WenmarOpen by Wenmar Pro

Service bulletins for the 2018 Chevrolet Cruze

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

991 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
16NA3772019-05-13. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. This informational bulletin provides information on a Service Emission System Message and/or a Malfunction Indicator Lamp illuminated. This usually occurs after recently filling the DEF tank with the ignition in the on position due to some DEF fill equipment uses pumps that create a high level of temporary aeration of the DEF fluid being dispensed in the tank.
100605002E2019-05-13. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM; EQUIPMENT. This informational bulletin provides information on Clean Exhaust Filter See Owners Manual Now or Cleaning Exhaust Filter Keep Driving Until Message is Cleared Message Displayed on DIC, DTC P2463 May Be Set.
070601016D2019-05-13. Service bulletin. ENGINE. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
000601012H2019-05-13. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. This informational bulletin advises the possible issues that may occur using a scotch brite pad or highly abrasive disk on gasket sealing surfaces or reused parts.
19NA0442019-04-22. Service bulletin. ENGINE. This informational bulletin provides information on a normal engine operating condition for faster emission warm up time.
PIP5151D2019-04-08. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE. This Preliminary Information communication provides information to the technician about vehicles that may have a hard start, no start, rough running, or low fuel pressure. Technician may find Diagnostic Trouble Codes P0087, P0088, P0191 and P128E during the inspection. If during the inspection of the fuel system contamination is found the complete fuel system will need to be cleaned and flushed. After the fuel system is cleaned out test the fuel using the latest version of PIT3173.
PIP55192019-04-08. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; ENGINE AND ENGINE COOLING. This Preliminary information communicates the possibility of the timing chain tensioner gasket being improperly installed or mis-positioned after major engine repairs causing a low engine oil pressure and dtc p06DE.
PIP55172019-04-08. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; ENGINE. This Preliminary information communicates the following to the dealer. If an engine oil leak has been isolated to the front crankshaft seal, check for misfires low engine compression and/or cylinder leakage readings. These issues could cause excessive positive crankcase pressure leading to engine oil leaks.
PIP5370B2019-04-08. Service bulletin. FUEL SYSTEM, DIESEL; ENGINE AND ENGINE COOLING:ENGINE:DIESEL. This Preliminary Information communication provides information to the technician that some vehicle may have an “ Exhaust Fluid Quality Poor ” on the Driver Information Center or a diesel exhaust fluid warning lamp on or other exhaust fluid quality related concerns. Technician will inspect the diesel exhaust fluid for contamination. Technician should use Service Information for Contaminants in Diesel Exhaust Fluid Diagnosis and use special tool J26568 or EN50422 Diesel Exhaust Fluid Refractometer for fluid testing.
PIP5472F2019-04-08. Service bulletin. ENGINE; FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician related to vehicles that have a Malfunction Indicator Lamp on. A technician may find Diagnostic Trouble Code P050D set as current or history. The technician is advised to first perform the SI diagnostic. That if the diagnostic fails to isolate the concern, then replace only the exhaust side SHLA's (Stationary Hydraulic Lash Adjuster) and to retest for the concern.
15NA0872019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This technical bulletin advises the technician to rest the MIL and diagnose additional DTCs for why the code is setting and disabling the start/stop system.
PIC5650F2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, and/or B3935. Technician should not replace any parts for this concern. If unable to duplicate the concern ask if the customer uses any Radio Frequency Identification Devices when the concern is present. Dealer should also direct their customers to the appropriate section in the Owner manuals that references that the device complies.
PIP5598A2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates the possibility of a crank no start or extended crank condition due to exhaust cam reluctor being out of position.
PIP5540B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP4925B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. This preliminary information document communicates a tip on the way to diagnose possible induction or exhaust air leaks using the evaporative emission cart smoke machine and ultrasonic leak detector tools.
18NA1712019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This technical bulletin provides a procedure to repair the mechanical components and then be sure to reprogram the throttle body to prevent the conditions of a rough running engine, MIL On from happening again.
PIP5540D2019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP56282019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates information that will need to be provided to TAC to aid in diagnosing if a vehicle comes in with misfire and DTC Codes P0300 - P0308 and/or P050D
PIP56232019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates that a rotational clicking noise heard after engine shut down is a design characteristic and no repairs should be attempted.
PIP5483B2018-12-17. Service bulletin. ENGINE; EQUIPMENT ADAPTIVE/MOBILITY. This Preliminary information communicates noises are considered to be normal operating characteristics of the vehicle when shut off. It will not impact the designed performance or reliability of the vehicle.
PIP55982018-11-13. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM; ENGINE; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV). This Preliminary information communicates the possibility of a crank no start or extended crank condition due to exhaust cam reluctor being out of position.
182392018-10-09. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. 18239 - Emissions Recall - General Motors has decided to conduct a Voluntary Emission Recall involving certain 2018 model year vehicles, equipped with 4-cylinder engines (RPO LHN, LEX, L3A, LYX, LKN, LE2, LCV or LTG). On some vehicles, an electrical connection in the circuit board may fail in the engine control module. If this occurs, a malfunction indicator lamp (MIL), such as the Check Engine Light may illuminate. Replace the Engine Control Module (ECM).
PIP5472E2018-09-17. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM; ENGINE. This Preliminary Information communication provides information to the technician related to vehicles that have a Malfunction Indicator Lamp on. A technician may find Diagnostic Trouble Code P050D set as current or history. The technician is advised to first perform the SI diagnostic. That if the diagnostic fails to isolate the concern, then replace only the exhaust side SHLA's (Stationary Hydraulic Lash Adjuster) and to retest for the concern.
PIP5557C2018-09-17. Service bulletin. ENGINE; POWER TRAIN. This Preliminary information communicates the Control Valve Body spacer plate orifice #33 may be restricted as root cause for themay not go above 30 mph, may be stuck in 2nd gear, will not upshift, MIL is on, and/or DTC P2821 concern,to replace the plate as necessary.
PIP5163D2018-09-17. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.