WenmarOpen by Wenmar Pro

Service bulletins for the 2026 Ford Maverick

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

30 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
SSM 550582026-08-03. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM; ENGINE; FUEL/PROPULSION SYSTEM. Some 2025-2026 Maverick vehicles built on or before 05-Dec-2025 and 2024-2026 Nautilus vehicles built on or before 04-Sep-2025 may exhibit limited power and display "Stop Safely Now" or "Service Vehicle Soon" stored in the message center after start up with diagnostic trouble codes (DTC) P0A5D, P0A60, P0A63, P0A6F, P0A72, P0A75, and/or P0E52 stored in the inverter system controller (SOBDMC). The Ford Diagnostic and Repair System (FDRS) may refer to this module as the "Secondary On-Board Control Module C". If the vehicle exhibits these conditions, replace the inverter system controller. Refer to Workshop Manual, Section 307-01B. For claiming, use causal part 7B012 and labor operations 12651D and 12651D58. NOTE: This article does not remove any RVC, Prior Approval or Warranty and Policy requirements for component replacement.
SSM 548222026-05-18. Service bulletin. STRUCTURE:BODY; ENGINE; UNKNOWN OR OTHER; POWER TRAIN. All 2026 Maverick non-Lobo vehicles equipped with a 2.0L engine and built on or after 04-May-2026 and all 2026 Bronco Sport vehicles built on or after 07-May-2026 are no longer equipped with an underbody tunnel shield (Maverick base part number 6011434/Bronco Sport base part number 7811434). The vehicle is not misbuilt and the installation of this part is not a warrantable repair. Do not submit a claim for this condition.
SSM 546312026-03-11. Service bulletin. ENGINE. Some 2020-2026 Escape and 2022-2026 Maverick 2.5L Duratec hybrid vehicles may require various repairs on the exhaust system. This may require removal of the exhaust heat exchanger. WSM, Section 309-00 Exhaust System > 2.5L Duratec hybrid > Removal and Installation > Exhaust Heat Exchanger has been revised to eliminate the need to remove the muffler assembly. The procedure steps and labor times have been updated to reflect this adjustment.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.