Service bulletins for the 2026 Jeep Cherokee
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
94 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Electrical system are shown. Show all
| S2608000037 | 2026-10-16. Service bulletin. ELECTRICAL SYSTEM. Negative Response 0X33 - Security Access Denied When Flashing BPCM With WiTech |
|---|---|
| S2608000037 | 2026-10-16. Service bulletin. ELECTRICAL SYSTEM. Negative Response 0X33 - Security Access Denied When Flashing BPCM With WiTech |
| S2623000056 | 2026-10-07. Service bulletin. ELECTRICAL SYSTEM. The Door Latch Module Has Active Faults With No Warning Indicators In Cluster |
| 08-332-26 REV. B | 2026-09-23. Service bulletin. ENGINE; ELECTRICAL SYSTEM. Hybrid Cooling Pump Emergency Mode Condition Customers may comment on one or more of the following: SYMPTOM: ● 12V battery is draining. NOTE: The auxiliary heat and battery coolant pumps can enter emergency mode and drain the 12V battery. ● A pump running at full speed noise may be heard from the engine compartment after the vehicle is turned off. This bulletin involves replacing the Auxiliary Heat Pump (AHP). |
| 08-178-26 REV. A | 2026-09-17. Service bulletin. STRUCTURE:BODY; ELECTRICAL SYSTEM. Flash: Power Liftgate Module (PLGM) Update Customers may comment on one or more of the following: ● The power liftgate chime remains active continuously and does not stop after the liftgate is closed or after an ignition cycle. ● The vehicle will not start due to a discharged battery. NOTE: Battery discharge caused by a continuously active liftgate chime or liftgate remaining open for an extended period. The following PLGM software enhancements are available with this software release: ● New Diagnostic Trouble Codes (DTCs) have been added to the PLGM to report out-of-range ambient temperature and the PLGM being left in plant mode. This bulletin involves reprogramming the PLGM with the latest software. |
| S2623000052 REV. A | 2026-09-10. Service bulletin. AIR BAGS; ELECTRICAL SYSTEM. Airbag Warning Light On or Intermittent. The Occupant Restraint Controller (ORC) May Have The Following DTCs (Active/Stored) |
| 08-326-26 REV. A | 2026-09-03. Service bulletin. ELECTRICAL SYSTEM. Malfunction Indicator Illuminated (MIL) - P04DF-00 Has Set Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set the following Diagnostic Trouble Code (DTC): ● P04DF-00 - Evap System Purge Control Valve 1 Performance/Stuck Open. |
| 08-326-26 | 2026-09-03. Service bulletin. ELECTRICAL SYSTEM. Malfunction Indicator Illuminated (MIL) - P04DF-00 Has Set Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set the following Diagnostic Trouble Code (DTC): ● P04DF-00 - Evap System Purge Control Valve 1 Performance/Stuck Open. |
| 23-034-26 | 2026-08-19. Service bulletin. STRUCTURE:BODY; ELECTRICAL SYSTEM. Door Latch 12V Battery Drain Customers must experience the following: SYMPTOM: ● The 12v battery is depleted. NOTE: Battery depletion is due to a door latch module issue. This bulletin involves replacing both front door and both rear door latch modules. |
| 9100880 | 2026-08-13. Service bulletin. ELECTRICAL SYSTEM. Cluster Assembly When the technician connects to the vehicle via Witech, they observe Stored and/or Pending DTC in the IPC for KM49, LB, KM74 Programs. The instrument cluster should not be replaced based solely on the presence of stored or pending DTCs in the IPC. Replacement should only be considered if the stored or pending DTC becomes active during the troubleshooting and diagnostic process. |
| 9100877 | 2026-08-13. Service bulletin. ELECTRICAL SYSTEM. Trailer Tow Wiring Harness If after installing Trailer Tow Kit the DTCM will not PROXI / B2204-00 ECU CONFIGURATION MISMATCH sets active in the BCM / ODOMETER begins to blink, please open a STAR Case and await instruction. |
