WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Kia Optima

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

293 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Latches and locks are shown. Show all

Bulletins, newest first
TSB_BOD2082020-07-06. Service bulletin. LATCHES/LOCKS/LINKAGES. TSB - This bulletin provides the procedure to perform a partial repair on the trunk latch base sub assembly on the certain Forte, Rio and Optima vehicles, which may exhibit a difficult-to-close/latch concern with the trunk lid.
TSB-GEN0852017-08-02. Service bulletin. LATCHES/LOCKS/LINKAGES; EQUIPMENT ADAPTIVE/MOBILITY. TSB: MANDATORY REPLACEMENT OF LOCKING/SECURITY HARDWARE - By design, certain fasteners utilized in various Kia models are strictly intended for ?one time use?. Though not limited to the following, some examples are: axle shaft nuts with stake collar, cotter pins, washers with locking tabs and other similar hardware, including threaded fasteners with pre-applied ?thread-locking adhesives.?
TSB BOD131_SA2192017-02-16. Service bulletin. SEATS; EQUIPMENT; LATCHES/LOCKS/LINKAGES. THIS BULLETIN DESCRIBES THE PROCEDURE TO REPLACE THE REAR SEAT LATCH MANUAL RELEASE CABLE ON SOME 2016 MY OPTIMA (JFA) VEHICLES, PRODUCED FROM AUGUST 28, 2015 TO DECEMBER 15, 2015, WHICH MAY EXPERIENCE DETERIORATION OF THE PLASTIC HANDLE ON THE REAR SEAT RELEASE LATCH. FOLLOW THE PROCEDURE OUTLINED IN THIS BULLETIN TO INSPECT AND, IF NECESSARY, REPLACE THE AFFECTED SEAT RELEASE LATCH ASSEMBLY WITH AN IMPROVED PART.
TSBBOD1312017-01-25. Service bulletin. SEATS:MID/REAR ASSEMBLY; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. SERVICE ACTION: REAR SEAT LATCH CABLE INSPECTION AND/OR REPLACEMENT (SA 219) - THIS BULLETIN DESCRIBES THE PROCEDURE TO REPLACE THE REAR SEAT LATCH MANUAL RELEASE CABLE ON SOME 2016MY OPTIMA (JFA) VEHICLES, PRODUCED FROM AUGUST 28, 2015 TO DECEMBER 15, 2015, WHICH MAY EXPERIENCE DETERIORATION OF THE PLASTIC HANDLE ON THE REAR SEAT RELEASE LATCH. FOLLOW THE PROCEDURE OUTLINED BELOW TO INSPECT AND, IF NECESSARY, REPLACE THE AFFECTED SEAT RELEASE LATCH ASSEMBLY WITH AN IMPROVED PART. KIA IS REQUESTING THE COMPLETION OF THIS SERVICE ACTION ON ALL AFFECTED VEHICLES.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.