WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Buick LaCrosse

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1240 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
PIP56282019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates information that will need to be provided to TAC to aid in diagnosing if a vehicle comes in with misfire and DTC Codes P0300 - P0308 and/or P050D
PIP5191C2018-12-17. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about vehicles that have a ticking noise on cold start after sitting more than 6 hours. Technician will inspect the oil pump pick-up tube to block seal being compressed. It the seal is compressed replace the seal and retest.
PIC6229C2018-10-15. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about vehicles that have a crank but engine does not start concern.Technician will use this publication to reset the battery low state of charge concern after extended crank where the vehicle will no longer crank anymore and the cause of the no start concern is repaired.If Diagnostic Trouble Code P0AFA is the only Diagnostic Trouble Code set this could be caused by an internal fault in the high voltage battery and SI diagnosis will have to be followed for further diagnosis.
PIP5095F2018-09-17. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon and may also have an oil or coolant leak. Technician may find coolant or oil in a spark plug tube. If the Spark Plug Tube is leaking and it is determined that the oil or coolant is not coming from a leak above the spark plug then replace the cylinder Head, spark plug and coil.
PIP3423P2018-09-17. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV). This Preliminary Information communication provides information to the technician that Diagnostic Trouble Codes P0016, P0017, P0018, P0019, P0008 or P0009 may be set. Technician will need to inspect for loose timing chains or tensioners. If after following Service Information diagnostics the root cause is not found inspect the reluctor for the crankshaft sensor. If the reluctor has moved then replace crankshaft.
PIP5163D2018-09-17. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
PIP5257B2018-08-20. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have oil mixed in with the engine coolant. Technician will need to inspect the oil cooler if equipped for possible leaking into the cooling system through the radiator. If no issue found replace the engine as well as all rubber coolant hoses.
PIP4495F2018-08-06. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; ENGINE; ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have a loud tick or rattle noise under the hood at all operating conditions. Technician will need to check the lower and oil pressure to the upper end oil pressure. Technician will need to inspect the oil feed orifice in the cylinder head. Technician will clean out and debris found in the orifice.
PIP5373B2018-08-06. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This Preliminary Information communication provides the technician with steps on how to program an Engine Control Module when getting a Service Programming System error code E4491 or E4423. In some cases Techline Customer Support Center may need to be contacted to resolve the issue.
PIP55692018-06-18. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. This Preliminary information communicates to the dealer an issue where the vehicle's engine may crank over unprompted and not start afterward. This is the result of hooking up the Active Fuel Injector Tool incorrectly on vehicles equipped with a direct fuel injection system. This Preliminary information instructs the dealer ofa repair kit they received that will prevent this issue when installed correctly.
00-06-01-026J2018-06-11. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin provides information on Intake Manifold Inspection/Replacement After Severe Internal Engine Damage.
PI0653E2018-06-04. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER. This preliminary informational bulletin provides information on Damaged, Disassembled or Improperly Packaged Turbochargers Returned to Warranty Part Center.
060601010D2018-06-04. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CATALYTIC CONVERTOR. This informational bulletin explains how the catalytic converters may need an inspection, cleaning or replacement if debris have entered the exhaust system.
070604019F2018-06-04. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This technical bulletin provides repair information for repairing the IP to body harness connector to correct a customer concern for intermittent Malfunction Indicator Lamp (MIL) illuminated with Reduced Engine Power displayed and DTC P2138 set.
040730013D2018-06-04. Service bulletin. POWER TRAIN; ENGINE; EQUIPMENT. This informational bulletin provides information to dealership personnel on automatic transmission shift and engine drivability concerns and/or MIL ON due to aftermarket oil bath air filter use.
010601011J2018-06-04. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
PIC6229A2018-05-21. Service bulletin. ENGINE; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have a crank but engine does not start concern. Technician will use this publication to reset the battery low state of charge concern after extended crank where the vehicle will no longer crank anymore and the cause of the no start concern is repaired. If Diagnostic Trouble Code P0AFA is the only Diagnostic Trouble Code set this could be caused by an internal fault in the high voltage battery and SI diagnosis will have to be followed for further diagnosis.
09-00-89-002L2018-05-21. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; ENGINE. This informational bulletin provides information to dealership personnel on properly maintaining vehicles in dealer inventory.
09-06-04-026K2018-05-21. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE. This informational bulletin supplies infomation for identifying non-GM (Aftermarket) engine calibrations for gasoline engines using Tech 2® or GDS 2 (U.S. and Canada).
PIE0385B2018-05-21. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM. This engineering information bulletin ends the need for information from the field on vehicles that have the concern of a noisy water pump.
17-NA-0842018-05-21. Service bulletin. ENGINE AND ENGINE COOLING. This technical bulletin provides a procedure to Complete the Circuit/System Verification steps to correct a condition of Malfunction Indicator Lamp (MIL) - Check Engine Light On, DTC P182E.
PIE0385A2018-05-21. Service bulletin. ENGINE AND ENGINE COOLING. This engineering information bulletin is requesting information from the field on vehicles that have the concern of a noisy water pump.
PIP4959F2018-05-21. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician with information regarding high misfire rates always on #1 cylinder. A customer may complain of misfires or roughness on cold start up with a P0300 diagnostic trouble code. Technician is to add coolant dye to the system and run the engine through warm up to circulate the dye. Pressurize the cooling system after a cold soak and inspect the cylinder with a bore scope for coolant dye. Dye is used to identify coolant over residual fuel being that might be left in the cylinder. The technician is not to replace the cylinder head as it will not correct this concern. In some cases it is necessary to remove the head for inspection. Do not replace the engine for small surface pock marks or a pitting appearance this is normal and do not connect to coolant passages. Usually if porosity is present there will be a break in the carbon ring. Only replace the engine if true porosity is found. Technician is to call Product Quality Center with the latest version of bulletin 02-07-30-029 if porosity is found and engine replacement is required.
PIP3423N2018-05-21. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician that Diagnostic Trouble Codes P0016, P0017, P0018, P0019, P0008 or P0009 may be set. Technician will need to inspect for loose timing chains or tensioners. If after following Service Information diagnostics the root cause is not found inspect the reluctor for the crankshaft sensor. If the reluctor has moved then replace crankshaft.
PIP5163C2018-05-21. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.