WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Genesis G90

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

20 on file from NHTSA, as of 2026-10-19.

By type

By component

Only bulletins with type: Service bulletin are shown. Show all

Bulletins, newest first
25-BD-012H TSB2025-11-12. Service bulletin. EXTERIOR LIGHTING. This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
25-GI-009G2025-05-02. Service bulletin. ELECTRICAL SYSTEM. Certain Genesis vehicles may experience an inoperable horn from moisture or carbonization at the contact point. This bulletin provides a guide to inspect and replace the horns.
24-DS-003G2024-09-03. Service bulletin. WHEELS. This bulletin provides information to inspect and replace the front or rear wheel bearing hub assemblies for all Genesis vehicles. This procedure is applicable when noise (whirring, roaring, grinding, rumbling, etc.) is present which gets louder when driving with more speed.
21-BD-001G2024-04-11. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Genesis applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships. It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.
21-AT-015G2024-04-11. Service bulletin. POWER TRAIN. This TSB provides a procedure to diagnose and repair a transmission for the following Incorrect Ratio DTC (transmission clutch slipping more than 200 rpm in gear).
19-AT-014G2024-04-11. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This bulletin provides a procedure to diagnose an 8-speed automatic transaxle with a harsh and/or delayed shift.
19-AT-007G2024-04-11. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. This bulletin provides a procedure to transfer oil pressure data to the TCU using GDS Mobile. This procedure is necessary to reduce the TCU learning time and improve the shift quality. • Before replacing an automatic transmission: Input the data into the TCU using the GDS. • Before replacing a TCU: Back up the oil pressure data from the old TCU into the GDS and then transfer the data to the new TCM.
21-AT-012G2024-04-11. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This bulletin provides a procedure to transfer oil pressure data to the TCU using GDS Mobile. This procedure is necessary to reduce the TCU learning time and improve the shift quality. • Before replacing an automatic transmission (Pages 2~3): Input the data from the new transmission into the TCU using the GDS. • Before replacing a TCU (Pages 4~6): Back up the oil pressure data from the old TCU into the GDS and then transfer the data to the new TCM.
20-BD-009G2024-04-11. Service bulletin. SEATS. Some vehicles may experience seat noise and/or possible wobble movement from the seat bottom when the vehicle is turning. This bulletin describes the procedure to install an e-ring clip to the tilt pipe housing on the front seat.
19-BE-017G2024-04-11. Service bulletin. VISIBILITY:REARVIEW MIRRORS/DEVICES; ELECTRICAL SYSTEM; VISIBILITY. Certain vehicles (listed below) equipped with the HomeLink5 (Two Way Communication) mirror may experience programming and operating difficulties with the home garage system. This bulletin provides information related to some of the possible symptoms.
19-AT-023G2024-04-11. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. If you are servicing a vehicle with a transmission slipping concern, follow the Service Procedure shown below and perform a stall test. This TSB provides a procedure to test each clutch in the transmission. If the vehicle fails the stall test, replace the transmission. PASS: Stall speed is between 1700~2900 rpm (See shop manual for stall speed). FAIL: Engine revs to redline limit (6,000~6,500 rpm). If so, replace the transmission.
19-AT-012G2024-04-11. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. This TSB provides a procedure to diagnose and repair a transaxle for the following Incorrect Ratio DTC (transaxle clutch slipping more than 200 rpm in gear).
19-AT-008G2024-04-11. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. When servicing a vehicle with a “Check Engine light” and any of the DTCs listed below, follow the Service Procedure to replace the related solenoid and E-module or park position switch.
23-AT-007G2023-07-01. Service bulletin. POWER TRAIN. When servicing an 8-speed automatic transmission vehicle with a “Check Engine light” and any of the DTCs listed below, follow the Service Procedure and, if necessary, replace the E-module.
23-BD-007H2023-05-04. Service bulletin. STRUCTURE:BODY. Hyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships. It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.
23-AT-001G2023-04-04. Service bulletin. ENGINE AND ENGINE COOLING. When servicing a vehicle with a “Check Engine light” and any of the DTCs listed below, follow the Service Procedure to replace the related solenoid and E-module or park position switch.
23-BD-002G2023-02-02. Service bulletin. VISIBILITY. This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.