WenmarOpen by Wenmar Pro

Service bulletins for the 2023 Chrysler Pacifica

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

361 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Backup camera are shown. Show all

Bulletins, newest first
S2208000045 REV.B2024-12-11. Service bulletin. BACK OVER PREVENTION: REARVIEW SYSTEM BRAKING. Backup Camera Poor Image Quality Inspection
90044522024-01-08. Service bulletin. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
S21080000152024-01-02. Service bulletin. BACK OVER PREVENTION. Uconnect Box Require Service Message
S14080003842024-01-02. Service bulletin. BACK OVER PREVENTION; LANE DEPARTURE. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
90033572024-01-02. Service bulletin. BACK OVER PREVENTION. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
91001322024-01-02. Service bulletin. BACK OVER PREVENTION. ENGINE ASSY - 3.6L AUTO TRANS Before replacing the engine due to an abnormal ticking noise, please check that the INTAKE Hydraulic Lash Adjusters are not "collapsed". If a collapsed INTAKE HLA is found, replace all INTAKE HLAs on the suspect cylinder head. The noise can occur at low or high RPMs, and at low or high temperatures. There are no Diagnostic Trouble Codes (DTC)s present. CAUSE: INTAKE Hydraulic Lash Adjuster may have a manufacturing issue that can cause the plunger to stick, generating valvetrain noise.
91001312024-01-02. Service bulletin. BACK OVER PREVENTION. Video router module Please review the latest version of SOL S2208000030 regarding DVD/blue ray issues. After updating software perform resets on both display or concern may still appear.
S238A0000492023-12-18. Service bulletin. BACK OVER PREVENTION. SXM Lockup (rearview camera function is not affected), Cannot Change Channel or Adjust Volume
S238A0000472023-12-18. Service bulletin. BACK OVER PREVENTION. Humming Noise Through Speakers While Vehicle Is Off
90044522023-10-30. Service bulletin. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
91001772023-08-21. Service bulletin. BACK OVER PREVENTION. 10.1" CENTER STACK Upper Display w/bezel For complaints of intermittent black or blank screens on the center stack display (this is a radio to display signal issue, not a rearview camera to display signal issue), prior to replacing this part, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
91001332023-07-31. Service bulletin. BACK OVER PREVENTION. ROCKER ARM ASSY - ROLLER ROCKER Case 1.- Before replacing the intake or exhaust rocker arms due to an abnormal ticking noise, please check that the INTAKE Hydraulic Lash Adjusters are not "collapsed". If a collapsed INTAKE HLA is found, replace all INTAKE HLAs on the suspect cylinder head (no need to replace rocker arms). The noise can occur at low or high RPMs, and at low or high temperatures. There are no Diagnostic Trouble Codes (DTC)s present. Case 2.- If the INTAKE camshaft or INTAKE rocker arm has excessive wear on the high lift profile (Rocker arm: slider, Camshaft: central lobe), replace the intake camshaft (1) in that cylinder head and all intake rocker arms (6).
08-028-232023-02-13. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Radio Over The Air Updating to S26.17 Software Version Battery drain on vehicle after connecting wiTECH to vehicle. This bulletin provides information regarding the latest Firmware Over The Air (FOTA) update and provides the service technician an overview of the steps a customer will need to take to complete the update. The radio software will be updated from S26.15 to S26.17. NOTE: National launch for this FOTA update is expected to begin February 09, 2023.
02-001-232023-02-13. Service bulletin. BACK OVER PREVENTION; POWER TRAIN. Front Hub Bearing Growling Noise Customers may experience a noise/vibration coming from the front end of the vehicle while driving. Wheel bearing growling noise in front when driving. This bulletin involves possibly replacing the either side front hub bearing(s).
S238A0000052023-02-13. Service bulletin. BACK OVER PREVENTION:DISPLAY FUNCTION. DVD Or Blu-Ray? INOP, cannot launch DVD player from Rear Screens
S1623000028 Rev.2023-02-13. Service bulletin. VEHICLE SPEED CONTROL; BACK OVER PREVENTION; POWER TRAIN; VISIBILITY; PARKING BRAKE. Outside Power Fold Rearview Mirror Noise Or Loose At Pivot. Mirror Contacts Door Window Glass In The Folded Position.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.