WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Ford Edge

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

147 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Wiring and fuses are shown. Show all

Bulletins, newest first
SSM 509702022-08-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ELECTRICAL SYSTEM:WIRING:CONNECTORS/PLUGS:ACCESORY POWER OUTLET/JACK/PORT/USB/SAE/CIGARETTE LIGHTER; EQUIPMENT ADAPTIVE/MOBILITY. Some 2021-2022 Edge vehicles may exhibit a concern during an accessory protocol interface module (APIM) software update where the vehicle fails to recognize the universal serial bus (USB) drive or center display screen does not acknowledge USB programming has started. If the Ford Diagnosis and Repair System (FDRS) application titled Module Update Repair has been performed previously but the vehicle fails to indicate that the USB programming has started, inform customers that they can continue to drive the vehicle and engineering is currently working on a solution, expected by the end of August 2022. Monitor OASIS for additional information and schedule service appointments for customers once the repair becomes available.
SSM 504562022-02-16. Service bulletin. BACK OVER PREVENTION; BACK OVER PREVENTION: SENSING SYSTEM: CAMERA; ELECTRICAL SYSTEM:WIRING. Some 2021-2022 Edge vehicles may exhibit various image issues such as infrared, distorted, glitching, flickering or fuzzy image in the rear view camera with DTC C1001 stored in the Image Processing Module B or Sync module and/or B115E stored in the body control module (BCM). This may be due to a poor circuit connection. Inspect both male and female sides of connectors C4357 and C2383A for loose, bent, or damaged terminals. Refer to Workshop Manual (WSM), Section 100-00 General Information > Wire Terminal Inspection and Removal. If there is damage detected, refer to cell 005 of the wiring diagram to perform the repair procedure. In addition to the wiring inspection, make sure the IPMB and the APIM are in the latest software level. If there is no damage, continue with the normal diagnosis.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.