Recalls that may apply to the 2010 Cadillac CTS
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 14V394000 | 2014-07-02. ELECTRICAL SYSTEM:IGNITION. This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on July 2, 2014 that they are recalling 554,328 model year 2003-2014 Cadillac CTS vehicles manufactured August 16, 2001, to April 28, 2014, and 2004-2006 Cadillac SRX vehicles manufactured March 20, 2003, to August 11, 2006. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine. Built 2009-02-12 to 2010-06-07. |
|---|---|
| 11V089000 | 2011-02-11. SUSPENSION:REAR. GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2009-2010 CADILLAC CTS VEHICLES. SOME OF THESE VEHICLES HAVE A CONDITION IN WHICH A WAX COATING ON THE REAR SUSPENSION TOE LINK JAM NUTS MAY ALLOW THE NUT(S) TO LOOSEN. IF A NUT SUFFICIENTLY LOOSENS, THE TOE LINK COULD SEPARATE AND THE REAR WHEEL WOULD BE ABLE TO TURN INBOARD OR OUTBOARD. OWNERS MAY HEAR A METALLIC CLANKING NOISE COMING FROM THE REAR OF THE VEHICLE THAT MAY WARN OF A LOOSENING NUT. Built 2009-02-12 to 2009-04-17. |
| 10V414000 | 2010-09-13. EQUIPMENT. GM IS RECALLING CERTAIN MODEL YEAR 2009-2010 CADILLAC CTS ALL WHEEL DRIVE AND CTS-V VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." Built 2009-03-01 to 2010-06-30. |
| 2014273 | 2014-07-02. Electrical. On certain vehicles, there is a risk that some drivers may bump the ignition key with their knee and unintentionally move the key from out of the "run" position. If this were to occur, engine power, power braking and power steering would be affected, which would unexpectedly increase steering and brake pedal effort, potentially increasing stopping distances and the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the "run" position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: Dealers are to remove the key blade from the original flip key/transmitter assemblies provided with the vehicle, and provide two new keys and two key rings for every original key. Important note: Until the correction is performed, drivers should adjust their seat and steering column to allow clearance between their knee and the ignition key. |
|---|---|
| 2011064 | 2011-02-11. Suspension. On certain vehicles, a wax coating applied to the rear suspension toe link jam nuts may allow the nut(s) to loosen. Should this occur, a metallic clanking noise may be heard coming from the rear of the vehicle. Ignoring this warning could result in a further loosened toe link, which could eventually separate, allowing the rear wheel to turn inboard or outboard. If this were to happen, sudden changes in vehicle handling could occur, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will clean all wax residue from the rear suspension toe link and install two new jam nuts. If required, the rear suspension toe link will be replaced. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.