WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Freightliner Sprinter

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

87 on file from NHTSA, as of 2026-10-19.

About P20EE on the 2021 Freightliner Sprinter: what the code means, and the bulletins and recalls about the same components.

By type

By component

By trouble code

By topic

Only bulletins with trouble code: P20EE are shown. Show all

Bulletins, newest first
LI49.20-N-0795932025-08-01. Service bulletin. UNKNOWN OR OTHER. Check engine light with fault code P20EEFE in the CDI control unit CDI (N3/47) Complaint Check engine light is illuminated with fault code P20EEFE "The efficiency of component 'SCR catalytic converter' is not sufficient" stored in the CDI control unit (N3/47). Cause Excessive ammonia slip is being detected in the SCR system, often triggered by IUMPR (In-Use Monitor Performance Ratio) thresholds. This typically indicates that the SCR catalyst is not converting DEF (AdBlue) efficiently under moni- tored conditions. Common Driving Scenario: •Non-dynamic driving (e.g., highway cruising with cruise control set) •Minimal load changes, steady-state exhaust flow Contributing Factors: •Software influence – IUMPR (In-Use Monitor Performance Ratio) thresholds •DEF Overdosing – Over-injection due to faulty NOx sensors, dosing valve issues, or poor DEF quality •Low Exhaust or Catalyst Temperatures – Common under low-load conditions; reduces SCR conversion efficiency •Catalyst Degradation or Contamination – Aging catalyst or contamination from oil, coolant, or poor-quality DEF Remedy IMPORTANT: Do not replace any components unless instructed through TIPS. For Model Year 2019–2021 Vehicles: •Update the following control units to the latest available software: N3/47 - Motor electronics 'CDI43' for combustion engine 'OM651' (CDI) N118/5 - Selective catalytic reduction (SCR GEN3) •If no newer software is available, proceed with the inspection and documentation steps listed under the No Newer Software section. •Once all inspections are complete, open a TIPS case directed to the Powertrain Inbox, referencing this LI with the collected information and data. No Newer Software Vehicles: Perform the following steps in order. Document all findings with photos and actual values where applicable: 1. Tailpipe Wipe Test •Perform and photograph results. 2. NOx Sensor Harness Inspection •Check connectors, pins, crimps, and harnesses 3. Sensor Plausibility Checks •Record actual values for all pressure and temperature sensors: •Once with the engine cold (≥8 hours off) •Again, at full operating temp, engine idling 4. Smoke Test – Intake, Charge Air, Exhaust •Apply ≤26 psi from the tailpipe. •Seal at clean air line. •Manipulate components during the test. •Document any leaks. 5. DPF Data •Record actual values and regeneration history. 6. SCR Temp Sensor Wiring •Inspect wiring and pins. •Confirm sensor reaches operating temp while driving. •Document time to temp. 7. AdBlue Injector Inspection •Check for clogging or leaks. •Photograph nozzle(s). 8. AdBlue Pressure Test •Remove injector(s), perform 2–3 pressure tests. •Check for leaks and document with photos. 9. DEF Quality Check •Collect a sample. •Note color, clarity, separation, odor, and quantity. •Photograph the fluid and spray pattern. 10. DPF & SCR Visual Inspection •Separate exhaust downstream of DPF. •Inspect for soot, blockage, or damage. •Photograph findings. 11. SCR Catalyst Interior •Inspect for dried AdBlue residue. •Photograph the interior. 12. NOx Sensor Graphing •Perform multiple test drives at varying speeds. •Capture 3–4 graphs/screenshots of NOx sensor signals using XENTRY. •Include one at idle, engine warm. •Disconnect AdBlue valve, drive 30 min, capture 2–3 more graphs. •Once all inspections are complete, open a TIPS case directed to the Powertrain Inbox, referencing this LI with the collected information and data.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.