Service bulletins for the 2014 Chevrolet Silverado
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
3313 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| PI0592F | 2020-01-21. Service bulletin. EQUIPMENT. This preliminary information bulletin provides information om Service Programming System (SPS) Error Codes (E4398, E4399, E4403, M4404, M4413, M6954, M6955, E4414, E4423, E4491 or E6961). |
|---|---|
| PIT5282F | 2020-01-21. Service bulletin. TRAILER HITCHES. This Preliminary Information communication provides information to the technician that a customer may request the factory Integrated Trailer Brake Control be bypassed and their aftermarket trailer brake controller be installed instead. Technician will need to gain access to the body harness. Install trailer brake controller harness General Motors part number 23184088 into Middle Bus Electrical Center (X61A). |
| PIT5434D | 2020-01-21. Service bulletin. SEATS. This Preliminary Information communication provides information to the technician only to provide additional tips when diagnosing a front heated seat concern and is not meant to be a diagnostic flow chart or replace Service Information. Always, perform and refer to Service Information for the latest diagnostic information and procedures. |
| PIT5479C | 2020-01-21. Service bulletin. SERVICE BRAKES. This Preliminary Information communication provides information to the technician about fluid leaking from the brake caliper piston area found during a service of the vehicle. The substance is actually excess assembly grease from the caliper boot and piston installation. This grease can be cleaned off and the rest of the service completed. |
| 100089009D | 2019-12-16. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. This informational bulletin provides information on key code security rules and information on GM keycode look-up applications. |
| 080310006G | 2019-12-16. Service bulletin. EQUIPMENT; TIRES; EQUIPMENT ADAPTIVE/MOBILITY; WHEELS. This technical bulletin provides a procedure on how to clean and resurface aluminum wheel bead seats for vehicles that have the condition of Tire Slowly Goes Flat, Tire Air Loss, Low Tire Pressure Warning Light Illuminated, Aluminum Wheel Bead Seat Corrosion. |
| 080089014F | 2019-12-16. Service bulletin. EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information for dealers/technicians on Use of Dealer Case Management (DCM) and Being Prepared for Contacting U.S. Technical Assistance (TAC). |
| 010842001M | 2019-12-16. Service bulletin. EQUIPMENT; EXTERIOR LIGHTING; EQUIPMENT ADAPTIVE/MOBILITY. This informational bulletin provides information for dealers/technicians on Exterior Lamp Condensation and Replacement Guidelines. |
| 19NA255 | 2019-12-16. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE. This preliminary informational bulletin provides frame coating repair information to correct a customer concern of wax coating on frame peeling, metal shows corrosion/rusting (U.S. and Canada Only). |
| 19NA212 | 2019-12-16. Service bulletin. ENGINE. This diagnostic tip provides a procedure to aid in performing a diagnostic test to verify if the camshaft alignment pin has been sheared away. |
| 18NA137 | 2019-12-16. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE. This Bulletin provides information for rebuilding fuel injectors in the event of an underhood fuel odor and/or extended cranking condition. |
| 19NA153 | 2019-12-16. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN. This technical bulletin provides a procedure to replace the torque converter and inspect the front pump and the TEHCM for metal. |
| PIP5330D | 2019-12-09. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have a coolant loss and/or coolant odor after driving the vehicle. Technician will need to test the cooling system looking for leaks at the outer head bolts. If coolant is found replace the head the concern is present on. |
| PIT5594B | 2019-12-09. Service bulletin. EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES. This Preliminary information communicates a normal DIC message after learning keys/fobs which indicates the drivers memory position. |
| PIT3271J | 2019-12-09. Service bulletin. WHEELS; SERVICE BRAKES, AIR:ANTILOCK. This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection. |
| PIT5404F | 2019-12-09. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a buffeting vibration and/or drone type noise, exhaust tone change, and/or body pressure booming. Replace or repair any of the issue that was found in the inspection. If the vehicle is equipped with a 4.3 liter or 5.3 liter engine an updated exhaust system is now available. |
| PIP5335D | 2019-12-09. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician will find Diagnostic Trouble Codes P0340 and P0341 setting at times. Technician should use normal published Service Information diagnostics. If normal Service Information diagnostics does not isolate the concern, inspect for corrosion in connector X154 located on the front cover next to the vacuum pump. |
| PIT5074M | 2019-12-09. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about the use of J-35616-64B terminal test probe, replacement terminals, and terminated leads. The J-35616-64B is the latest test probe released for checking tension or probing the .64 series terminals. The test probe terminal has been released in the terminal repair kit (J-38125-620H) located in Lear Tray 7 part number 963716-2. There are 5 terminated leads in a package part number is 13505346, which can be ordered through your normal General Motors Customer Care and Aftersales parts channel. |
| PIE0504A | 2019-11-25. Service bulletin. EQUIPMENT. This engineering informational bulletin is requesting information on a scraping noise heard from under the vehicle while driving. |
| 990420002K | 2019-11-25. Service bulletin. POWER TRAIN. This informational bulletin provides information on Driveline Clunk Noise and what is acceptable and what is considered normal operations. |
| 120851002K | 2019-11-25. Service bulletin. EQUIPMENT. This informational bulletin provides technicians and dealership personnel with spray-in bed liner general information and repair procedures. |
| 100605002H | 2019-11-25. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. This informational bulletin provides information on Clean Exhaust Filter See Owners Manual Now or Cleaning Exhaust Filter Keep Driving Until Message is Cleared messages Displayed on DIC, DTC P2463 May Be Set. |
| 100089009C | 2019-11-25. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information on key code security and information on GM key code look up applications. |
| 100089006G | 2019-11-25. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information for dealers how to submit a product information report (PIR) (Canada Only). |
| 060309004N | 2019-11-25. Service bulletin. SUSPENSION:FRONT:SPRINGS:LEAF SPRING ASSEMBLY. This technical bulletin provides a procedure to apply grease to the leaf springs to correct a condition of a squeak noise from the metals making contact. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.