Service bulletins for the 2021 Mazda CX-30
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
616 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Engine are shown. Show all
| 01-004-23 | 2023-03-03. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may have the check engine light on with DTC P0524:00 or P055F:00 stored in memory. Contamination in the engine oil may cause the engine oil solenoid valve to become stuck, resulting in improper operation of the oil pump and improper oil pressure. DTC P0524:00 (Engine oil pressure too low), DTC P055F:00 (Engine oil pressure malfunction). The control software of the PCM has been modified to eliminate this concern. In addition, the production process has been modified to reduce contamination in the engine oil solenoid valve, oil pump, spacer and oil filter. |
|---|---|
| 01-001-23a | 2023-03-03. Service bulletin. ENGINE AND ENGINE COOLING. Some customers may complain about a poor acceleration and rough idling or the CHECK ENGINE light ON with DTC P0301:00, P0302:00, P0303:00, P0304:00.NOTE: Only turbo engines are applicable; non-turbo engines are NOT applicable. In most cases, DTCs P030X stores, but sometimes not. Sometimes the CHECK ENGINE light does not recognize this engine concern. This is caused by the variable valve in the exhaust manifold seizing and causing the exhaust port to become hot and the exhaust valve seat to wear unevenly, resulting in compression leakage. To eliminate this concern, the design of the exhaust manifold has been modified. |
| 01-003-23 | 2023-02-02. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may have a "LOW ENGINE OIL LEVEL" warning message and an engine oil level warning light on in the instrument cluster with DTC P250F:00 stored in memory, and the oil level has actually decreased to near low. - DTC P250F:00 - Engine oil level signal: engine oil level low This is caused by an oil consumption increase due to damage of the valve seals on the exhaust side. To eliminate this concern, the design of these valve seals has been modified. |
| 01-001-23 | 2023-02-02. Service bulletin. ENGINE AND ENGINE COOLING. Some customers may complain about a poor acceleration and rough idling or the CHECK ENGINE light ON with DTC P030X:00 (only turbo engines are applicable; non-turbo engines are NOT applicable). - In most cases, P030X is stored, but sometimes not. - Sometimes the CHECK ENGINE light does not recognize this engine concern. This is caused by the variable valve in the exhaust manifold seizing and causing the exhaust port to become hot and the exhaust valve seat to wear unevenly, resulting in compression leakage. To eliminate this concern, the design of the exhaust manifold has been modified. |
| RF-23-01 | 2023-02-02. Service bulletin. ENGINE AND ENGINE COOLING. When servicing SKYACTIV engine vehicles requiring to replace the Oil Galley Plug and Crush Washer, order the required part numbers below. These parts are not listed in GEPC and were previously listed as "non-serviceable" in the cylinder block diagram. |
| 01-017-22 | 2023-01-05. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may experience an engine stall when hard accelerating from a stop (often difficult to reproduce on a test drive), no codes are stored and the vehicle easily restarts with no other drivability concerns. This is only caused in certain situations by the torque reduction calibration in the PCM software. To correct this issue, the control software of the PCM has been modified to optimize the torque reduction feature. |
| MT-004-22 | 2023-01-05. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may experience the Check Engine Light ON with DTC P0171 (Fuel Trim too Lean) and possibly DTCs P030X (Misfire). Vehicles having this concern should use the following Inspection/Repair procedure. |
| 01-011-22a | 2022-12-02. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may have a "LOW ENGINE OIL LEVEL" warning message and a CHECK ENGINE light illuminated in the instrument cluster with DTC P250F:00 stored in memory, and the oil level has actually decreased to near low. - DTC P250F:00 - Engine oil level signal: engine oil level low This is caused by an oil consumption increase due to damage of the valve seals on the exhaust side. To eliminate this concern, the design of these valve seals has been modified. |
