WenmarOpen by Wenmar Pro

Recalls that may apply to the 1993 Jeep Grand Wagoneer

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
02V0530002002-02-15. POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:FLOOR SHIFT. ON CERTAIN SPORT UTILITY VEHICLES, IF A DRIVER HAS NOT PLACED THE SHIFTER LEVER FULLY INTO THE "PARK" POSITION AND LEAVES THE VEHICLE RUNNING, THE VEHICLE MAY UNEXPECTEDLY MOVE REARWARD AFTER SEEMING TO BE STABLE. Built 1992-06-01 to 1998-05-31.
99V3400001999-12-13. SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:ROTOR. VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR. Built 1991-02-28 to 1995-07-07.
93V2100001993-12-13. STEERING: STEERING WHEEL/HANDLE BAR. THE MOLDED PLASTIC PIN WHICH CONNECTS THE UPPER STEERING COLUMN SHAFT AND THE LOWER COLUMN SHAFT MAY HAVE BEEN SHEARED PRIOR TO INSTALLATION OF THE STEERING COLUMN ASSEMBLY INTO THE VEHICLE. IF THIS OCCURRED, THE UPPER STEERING SHAFT WILL SEPARATE FROM THE LOWER STEERING SHAFT.
93V0550001993-04-08. STRUCTURE:BODY:HATCHBACK/LIFTGATE. GREASE APPLIED TO THE LIFTGATE LATCH RUBBER BUMPERS TO EASE COMPONENT ASSEMBLY CAUSED THE BUMPER TO SWELL, INTERFERING WITH THE MOVEMENT OF THE LIFTGATE LATCH PAWL. THIS PREVENTS THE LIFTGATE LATCHING WHEN CLOSED AND DIFFICULT TO OPEN WHEN LATCHED. Built 1992-01-01 to 1992-10-01.
93V0510001993-04-02. SUSPENSION:FRONT. THE ECCENTRIC CAM ADJUSTER BOLTS IN BOTH FRONT LOWER SUSPENSION ARM-TO-FRONT AXLE BRACKET ATTACHMENTS MAY FAIL DUE TO ASSEMBLY MISALIGNMENT. Built 1993-01-01 to 1993-03-01.
92V1810001992-12-14. SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES. THE RETAINER CLIP WHICH SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL WAS NOT INSTALLED PROPERLY, AND COULD WORK LOOSE. Built 1992-10-01 to 1992-10-01.
Canada: Transport Canada, as of 2026-10-19
19930621993-04-29. Structure. THE LIFTGATE MAY BECOME DIFFICULT TO UNLATCH OR MAY NOT LATCH WHEN SHUT DUE TO AN INTERNAL RUBBER BUMPER INTERFERING WITH THE MOVEMENT OF THE LATCH PAWL. IF THE LIFTGATE DOES NOT LATCH PROPERLY WHEN CLOSED, THE LIFTGATE MAY OPEN WITHOUT WARNING WHILE THE VEHICLE IS BEING DRIVEN. CORRECTION: LATCH WILL BE INSPECTED AND REPLACED IF REQUIRED.
19930411993-03-30. Suspension. THESE VEHICLES MAY CONTAIN FRONT SUSPENSION CAM BOLTS WHICH MAY FAIL DUE TO ASSEMBLY MISALIGNMENT WHICH COUULD CAUSE THE BOLT TO BEND AND POSSIBLY CRACK DURING INSTALLATION. FAILURE OF THE BOLT MAY CAUSE THE VEHICLE TO PULL TO ONE SIDE WHEN THE BRAKES ARE APPLIED. THIS COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: FRONT SUSPENSION CAM BOLTS, CAM WASHERS AND NUTS WILL BE REPLACED WITH COMPONENTS OF A DIFFERENT DESIGN.
19930031993-01-14. Brakes. THE RETAINER CLIP THAT SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL MAY NOT BE PROPERLY INSTALLED, POSSIBLY PREVENTING FULL CLIP ENGAGEMENT. THIS COULD RESULT IN THE INPUT ROD SEPARATING FROM THE BRAKE PEDAL WITH SUBSEQUENT LOSS OF SERVICE BRAKES. CORRECTION: VEHICLES WILL BE INSPECTED FOR PROPER CLIP INSTALLATION AND IMPROPERLY INSTALLED CLIPS WILL BE REPLACED.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.