Service bulletins for the 2024 Jeep Compass
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
314 on file from NHTSA, as of 2026-10-19.
About B178F on the 2024 Jeep Compass: what the code means, and the bulletins and recalls about the same components.
By type
By component
By trouble code
By topic
Only bulletins with trouble code: B178F are shown. Show all
| 08-364-25 | 2025-11-05. Service bulletin. FORWARD COLLISION AVOIDANCE: WARNINGS; ELECTRICAL SYSTEM; LANE DEPARTURE: ASSIST. Not applicable to vehicles built for US market. Collision Warning And Lane Keep Assist Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● B178F-15 - Turn Signal Switch-circuit Short To Battery Or Open. ● B1051-15 - Column Switch Module Turnlights - Circuit Short To Battery Or Open. Customers may also comment on the following: ● The collision warning light and lane-keeping light Fig. 1 illuminate on the Instrument Panel Cluster (IPC) when the steering wheel is turned. NOTE: There are no other abnormal behaviors in the vehicle due to this concer This bulletin involves replacing the signal lever assembly. |
|---|---|
| 9100439 | 2024-10-31. Service bulletin. ELECTRICAL SYSTEM; STEERING. MODULE Steering Control Before replacing the steering column control module (SCCM) due to front or rear windshield wiper operation / blindspot inop / lane assistant inop/ DTC B178F-15 active, please follow these steps: 1.- Refer to TSB-08-219-24 MP - Rear Windshield Wipers Operate Continuously and TSB 08-136-24 REV. A - Adaptive Cruise Control (ACC) Module Update. 2.- Verify if failure is still present (review wipers, turn signal, blindspot and lane assistant status) and if DTCs still active. 3.- If failure still present, make sure all the switches' and airbag's harness are properly connected and there is no corrosion, disconnect the switches & reconnect them, and reverify the issue. 4.- Read at the BCM diagnosis session if BCM is receiving information from SCCM. Through diagnosis review if activation from wipers is requested, if turn signal, blindspot and lane assistant work. 5.- Do a hard reset of battery to BCM and evaluate if any DTC is set. Retest if failure still present. If there are no DTC's, physical defects, wipers inop, nor turn signal inop, then SCCM does not need to be replaced. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.