WenmarOpen by Wenmar Pro

Service bulletins for the 2011 GMC Terrain

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1756 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Automatic transmission are shown. Show all

Bulletins, newest first
16-NA-0922017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ELECTRICAL SYSTEM. This technical bulletin provides a procedure to replace the control solenoid valve and transmission control module assembly to correct a condition of no forward or slips in forward and reverse operates normally, due to non-functioning pressure control solenoid located inside the control solenoid valve assembly
PIT5076C2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); EQUIPMENT:ELECTRICAL; STEERING:ELECTRIC POWER ASSIST SYSTEM. This Preliminary Information communication advises the technician to insure that global diagnostic service 2 diagnostic packages are up to date prior to learning the steering angle sensor for a diagnostic trouble code C710 symptom code 71 set in the electronic brake control module or the power steering control module. When rechecking for diagnostic trouble codes a U0074 U0077, U0180D, U01293, U0126, U0125, C0186, C0196, or C0287 are set and will not clear diagnose the Chassis bus. If no fault is found in the chassis bus check for an multiple diagnostic interface to data link connector issue. Technician is to try a different multiple diagnostic interface cable and attempt the steering angle sensor learn again following service information instruction then try to clear the codes again.
PIP5209A2017-08-15. Service bulletin. ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:WIRING; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). This Preliminary Information communication provides information to the technician about vehicles that have Diagnostic Trouble Code P00C6 and/or P228C set. Technician will need to inspect the terminals at the Engine Control Module for fit and tension as well as the crimp to wire connection. Terminals to inspect in the ECM are connector x2 terminals 3, 18, and 19 for the fuel rail pressure sensor. Also connector x3 terminals 16 and 32 for the high pressure fuel pump.
PIP4112N2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle. This is considered normal operation of the vehicle the throttle is delayed and opened slowly up to .7 seconds to help minimize driveline lash and clunking or will have approximately .5 seconds of zero torque to allow the transmission to shift to first gear.
PIP4990C2017-03-20. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. THIS PRELIMINARY INFORMATION COMMUNICATION ADVISES THE TECHNICIAN THAT SOME VEHICLES MAY HAVE A SERVICE ENGINE SOON THAT COMES ON. TECHNICIAN MAY FIND A DIAGNOSTIC TROUBLE CODE U0101 CURRENT OR STORED HISTORY. TECHNICIAN SO CHECK TERMINAL PIN FIT AT TRANSMISSION CONNECTOR, UNDER HOOD FUSE BLOCK. ALSO THE TRANSMISSION CONTROL MODULE GROUND WILL NEED TO BE INSPECTED. TECHNICIAN WILL REVIEW THE APPROPRIATE SERVICE INFORMATION DIAGNOSTICS FOR DTC U0101.
PIP5277B2016-09-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER; ENGINE. THIS PRELIMINARY INFORMATION COMMUNICATION PROVIDES INFORMATION TO THE TECHNICIAN ON THE STEPS TO DIAGNOSE AND REPAIR VEHICLES THAT HAVE A RESONANCE TYPE VIBRATION OCCURS BETWEEN 40 TO 60 MPH. IN MOST CASES THE ENGINE MUST BE UNDER A SLIGHT LOAD SUCH AS A/C COMPRESSOR ENGAGEMENT, LIGHT THROTTLE, AND IN 6TH GEAR TORQUE CONVERTER CLUTCH APPLIED. TECHNICIAN WILL RELAX THE ENGINE AND TRANSMISSION MOUNTS, THEN THE EXHAUST SYSTEM BY LOOSENING THE FRONT PIPE STUDS. ALSO WORK DOWN THE SYSTEM DISCONNECTING ONE EXHAUST HANGER AT A TIME. THEN TAKE THE VEHICLE ON A TEST DRIVE TO VERIFY THERE WAS IMPROVEMENT. IF ADDITIONAL STEPS ARE REQUIRED PLACE TWO SETS OF EXHAUST DAMPENERS ONE SET BEFORE AND ONE SET AFTER THE FRONT CATALYTIC CONVERTER. IT MAY BE REQUIRED TO MOVE THE PAIR OF DAMPENERS ALONG THE EXHAUST SYSTEM TO GET THE BEST RESULTS.
PI-0312A2012-05-02. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. CHEVROLET/GMC: FLUID LEAK FROM TRANSFER CASE (PTU) VENT. *KB
PI-0324-C2012-04-17. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE AND ENGINE COOLING. GMC/CHEVROLET/BUICK: TRANSMISSION PUMP NEEDS INSPECTING DUE TO ENGINE CRANKING BUT FAILS TO START, HAS NO FORWARD, NO REVERSE, TRANSMISSION LEAKS, HARD SHIFT AND NO CRANKING. *PE UPDATED 2/25/13. *PE UPDATED 1/29/2014 *JS
PIP-49902012-03-13. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. BUICK/CHEVROLET/GMC/PONTIAC/SATURN: SOME MODEL YEAR VEHICLES MAY EXPERIENCE SERVICE ENGINE SOON (SES) LAMP ILLUMINATED. ISSUE MAY BE CAUSED BY THE CONTROL SOLENOID/MODULE ASSEMBLY OR MAY HAVE DAMAGED OR POOR TERMINALS FOR UNDER HOOD FUSE BLOCK. *PE
PI-04482011-06-27. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). GM: MALFUNCTION LIGHT IS ON WITH FOUR POSSIBLE TROUBLE CODES STORED. *RM
PI-03762011-06-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. GM: THE MALFUNCTION INDICATOR LIGHT IS ON AND THE TRANSMISSION MAY SLIP DUE TO DEBRIS ENTERING THE CHANNEL PLATE. *RM

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.