WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Chrysler 300

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

270 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
S18090000072022-05-31. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. Customer Complaint May Include Engine Oil Leak Or Consumption
S1809000007 Rev.2021-06-28. Service bulletin. ENGINE AND ENGINE COOLING. Customer Complaint May Include Engine Oil Leak Or Consumption
S1809000007 Rev.2021-04-26. Service bulletin. ENGINE AND ENGINE COOLING. Customer complaint may include engine oil leak/consumption.
90033572021-04-26. Service bulletin. ENGINE AND ENGINE COOLING. ADAPTER, Engine Oil Filter (Pentastar V6) All vehicles equipped with a 3.2L or 3.6L except for model year 2014 vehicles with leak concern: 1) Ensure the Oil Filter Adapter (OFA) Cap O-ring is seated in the proper groove in the cap and not damaged or cut. 2) If replacing the (OFA) due to a leak detected between (OFA) and block. Ensure the torque on the 5 bolts are torqued to 12nm. If not record the actual values, torque to 12nm and contact the FCA employees listed below. 3) Remove the (OFA) and replace the O-ring and gaskets only (Kit #68191356A$), NOT THE OFA. 4) If oil was drained, add oil dye to ensure the leak is repaired. For model year 2014 vehicles replace the Oil Filter Adaptor. 5) When replacing PN's 68310865A$ & 68308741A$, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
90014962020-10-26. Service bulletin. ENGINE; EQUIPMENT. CAP, Engine Oil, Fill (O RING, Oil Filler Cap) For all model years, models and engines using oil fill caps with O-Ring seals: These O-Rings are now available for service. The green O-Ring is part 68029299A$. The black O-Ring is to be serviced by the green O-Ring. The blue O-Ring (thicker cross section than green & black) is part 68029300A$.~ If ordering this oil filler cap for a warranty repair due to a damaged/missing O-ring, please note that returned caps replaced for an O-ring issue will be subject to chargeback.
S20080001132020-09-28. Service bulletin. ENGINE; ELECTRICAL SYSTEM. No Start Intermittently, Vehicle Requires Multiple Keyless Push To Start Attempts To Start Vehicle
90042272020-04-27. Service bulletin. ENGINE AND ENGINE COOLING. CORE, Heater (with tubes) When replacing the heater core for LA, LX, and LD vehicles, make sure to return not only the heater core but also the connecting tubes, seals and retainers. For any questions contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
18-099-192020-01-21. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may describe the following: Hearing a predetonation noise (Spark Knock) sound in the engine during acceleration.
18-089-192019-12-16. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE. wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK
90036802019-10-28. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING. RETAINER, Crankshaft Rear Oil Seal Oil leak from rear engine seal retainer or windage tray/gasket Check for other sources of leaks using dye such as gallery plugs, camshaft cup plug at rear of engine, rear of engine valley for possible MDS solenoid, VVT solenoid, block porosity or transmission leaks. If another source of the leak was identified, proceed with the appropriate repairs. Engineering is looking for assistance in determining root cause and a corrective action on crankshaft rear oil seals and windage tray/gaskets. For concerns related to rear crankshaft seal oil leaks and windage tray gaskets, please send an email to brenton.swank@fcagroup.com. Include the VIN, mileage, and any photos identifying where the leak is coming from using dye, such as: 1. Leak between rear seal and crankshaft (seal rolled during installation) 2. Leak between outer diameter of rear seal and retainer 3. Leak between rear seal retainer and engine block (Please record the 5 retainer bolts residual torque in tightening direction) 4. Leak between rear seal retainer and windage tray/gasket (Please record the oil pan bolts residual torque in tightening direction) If the source of the leak cannot be identified, please contact Brenton Swank at (248) 804-9386 or Brenton.Swank@FCAGroup.com If no response in 15 minutes, proceed with repair.
90041152019-10-28. Service bulletin. ENGINE. SEAL, Crankshaft Oil, Front Front crankshaft oil seal leak: For concern of front crankshaft seal leak please send an email to brenton.swank@fcagroup.com with VIN, Mileage, Photos and indicate where the leak is identified using dye such as: 1. Leak between the outer diameter of the seal to front cover? 2. Leak between the seal and damper 3. Leak through the damper bolt This will help in determining root cause and corrective action. For additional questions, please contact: Brenton Swank: Cell (248) 804-9386 or brenton.swank@fcagroup.com If no response in 15 minutes, proceed with repair.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.