| 08-307-26 | 2026-08-13. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN. AWD Drivetrain Control Module (DTCM) Reconfiguration Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● C0094-4B - 4WD/AWD Rear Differential Unit Temperature Sensor-over Temperature. ● C149B-98 - RDM-Component Or System Over Temperature. Customers may also experience one or more of the following: ● Poor AWD performance. ● 4WD Light illumination. This bulletin involves reconfiguring the DTCM. |
| 9100848 | 2026-07-02. Service bulletin. ELECTRICAL SYSTEM. If the Driver/Passenger Seat Adjsuter Switch is inoperable, seat back will not move or seat moves on its own: 1.Which function is not operating properly? *Forward/Backward *Recline Forward *Recline Backward *Height Adjustment *Multiple Functions 2.Is the concern constant or Intermittent? 3.If intermittent, how often does it occur? Daily, Weekly, Randomly 4.Does the seat move on its own without pressing any switch? Yes / No 5.Does the issue occur only while driving, only at key-on, or while the vehicle is parked? 6.Has the concern occurred after the vehicle has been sitting for an extended period (overnight or several hours)? 7.Does pressing the switch multiple times temporarily restore operation? 8.Have any other seat functions or electrical features been affected at the same time? 9.Has the seat adjuster switch or seat assembly been previously repaired or replaced? Before replacing the seat adjuster switch, verify power, ground, connector engagement, wiring integrity, and inspect for blown fuses or damaged harnesses. If no external issues are found and the concern is verified, an intermittent internal switch failure should be considered. |
| S2623000041 REV.A | 2026-07-02. Service bulletin. STRUCTURE:BODY; ELECTRICAL SYSTEM. Power Liftgate Intermittently Inoperative. Will Not Open/ Close. Liftgate/Hatch Ajar Message Displayed. Rev A |
| S268A000014 | 2026-07-02. Service bulletin. ELECTRICAL SYSTEM. Radio/ETM is Adding Approximately 27mA Draw to Vehicle When in Logistics Mode |
| 18-052-26 REV. A | 2026-07-02. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY; POWER TRAIN. Flash: Powertrain Control Module (PCM) Updates - PCR8A3 Technicians may find one or more of the following Diagnostic Trouble Code (DTC): SYMPTOM: ● **P22D3-00 - Turbo Turbine Inlet Valve Stuck Closed. DTC falsely sets. ● P016A-00 - Excessive Time To Enter Closed Loop Air/fuel Ratio Control. DTC falsely sets.** ● P04B6-00 - Fuel Fill Door Stuck Closed (Stored Status). NOTE: There will be no Malfunction Indicator Lamp (MIL) for this DTC. Customers may also experience one or more of the following: ● The vehicle will not start and cannot be keyed off. NOTE: The vehicles 12V system remains powered up. ● Poor combustion stability or "wavy" engine RPM oscillations during engine warm-ups. ● Engine Stop/Start (ESS) bumps or lack of refinement. ● Noisy/poor starts in extreme cold temperatures. ● Perceived after-run pump noise after vehicle is turned off. The following software enhancements are also available: ● **Disablement for DTCs P22D3-00 and P016A-00 setting.** ● Diagnostic improvements for DTCs, P013A-00, P013B-00, P013E-00 and P013F-00. ● Improved transitions between engine operating modes for emissions robustness. ● Scan tool improvement to show accurate state of after-run pump. ● Scan tool improvements for EVAP system data. ● Improved combustion stability during warm-up and catalyst-reheating mode. ● Improved ESS refinements. ● Optimization of after-run pump usage for lower 12V usage and perceived customer noise. ● Disablement of DTC P04B6-00 for falsely setting. ● Calibration update for EVAP system Service Leak Test. ● Improved engine starts at extreme low temperatures. This bulletin involves inspecting and possibly reprogramming the Battery Pack Control Module (BPCM), Drive Motor Power Inverter (DMPI), Electric Vehicle Control Unit (EVCU) and PCM with the latest available software. |
