Recalls that may apply to the 2007 Infiniti G35
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 10V175000 | 2010-04-27. SEATS; AIR BAGS. NISSAN IS RECALLING CERTAIN MODEL YEAR 2005 THROUGH 2007 INFINITI G35 SEDANS MANUFACTURED FROM MARCH 29, 2004 THROUGH AUGUST 25, 2006 AND INFINITI G35 COUPES MANUFACTURED FROM APRIL 1, 2004 THROUGH MAY 30, 2007. THE WIRE HARNESS CONNECTING THE BELT TENSION SENSOR (BTS) AND THE OCCUPANT DETECTION SENSOR (ODS) CONTROL UNIT UNDER THE FRONT PASSENGER SEAT CAN EXPERIENCE RELATIVE MOVEMENT WHICH CAN CAUSE WEAR AND OXIDIZATION OF THE TERMINALS AND MAY CAUSE INTERRUPTION OF THE SIGNAL. Built 2004-04-01 to 2007-05-30. |
|---|---|
| 08V521000 | 2008-10-07. ELECTRICAL SYSTEM:SOFTWARE; AIR BAGS. NISSAN IS RECALLING 204,361 MY 2007-2008 ALTIMA, ALTIMA HYBRID, 350Z, 350Z ROADSTER, MY 2008 ALTIMA COUPE, ROGUE, MY 2009 MURANO, AND INFINITI MY 2007-2008 G35 SEDAN, MY 2008 G37 COUPE AND EX35 PASSENGER VEHICLES EQUIPPED WITH CONTINENTAL AUTOMOTIVE SYSTEMS' OCCUPANT CLASSIFICATION SYSTEM (OCS) CONTROL UNITS. A VARISTOR IN THE OCS CONTROL UNIT LOCATED IN THE PASSENGER SEAT CUSHION MAY HAVE BEEN MANUFACTURED OUT OF SPECIFICATION. UNDER CERTAIN CONDITIONS, THIS COULD CAUSE AN INTERRUPTION OF SIGNAL BETWEEN THE OCS AND THE AIR BAG CONTROL UNIT (ACU). Built 2007-04-05 to 2007-10-31. |
| 06V394000 | 2006-10-13. EXTERIOR LIGHTING:HEADLIGHTS. CERTAIN VEHICLES FAIL TO COMPLY WITH THE "VERTICAL GRADIENT" AND "HEADLAMP PHOTOMETRIC VALUES" REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, 'LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.' Built 2005-06-17 to 2006-09-08. |
| 2010129 | 2010-04-22. Electrical. On certain vehicles, the wire harness connecting the Belt Tension Sensor (BTS) and the Occupant Detection Sensor (ODS) control unit under the front passenger seat can experience relative movement, possibly caused by vehicle vibration or passenger loading on the seat cushion. The movement may cause the pin & sleeve terminals in the connecter to rub against each other. This could lead to a signal interruption from the BTS to the ODS control unit. If a signal interruption is detected, the passenger airbag is designed to suppress and, if this occurred, the red supplemental airbag warning light would flash & the amber front passenger airbag status light would illuminate to alert the vehicle operator that the passenger airbag is not operating. In a crash, non-operative airbags could increase the risk of personal injury or death. Correction: Dealers will secure the Belt Tension Sensor harness connector. |
|---|---|
| 2008363 | 2008-10-06. Other. On certain vehicles, a varistor in the Occupant Classification System (OCS) control unit located in the passenger seat cushion may have been manufactured incorrectly. Under certain conditions, this could cause an interruption of signal between the OCS and the Airbag control unit (ACU). This could result in the passenger airbag being suppressed. The (red) supplemental airbag warning light would flash & the (amber) front passenger airbag status light would illuminate to alert the vehicle operator, however in case of a crash a suppressed airbag could result in personal injury or death. Correction: Dealers will test the signal between the OCS & ACU and if necessary will replace the seat cushion containing OCS hardware. |
| 2006260 | 2006-10-11. Lights And Instruments. Certain vehicles fail to comply with the requirements of CMVSS 108 - Headlamp vertical gradient. Correction: Dealers will install updated headlamp assemblies. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.