WenmarOpen by Wenmar Pro

Service bulletins for the 2022 Hyundai Tucson

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

125 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Transmission and driveline are shown. Show all

Bulletins, newest first
26-AT-002H2026-02-24. Service bulletin. POWER TRAIN. Some Santa Fe (TMA) and Tucson (NX4A) vehicles equipped with a 2.5L GDI engine and 8 speed automatic transmission may have DTC U028700 (Lost Communication With Trans Fluid Pump Module) set by the transmission Electric Oil Pump (EOP). This DTC can cause the Idle Stop & Go (ISG) system to become inoperative. Follow the procedure in this bulletin to replace the Electric Oil Pump on affected vehicles.
24-AT-001H-12024-12-21. Service bulletin. POWER TRAIN. This bulletin provides the procedure for updating the automatic transmission TCU (Transmission Control Unit) software to improve shift quality, judder and hesitation when accelerating.
24-AT-002H2024-04-16. Service bulletin. POWER TRAIN. This TSB provides a procedure to diagnose and replace, if necessary, an automatic transmission with Incorrect Ratio DTC (transmission clutch slip in gear above limit) listed on Page 2.
24-AT-001H2024-03-05. Service bulletin. POWER TRAIN. This bulletin provides the procedure for updating the automatic transmission TCU and ECU software (Santa Fe ONLY) to improve shift quality, judder with ISG enabled and hesitation when accelerating.
23-FL-007H2023-12-22. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). This bulletin provides the procedure to update the Transmission Control Module (TCM) for the 2022MY Tucson (NX4/NX4a) vehicles and the Engine Control Module (ECM) for the 2022-24MY Tucson vehicles to improve operation of the Idle Stop and Go (ISG) system. Under certain circumstances the vehicle may not restart after ISG system has engaged and require a manual restart due to the lack of intake manifold pressure recovery.
23-AT-006H-22023-11-30. Service bulletin. POWER TRAIN. This TSB provides information to diagnose the push button shifter operation.
23-AT-008H-12023-10-02. Service bulletin. POWER TRAIN. If you are servicing an 8-speed front-wheel-drive vehicle equipped with automatic transaxle with one or more of the DTC or symptoms listed below, refer to the Service Procedure to diagnose the condition. • DIAGNOSTIC TROUBLE CODES: ➢ P070500 - Transmission range sensor circuit malfunction ➢ P070512 - Transmission range sensor circuit malfunction ➢ P070514 - Transmission range sensor circuit malfunction ➢ P07051C - Transmission range sensor circuit malfunction ➢ P070600 - Transmission range sensor circuit range/performance ➢ P070661 - Transmission range sensor circuit range/performance ➢ P070696 - Transmission range sensor circuit range/performance • SYMPTOMS: ➢ Malfunction Indicator Light (MIL) illuminated ➢ 5th gear fail-safe ➢ Intermittently won’t shift into D or R ➢ Intermittently won’t shift out of Park ➢ Intermittent ly no engine cr ank/n o start in “P” or “N” with or without MIL or DTC.
23-AT-014H2023-09-06. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM. The Shift-By-Wire (SBW) buttons have been made available as separate service parts for the SBW lever. If replacement of the SBW button is required due to one or more button plating peeling, replace the button(s) with a new one. Do not replace the complete SBW lever.
23-AT-003H-12023-09-06. Service bulletin. POWER TRAIN. If you are servicing an 8-speed vehicle with a “Check Engine” light on and one or more of the DTC listed, follow the service procedure and replace the related solenoid and harness.
23-01-014H-52023-09-06. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN. Hyundai has launched an anti-theft software upgrade and window decal campaign (Campaign 993), combined with an anti-theft steering wheel lock campaign (Campaign P32), in response to an increase in thefts of certain 2011-2022MY Hyundai vehicles not equipped with engine immobilizers targeted through social media. For certain vehicles that cannot be updated with the software (Campaign 993), Hyundai is offering customers steering wheel locks at the dealer (Campaign P32). This Dealer Best Practices Guide provides information to assist dealership personnel with customer questions relating to the immobilizer software upgrade, window decals and steering wheel lock ant-theft solutions available from HMA through Hyundai dealers.
23-AT-006H-12023-09-05. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This TSB provides information to diagnose the push button shifter operation. If you are servicing a vehicle with any symptoms listed below or DTCs (listed on Page 2) , follow the Service Procedure on Page 3. SYMPTOMS: • “Shifter System Malfunction” displayed in the cluster • Won’t shift into or out of gear or won’t shift out of Park • Incorrect gear display in cluster and/or won’t start
23-01-052H-12023-08-02. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM; POWER TRAIN. This bulletin provides information related to the cleaning of the cooling system and coolant change to address the following problem: • “Refill Inverter Coolant” warning light displayed on the cluster • No DTC’s present • Normal level of coolant in Inverter Reservoir Tank • Measured EWP Speed > 2,800 RPM The cause of the warning light is due to increased EWP Speed due to poor flow of coolant inside the cooling circuit. The coolant in the system will be discharged and any foreign substances in the circuit will be flushed out with new coolant added in the end. A new reservoir cap label will be added.
