Recalls that may apply to the 2005 Cadillac SRX
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 14V394000 | 2014-07-02. ELECTRICAL SYSTEM:IGNITION. This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on July 2, 2014 that they are recalling 554,328 model year 2003-2014 Cadillac CTS vehicles manufactured August 16, 2001, to April 28, 2014, and 2004-2006 Cadillac SRX vehicles manufactured March 20, 2003, to August 11, 2006. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine. Built 2004-03-09 to 2005-06-03. |
|---|---|
| 07V589000 | 2007-12-20. POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT:SEAL. ON CERTAIN PASSENGER VEHICLES, THE REAR AXLE PINION SEAL DOES NOT MEET ALL OF THE SPECIFICATIONS AND MAY EXPERIENCE A FLUID LEAK. Built 2005-03-01 to 2005-06-30. |
| 06V125000 | 2006-04-20. SUSPENSION:REAR. CERTAIN VEHICLES HAVE A LEFT OR RIGHT REAR SUSPENSION TOE LINK THAT COULD SEPARATE BECAUSE OF AN INCORRECT WELD. Built 2004-09-01 to 2004-12-31. |
| 2014273 | 2014-07-02. Electrical. On certain vehicles, there is a risk that some drivers may bump the ignition key with their knee and unintentionally move the key from out of the "run" position. If this were to occur, engine power, power braking and power steering would be affected, which would unexpectedly increase steering and brake pedal effort, potentially increasing stopping distances and the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the "run" position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: Dealers are to remove the key blade from the original flip key/transmitter assemblies provided with the vehicle, and provide two new keys and two key rings for every original key. Important note: Until the correction is performed, drivers should adjust their seat and steering column to allow clearance between their knee and the ignition key. |
|---|---|
| 2007417 | 2007-12-19. Powertrain. On certain vehicles, the drive axle differential seal may leak (note that all-wheel drive vehicles have two seals). Reduced lubrication may cause the differential to become noisier. Continued use may cause damage to bearings and other differential components. Three conditions could occur: 1). When the vehicle is stopped and shifted to reverse, the differential may jam and prevent vehicle movement. 2). the damage can cause drag that will feel like the parking brake is applied; or 3) the differential could jam and lock the drive wheels while the vehicle is underway. Should the latter occur, it could result in a loss of vehicle control and a crash, causing injury or death. Correction: Dealers will replace the drive axle differential seal(s). |
| 2006086 | 2006-04-19. Suspension. On certain vehicles, an inadequate weld could cause the left or right rear suspension toe link assembly to separate. If this were to occur, the affected rear wheel would be able to turn in or out, which could compromise vehicle stability and cause a loss of vehicle control and a crash. Correction: Dealers will inspect and, if required, replace the left and right toe link assemblies. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.