| S2608000006 REV.C | 2026-06-16. Service bulletin. ELECTRICAL SYSTEM. Limp Home Mode, Red Wrench Lamp Illuminated. DTCs P0C01-00 - Drive Motor A Current High And/Or P0C04-00 - Drive Motor B Current High |
| S2623000041 | 2026-06-16. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. Power Liftgate Intermittently Inoperative. Will Not Open/ Close. Liftgate/Hatch Ajar Message Displayed. |
| 111752 | 2026-06-16. Service bulletin. ELECTRICAL SYSTEM. ACTUATOR - A/C AND HEATER |
| S2623000035 REV.A | 2026-06-03. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. Door Will Not Close. E-Latch Inoperative. |
| 9100822 | 2026-06-03. Service bulletin. ELECTRICAL SYSTEM. If VIN is built before CP: April 28th, 2026, please order 06514796AA (DMPI bolts) along when replacing or servicing DMPI assembly. |
| S2623000035 | 2026-05-28. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. Door Will Not Close. E-Latch Inoperative. |
| 9100786 Rev 1 | 2026-05-20. Service bulletin. ELECTRICAL SYSTEM. TBM2.0H Setting U0080-00. Do not replace TBM ECU or SGW. If replacement is determined, Verify "Z" part number availability. Order a "Z" part number for all Exchange Orders, Warranty, Mopar, Customer Pay and Service Contract. Order "68" part number for New, Unsold units only. Under certain conditions, SGW Module may take longer to establish Ethernet communication after boot up. If it takes longer than 30 seconds, The TBM2.0H module will set DTC U0080 - Ethernet Bus 1. As soon as SGW responds, the TBM2.0H will demature the DTC and move it to STORED. This issue should not cause any customer related symptoms. Do not replace the following TBM Part Numbers: WL: 68639445AF,68637489AE,68663479AE. WS: 68734941AA,68729188AC. EJ: 68592344AI. KM: 68592343AL,68735975AD. DT: 68634362AJ,68624784AF,68624784AE,68735493AB,68735493AA. DJ (HDCC): 68608721AJ. If the TBM2.0H module has set the DTC U0080 and it is STORED or ACTIVE, please clear the fault and do nothing. No further diagnostics is required. ---------------------------------------------------------------------------------------------------- TBM2.0H Setting DTC B1E21 Do Not Replace the TBM ECU. Is triggered when the TBM Backup Battery is discharged, inactive, or drained. This can happen during the lifetime of the vehicle. TBM should NOT be replace for B1E21, since there is no fault on TBM. TBM battery is replaceable. Part number of the back-up battery inside TBM is 68597650AA. Do not replace the following TBM Part Numbers: WL: 68639445A$, 68663479A$. -------------------------------------------------------------------------------------------------------- TBM Setting DTC U0499-00 Please refer to SOL S268A000004 if you are attempting to replace or repair the telematics box due to DTC U0499-00. This DTC does not cause direct customer impact and cannot be cleared. Engineering is working on TBM software enhancements, tentative Q2 2026. Do not replace the following TBM Part Numbers: KM: 68592343A$ |
| S2608000006 REV.B | 2026-05-20. Service bulletin. ELECTRICAL SYSTEM. Limp Home Mode, Red Wrench Lamp Illuminated. DTCs P0C01-00 - Drive Motor A Current High And/Or P0C04-00 - Drive Motor B Current High |
| 08-208-26 REV. A | 2026-05-20. Service bulletin. ELECTRICAL SYSTEM. Radio Message "Power Surge On USB Detected" Customers may comment on the following: ● The radio displays the message: “Power surge on USB hub detected” Fig. 1. NOTE: After the message appears, no USB devices function in the hub (no charging, no data). NOTE: Hub operation does not return until the vehicle undergoes a full key cycle. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.