPROPER CONTROL LOGIC OF THE PCM. TO CORRECT THE PROBLEM, THE CONTROL LOGIC OF THE PCM HAS BEEN CHANGED.DE-CHOKE MODE1.FULLY DEPRESS THE ACCELERATOR PEDAL AND CRANK THE ENGINE FOR 4 TO 5 SECONDS.2.TURN THE IGNITION SWITCH TO THE LOCK POSITION AND RELEASE THE ACCELERATOR PEDAL.3.START THE ENGINE WITHOUT DEPRESSING THE ACCELERATOR PEDAL.
1080M2017-02-23. Service bulletin. ENGINE. IF AN ENGINE ASSEMBLY IS REPLACED AFTER A CATASTROPHIC INTERNAL MECHANICAL FAILURE, CLEAN THE INTAKE MANIFOLD INTERNALLY BEFORE INSTALLING A REPLACEMENT ENGINE ASSEMBLY. IF THE INTAKE MANIFOLD IS NOT CLEANED PROPERLY, THE REPLACEMENT ENGINE MAY FAIL PREMATURELY.METALLIC DEBRIS FROM THE OLD ENGINE (WITH CATASTROPHIC INTERNAL MECHANICAL FAILURE) MAY REST INSIDE THE INTAKE MANIFOLD. WHEN THE NEW ENGINE ASSEMBLY IS INSTALLED, DEBRIS IN THE INTAKE MANIFOLD WILL BE INGESTED INTO THE NEW ENGINE AND CAUSE INTERNAL DAMAGE.CLEAN THE INTAKE MANIFOLD INTERNALLY TO REMOVE ANY DEBRIS FROM OLD ENGINE BEFORE INSTALLING THE NEW REPLACEMENT ENGINE ASSEMBLY.IF THE INTAKE MANIFOLD CANNOT BE PROPERLY CLEANED INTERNALLY, REPLACE IT.
01-016-16-32202017-02-23. Service bulletin. ENGINE. THERE IS A CONCERN THAT SOME WATER PUMPS ARE BEING REPLACED THAT ARE NOT FAULTY, DUE TO SIGNS OF A VERY SMALL COOLANT LEAK FROM THE BLEED HOLE. THIS SERVICE BULLETIN IS TO INFORM YOU ABOUT THE WATER PUMP SEALING MECHA-NISM AND THE CRITERIA IF REPLACEMENT IS NECESSARY OR NOT.
01-015-16-32342017-02-22. Service bulletin. ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). SOME VEHICLES MAY EXPERIENCE THE CHECK ENGINE LIGHT ON WITH DTC P2096:00 (TARGET A/F FEEDBACK SYSTEM TOO LEAN). THIS IS CAUSED BY IMPROPER CONTROL LOGIC OF THE PCM. TO ELIMINATE THE CONCERN, THE CONTROL LOGIC OF THE PCM HAS BEEN CHANGED.
1102M2017-02-21. Service bulletin. ENGINE. WORKSHOP MANUAL EVAP SYSTEM LEAK INSPECTION USING THE M-MDS HAS BEEN DISCONTINUED FOR SOME MODELS. INSTEAD, THE WORKSHOP MANUAL EVAP SYSTEM LEAK INSPECTION USING EVAP LEAK TESTER WILL BE USED TO TROUBLESHOOT EVAP SYSTEM LEAKS.
1080M2016-12-01. Service bulletin. ENGINE. IF AN ENGINE ASSEMBLY IS REPLACED AFTER A CATASTROPHIC INTERNAL MECHANICAL FAILURE, CLEAN THE INTAKE MANIFOLD INTERNALLY BEFORE INSTALLING A REPLACEMENT ENGINE ASSEMBLY. IF THE INTAKE MANIFOLD IS NOT CLEANED PROPERLY, THE REPLACEMENT ENGINE MAY FAIL PREMATURELY.METALLIC DEBRIS FROM THE OLD ENGINE (WITH CATASTROPHIC INTERNAL MECHANICAL FAILURE) MAY REST INSIDE THE INTAKE MANIFOLD. WHEN THE NEW ENGINE ASSEMBLY IS INSTALLED, DEBRIS IN THE INTAKE MANIFOLD WILL BE INGESTED INTO THE NEW ENGINE AND CAUSE INTERNAL DAMAGE.CLEAN THE INTAKE MANIFOLD INTERNALLY TO REMOVE ANY DEBRIS FROM OLD ENGINE BEFORE INSTALLING THE NEW REPLACEMENT ENGINE ASSEMBLY.IF THE INTAKE MANIFOLD CANNOT BE PROPERLY CLEANED INTERNALLY, REPLACE IT
01-014-142016-04-12. Service bulletin. ENGINE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
01-021-122016-03-16. Service bulletin. ENGINE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
01-021-132016-03-16. Service bulletin. ENGINE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
01-021-132016-03-16. Service bulletin. ENGINE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
01-021-132016-03-16. Service bulletin. ENGINE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
01-013-132016-03-16. Service bulletin. ENGINE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
01-005-13BB2016-03-16. Service bulletin. ENGINE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
01-005-132016-03-16. Service bulletin. ENGINE; ELECTRICAL SYSTEM:SOFTWARE. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
SB-01-018-112011-07-13. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE. MAZDA: THERE IS A RATTLE NOISE FROM THE ENGINE DUE TO A STRETCHED TIMING CHAIN. *RM UPDATED 4/18/2012. *KB

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.