| 01-013-22 | 2022-11-04. Service bulletin. ENGINE AND ENGINE COOLING. Some customers may experience the CHECK ENGINE light ON with DTC P0126:00 (Thermostat stuck open) and one or more of the following symptoms: * The engine takes longer to warm up * The engine temperature gauge fluctuates * The low coolant temperature indicator (blue) light stays on longer or comes on while driving * Poor heater performance, especially at idle NOTE: * Vehicles with SKYACTIV-G 2.5T are not applicable. * If DTC P2B61:00 (Coolant control valve circuit range/performance) accompanies, this information is not applicable. Diagnose according to the instructions in MGSS. Due to production variety of the failsafe thermostat integrated in the coolant control valve, engine coolant may enter into a dry hollow in the failsafe thermostat, resulting in unintended opening of the failsafe thermostat at lower temperatures (104-176 °F (40-80 °C)). To eliminate this concern, the production process of the coolant control valve has been modified. |
| 01-012-22 | 2022-11-04. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may exhibit accumulation of dried coolant (1) around the water pipe (2). This is caused by a gap between the housing and pipe due to a press fitting during the manufacturing process. The accumulated coolant is solidified and plugs the gap in high temperature environment and the seepage is stopped and does not progress. This is normal and does not require a part replacement, clean off the dried coolant from around the pipe with a wire brush. |
| 01-011-22 | 2022-11-04. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. Some vehicles may have a "OW ENGINE OIL LEVEL" warning message and a CHECK ENGINE light illuminated in the instrument cluster with DTC P250F:00 stored in memory, and the oil level has actually decreased to near low. * DTC P250F:00 - Engine oil level signal: engine oil level low This is caused by an oil consumption increase due to damage of the valve seals on the exhaust side. To eliminate this concern, the design of these valve seals has been modified. |
| SA-065-22 | 2022-11-04. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles equipped with a coolant control valve may exhibit difficulties when refilling the coolant because the control valve is closed and air in the engine cannot escape during ignition ON. Therefore, turn the ignition OFF when refilling engine coolant using the radiator filler neck. |
| SA-023-22 | 2022-05-05. Service bulletin. ENGINE AND ENGINE COOLING. A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts. |
| SA-018-22 | 2022-05-05. Service bulletin. ENGINE AND ENGINE COOLING. The WSM shows 3 possible crankshaft sprocket and timing chain combinations (Type A, B and C), but some vehicles have been produced with a combination of Type A timing chain with 2 yellow-colored links with a Type B crankshaft sprocket. |
| SA-013-22 | 2022-04-06. Service bulletin. ENGINE. A new cylinder head assembly for service parts has been newly established for SKYACTIV-G 2.5 with cylinder deactivation when replacement is needed. Valves, valve springs, valve spring seats, and cotters (IN/EX) are included in the new assembly. |
| 09-010/22 | 2022-04-05. Service bulletin. ENGINE; ELECTRICAL SYSTEM. Some customers may complain about frequent low battery warning message appearing in the instrument cluster. The warning message appears when the power saving mode is activated to avoid a drained battery. Depending on the customer usage, the warning message may appear more frequently due to the condition for the power saving mode to be activated sooner and to be deactivated later. To eliminate this concern, the control software of the BCM has been modified to change the condition for the power saving mode to be activated and deactivated. *Activation of the power saving mode: The accumulated time 30 minutes has been extended to 90 minutes. *Deactivation of the power saving mode: Driving or engine running for 5 minutes has been shortened to 3 seconds. |
| 01-001/22a | 2022-04-05. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. Some vehicles may exhibit an excessive body vibration when idling or driving after being left in extremely cold weather (-20°C/-4°F or below) for a long time. This is caused by the No.1, No. 3 and No. 4 rubber hardening due to material characteristics. NOTE: This concern only happens in extremely cold weather, therefore this TSB is only applicable for extremely cold regions. To eliminate this concern, the cold environment performance of the engine mount rubber has been increased by changing the rubber material. |