23-AT-008H2023-08-02. Service bulletin. POWER TRAIN. If you are servicing an 8-speed front-wheel-drive vehicle equipped with automatic transaxle with one or more of the DTC or symptoms listed below, refer to the Service Procedure to diagnose the condition.
23-01-051H-12023-07-01. Service bulletin. POWER TRAIN. This bulletin provides information related to the cleaning of the cooling system and coolant change to address the following problem: • “Refill Inverter Coolant” warning light displayed on the cluster • No DTC’s present • Normal level of coolant in Inverter Reservoir Tank • Measured EWP Speed > 2,800 RPM
23-01-052H2023-06-30. Service bulletin. POWER TRAIN. This bulletin provides information related to the cleaning of the cooling system and coolant change to address the following problem: • “Refill Inverter Coolant” warning light displayed on the cluster • No DTC’s present • Normal level of coolant in Inverter Reservoir Tank • Measured EWP Speed > 2,800 RPM The cause of the warning light is due to increased EWP Speed due to poor flow of coolant inside the cooling circuit. The coolant in the system will be discharged and any foreign substances in the circuit will be flushed out with new coolant added in the end. A new reservoir cap label will be added.
23-EE-002H2023-03-02. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN; ENGINE AND ENGINE COOLING. This bulletin provides information related to the Engine Control Module (ECM) / Hybrid Control Unit (HCU) software update for Tucson Hybrid (NX4 HEV) / Plug-in Hybrid (NX4 PHEV) vehicles to improve the following DTC and symptoms: 1. P1441 (EVAP System Flow During Non-Purge Condition) a. Misdiagnosis due to insufficient margin of pressure deviation when driving at constant speed with low engine load i. Logic improvement to eliminate misdiagnosis 2. P1A77 (Check Generator Belt) a. Misdiagnosis due to poor synchronization release when the engine is stopped i. Logic improvement to release synchronization even if CAM signal is active when engine is stopped 3. P00B7 (Engine Coolant Flow Low/Performance) a. ITM control error due to temporary ball valve stuck i. Improvement to ITM cleaning logic (1 time -> 5 times) 4. P2118 (Throttle Actuator Control Motor Current Range/Performance) / P0401 (EGR Flow Insufficient Detected) 5. P0236 (Turbocharger System Boost Sensor A Circuit Range/Performance) / P0299 (Turbocharger underboost) a. Failure due to EGR condensate freezing i. Change the EGR Flow diagnosis condition (-40℃ → -7℃) 6. P2B60 (Engine Coolant Flow Control Valve Position Sensor Circuit Range/Performance) a. Insufficient control at the end point when ITM cleaning logic completes operation i. Improve the ITM cleaning logic for better control 7. Oil Dilution: Some vehicles may experience increased oil consumption and white smoke due to the diluting of engine oil with fuel because of the frequent transition between EV ↔ Engine mode during the winter season a. Modify fuel injection strategy below 10℃ and add oil heating function based on the driving pattern.
22-FL-006H2022-09-27. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN. This bulletin provides the procedure to update ECU and TCU of a vehicle experiencing any of the following DTC: P013E - O2 Sensor Delayed Response - Rich to Lean Bank 1 Sensor 2 P0456 - Evaporative System
22-AT-010H2022-08-24. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the Service Procedure and replace the valve body internal harness and the input/output speed sensor.
22-HC-002H2022-08-24. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. This bulletin addresses a warning light “Refill Inverter Coolant” displayed on the instrument cluster, but inspection of the under hood blue coolant reservoir is found to be at normal level (not below “MIN” marking on the reservoir bottle). This may be caused by poor flow of antifreeze inside the low-conductivity coolant pipe from internal debris, resulting in unusual high EWP operation being detected. Follow the procedure outlined in this bulletin to flush/discharge debris from the cooling system and replace the blue coolant. To effectively resolve, the flushing must be performed section by section as instructed. After flushing of the cooling system is done, updated BSC-2 coolant will be installed.
22-AT-006H2022-06-10. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); POWER TRAIN. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the repair procedure and replace the related input/output speed sensor and harness.
22-AT-005H2022-05-10. Service bulletin. POWER TRAIN. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the repair procedure and replace the related solenoid and valve body harness.
22-AT-002H2022-04-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. Certain vehicles equipped with 8-speed automatic transmission may experience an automatic transmission fluid (ATF) leak at the rear cover. This type of leak is caused by a porous casting on the rear cover of the transmission.
22-AT-001H2022-02-08. Service bulletin. POWER TRAIN. This TSB provides a procedure to diagnose the push button shifter operation. If you are servicing a vehicle with any symptoms or DTC listed below, follow the Service Procedure, Page 2.
22-01-006H2022-02-08. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE AND ENGINE COOLING; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE:SOFTWARE. This bulletin provides the procedure to update the ECU and TCU software to improve drivability and shift quality when accelerating.
21-AT-009H2021-08-07. Service bulletin. POWER TRAIN. This TSB provides a procedure to diagnose the push button shifter operation.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.