P0171 on the 2018 Jeep Wrangler
The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.
Nobody has written a description of this code yet.
| 1801420 | 2022-10-17. Service bulletin. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following DTCs have been set:P2C90 - Crankcase Ventilation System - Hose "A" Disconnected(APAC, EMEA and LATAM Only). P04FC - Crankcase Ventilation System Performance(APAC, EMEA and LATAM Only). P2453 - Particulate Filter Pressure Sensor "A" Circuit Range/Performance(APAC and EMEA only equipped with Gas Particulate Filter (GPF). P245F - Particulate Filter Pressure Sensor "B" Circuit Range/Performance(APAC and EMEA only equipped with Gas Particulate Filter (GPF). P0456 - EVAP System Small Leak. If DTC P0456 is present use wiTECH Small Leak Verification Test (SLVT) to determine if a leak is present in the system. P0171 - Fuel System 1/1 Lean(LATAM Only). P0172 - Fuel System 1/1 Rich(LATAM Only). P0128 - Thermostat Rationality(Sales Codes NA1 with NBQ or NB6 Only - APAC and EMEA Only). P050B - Cold Start Ignition Timing Performance(Sales Codes NA1 with NBQ or NB6 Only - APAC and EMEA Only). Customers may comment on one or more of the following:Excessive fan noise when the A/C is on MAX output. Rough idle at engine start up in colder ambient temperatures. Software enhancements also included in this update:Electric Vacuum Pump (EVP) update. Fan noise reduction. Low Speed Pre Ignition (LSPI) update. |
|---|---|
| S1918000008RevB | 2022-09-26. Service bulletin. Customer?s complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
| S1918000008RevC | 2022-09-15. Service bulletin. Customer?s complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
| S1918000008 | 2022-08-22. Service bulletin. Customer?s complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
| S1918000008 Rev. | 2022-07-18. Service bulletin. Customer?s complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
| S1918000008 | 2022-05-31. Service bulletin. Customer?s complaint may include a MIL-on with one or more of the following DTCs Active, Pending, or Stored in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 Bank 1 downstream O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
| 18-036-21 | 2021-05-24. Service bulletin. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following DTCs have been set:P02EE - Cylinder 1 Injector Circuit Performance(APAC, EMEA and LATAM Only). P02EF - Cylinder 2 Injector Circuit Performance(APAC, EMEA and LATAM Only). P02F0 - Cylinder 3 Injector Circuit Performance(APAC, EMEA and LATAM Only). P02F1 - Cylinder 4 Injector Circuit Performance(APAC, EMEA and LATAM Only). P2C90 - Crankcase Ventilation System - Hose "A" Disconnected(APAC, EMEA and LATAM Only). P04FC - Crankcase Ventilation System Performance(APAC, EMEA and LATAM Only). P2453 - Particulate Filter Pressure Sensor "A" Circuit Range/Performance(APAC and EMEA only equipped with Gas Particulate Filter(GPF)). P245F - Particulate Filter Pressure Sensor "B" Circuit Range/Performance(APAC and EMEA only equipped with Gas Particulate Filter (GPF)). P0456 - EVAP System Small Leak.If DTC P0456 is present use wiTECH Small Leak Verification Test (SLVT) to determine if a leak is present in the system. P0171 - Fuel System 1/1 Lean(LATAM Only). P0172 - Fuel System 1/1 Rich(LATAM Only). P0128 - Thermostat Rationality(Sales Codes NA1 with NBQ or NB6 Only - APAC and EMEA Only). P050B - Cold Start Ignition Timing Performance(Sales Codes NA1 with NBQ or NB6 Only - APAC and EMEA Only). Customers may comment on one or more of the following:Excessive fan noise when the A/C is on MAX output. Rough idle at engine start up in colder ambient temperatures. The following software enhancements are also included in this update:Electric Vacuum Pump (EVP) update. Fan noise reduction. Low Speed Pre Ignition (LSPI) update. |
| S1918000008 Rev. | 2021-02-16. Service bulletin. Customer's complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
| 18-014-20 REV. B | 2020-07-27. Service bulletin. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following DTCs have been set:P2C90 - Crankcase Ventilation System - Hose "A" Disconnected(APAC, EMEA and LATAM Only). P04FC - Crankcase Ventilation System Performance(APAC, EMEA and LATAM Only). P2453 - Particulate Filter Pressure Sensor "A" Circuit Range/Performance(APAC and EMEA only equipped with Gas Particulate Filter (GPF). P245F - Particulate Filter Pressure Sensor "B" Circuit Range/Performance(APAC and EMEA only equipped with Gas Particulate Filter (GPF). P0456 - EVAP System Small Leak. If DTC P0456 is present use wiTECH Small Leak Verification Test (SLVT) to determine if a leak is present in the system. P0171 - Fuel System 1/1 Lean(LATAM Only). P0172 - Fuel System 1/1 Rich(LATAM Only). P0128 - Thermostat Rationality(Sales Codes NA1 with NBQ or NB6 Only - APAC and EMEA Only). P050B - Cold Start Ignition Timing Performance(Sales Codes NA1 with NBQ or NB6 Only - APAC and EMEA Only). Customers may comment on one or more of the following:Excessive fan noise when the A/C is on MAX output. Rough idle at engine start up in colder ambient temperatures. Software enhancements also included in this update:Electric Vacuum Pump (EVP) update. Fan noise reduction. Low Speed Pre Ignition (LSPI) update. |
| 18-014-20 REV. A | 2020-05-26. Service bulletin. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following DTCs have been set:P0456 - EVAP System Small Leak.If DTC P0456 is present use wiTECH Small Leak Verification Test (SLVT) to determine if a leak is present in the system. P0171 - Fuel System 1/1 Lean(LATAM Only). P0172 - Fuel System 1/1 Rich(LATAM Only). P0128 - Thermostat Rationality(APAC&EMEA with Sales Codes NA1 with NBQ or NB6 Only). P050B - Cold Start Ignition Timing Performance(APAC&EMEA with Sales Codes NA1 with NBQ or NB6 Only). Customers may experience:Excessive fan noise when the A/C is on MAX output. Rough idle at engine start up in colder ambient emperatures. Software enhancements include:Electric Vacuum Pump (EVP) update. Fan noise reduction. Low Speed Pre Ignition (LSPI) update. |
12 on file from NHTSA, as of 2026-10-19. See them in the bulletin list. A bulletin lists model years: read the document for which vehicles it concerns.