Recalls that may apply to the 2003 Kenworth T2000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Other are shown.
| None found. |
| 2004299 | 2004-08-23. Other. On certain vehicles, the battery box brackets, used to support the battery box and step, may develop a crack in the inboard radius. A crack in the bracket may lead to premature failure of the bracket causing the step to fail without warning, when an individual steps on it, causing a fall. Correction: Dealers will replace the battery box brackets. |
|---|---|
| 2003163 | 2003-07-02. Other. On certain vehicles, the grabhandles were mounted too high and may limit the ability to maintain 3-points of contact at all times. This condition may cause a person to slip and/or fall and could lead to personal injury. Correction: Dealer will relocate the handle to the proper height. |
| 2003121 | 2003-05-05. Other. On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: Dealers will replace the bracket pins. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.