WenmarOpen by Wenmar Pro

Service bulletins for the 2017 Mazda CX-3

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

519 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Body and frame are shown. Show all

Bulletins, newest first
09-022-18-34712018-07-02. Service bulletin. STRUCTURE:BODY:ROOF AND PILLARS. On some vehicles, one or more roof carrier brackets (A) may be installed in reverse (with arrows (B) facing outward). In this case, accessories, such as a roof carrier cannot be installed. Even if the accessory installation was possible, it may cause loose fitting, water leaks or other concerns.
09-021-18-34592018-05-14. Service bulletin. STRUCTURE:BODY:TRUNK LID; STRUCTURE:BODY:ROOF AND PILLARS; STRUCTURE:BODY:HOOD. Some vehicles may experience stains appearing on the hood, roof and/or trunk of the vehicle. This concern is most likely to be found in a cold weather areas just after the RAPGARD is removed at PDI. This may be caused by moisture which has been trapped and condensed between the paint and the RAPGARD. These types of stains can be removed with a heat gun or an infrared drier. If you encounter this concern during PDI, use a heat gun or an infrared drier to apply heat to the affected area to remove the stain(s).
09-014-18-34432018-04-23. Service bulletin. STRUCTURE. When encountering a vehicle with paint damage, refer to the "Mazda Pocket Paint Guide" to determine cause, prevention, remedy, and warranty coverage (if applicable).
09-047-17-33962018-02-26. Service bulletin. STRUCTURE:BODY. On some vehicles, one or more roof carrier brackets (A) may be installed in reverse (with arrows (B) facing outward). In this case, accessories, such as a roof carrier cannot be installed. Even if the accessory installation was possible, it may cause loose fitting, water leaks or other concerns. (C) - Bracket Unit. This concern was caused by improper assembly during vehicle production.
09-001-17-3296b2017-10-04. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS; STRUCTURE; ELECTRICAL SYSTEM. When dealing with customer complaints of excessive condensation and/or water within the headlamp unit, first determine if all the bulb sockets (including O-ring), seals and covers are present and correctly installed. In most cases you will find that the Bulb Seal No. 1 (A) or HID Bulb Seal No. 1 (B) and Bulb Seal No. 2 (C) socket covers have not been correctly installed or are missing due to improper prior repairs (i.e., customer replacing the headlamp bulbs or body shop not transferring them when replacing the headlamp unit(s) due to a collision). Any damage caused by missing socket covers, HID module seal (D), or missing bumper brackets (E) is not covered by warranty policy.
1098M2017-02-14. Service bulletin. STRUCTURE. WHEN REMOVING PARTS FROM A VEHICLE, TAKE CAUTION OF THIS SYMBOL "R". FAILING TO REPLACE THE NON-REUSABLE PART MAY CAUSE A SYSTEM FAILURE.
1098M2017-02-07. Service bulletin. STRUCTURE. WHEN REMOVING PARTS FROM A VEHICLE, TAKE CAUTION OF THIS SYMBOL "R". FAILING TO REPLACE THE NON-REUSABLE PART MAY CAUSE A SYSTEM FAILURE.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.