| 01-001-22 | 2022-03-04. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. Some vehicles may exhibit an excessive body vibration when idling or driving after being left in extremely cold weather (-20°C/-4°F or below) for a long time. This is caused by the No.1, No. 3 and No. 4 rubber hardening due to material characteristics. NOTE: This concern only happens in extremely cold weather, therefore this TSB is only applicable for extremely cold regions. To eliminate this concern, the cold environment performance of the engine mount rubber has been increased by changing the rubber material. |
| 00-001-22 | 2022-03-04. Service bulletin. POWER TRAIN; SERVICE BRAKES, HYDRAULIC; ENGINE AND ENGINE COOLING; STEERING. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. |
| SA-031-21c | 2022-01-05. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN. New Cylinder Head Assembly Established: A new cylinder head assembly for service parts has been newly established for SKYACTIV-G 2.5 with cylinder deactivation when replacement is needed. Valves, valve springs, valve spring seats, and cotters (IN/EX) are included in the new assembly. |
| 01-012-21-3832a | 2021-12-02. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. Some vehicles may have a “LOW ENGINE OIL LEVEL” warning message and a CHECK ENGINE light illuminated in the instrument cluster, along with DTC P250F:00 stored in memory. DTC P250F:00 - Engine oil level signal: engine oil level low. Upon inspecting the engine oil level, the level is found to be low and there doesn’t appear to be any trace of oil leakage in the engine compartment. This concern usually occurs when the mileage reaches approximately 3,100 – 4,700 miles (5,000 - 7,500km) and may also occur again after replacing or topping off the engine oil. The root cause of this concern has not been identified yet, therefore a repair procedure will be announced at a later date. Since this issue has been reported after a valve stem seal modification, it is very likely that valve stem seal damage is causing oil to leak into the combustion chamber. |
| SA-031-21c | 2021-11-01. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. A new cylinder head assembly for service parts has been newly established for SKYACTIV-G 2.5 with cylinder deactivation when replacement is needed. Valves, valve springs, valve spring seats, and cotters (IN/EX) are included in the new assembly. Dealers can now utilize the Limited Parts Ordering (LPO) page on eMDCS to order the repair parts for 2.5L (with cylinder deactivation) and 2.5L turbo cylinder head repairs. There is no longer a need to contact hotline for part ordering. If there are any questions on part ordering or part status, contact the DAG group for assistance. |
| SA-031-21b | 2021-11-01. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN; EQUIPMENT. A new cylinder head assembly for service parts has been newly established for SKYACTIV-G 2.5 with cylinder deactivation when replacement is needed. Valves, valve springs, valve spring seats, and cotters (IN/EX) are included in the new assembly. |
| 01-012-21-3832 | 2021-10-31. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ENGINE AND ENGINE COOLING; TIRES:VALVE. Some vehicles may have a LOW ENGINE OIL LEVEL warning message and a CHECK ENGINE light illuminated in the instrument cluster, along with DTC P250F:00 stored in memory. DTC P250F:00 - Engine oil level signal: engine oil level low. Upon inspecting the engine oil level, the level is found to be low and there doesn't appear to be any trace of oil leakage in the engine compartment. This concern usually occurs when the mileage reaches approximately 3,100 - 4,700 miles (5,000 - 7,500km) and may also occur again after replacing or topping off the engine oil. The root cause of this concern has not been identified yet, therefore a repair procedure will be announced at a later date. Since this issue has been reported after a valve stem seal modification, it is very likely that valve stem seal damage is causing oil to leak into the combustion chamber. |
| SA-047-21 | 2021-10-05. Service bulletin. ENGINE AND ENGINE COOLING. If you receive a customer concern about the CHECK ENGINE light coming on and DTC P3400 (cylinder deactivation system malfunction) stored, the cylinder deactivation oil control valve may be plugged with plastic debris from the oil filter wrapper. The debris may enter the center of the oil filter when poking a hole in the filter wrapper during removal, and then travel through the engine and plug the cylinder deactivation oil control valve. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.