WenmarOpen by Wenmar Pro

Service bulletins for the 2019 BMW 330i

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

390 on file from NHTSA, as of 2026-10-19.

By type

By component

Only bulletins with component: Electrical system are shown. Show all

Bulletins, newest first
B6104192020-08-31. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. VEHICLE DOES NOT START BATTERY TOTALLY DISCHARGED: The customer's vehicle does not start due to a totally discharged battery.
B3406202020-08-31. Service bulletin. ELECTRICAL SYSTEM; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). NOISE FROM DYNAMIC STABILITY CTRL(DSC)UNIT WHEN DRIVING RAPIDLY OVER SPEED BUMP: When driving rapidly over a speed bump, the following issues may arise: 1. DSC pump noise 2. Power output delayed for 1-2 seconds DSC software application.
B6115202020-07-27. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. DELIVERY STOP: TRUNK LOCK SWITCH WIRING HARNESS: BMW AG has issued a Delivery Stop (effective June 5, 2020) on a small number of Model Year 2020 BMW 3 Series vehicles that were produced on March 25, 2020 and March 26,2020. The wiring harness from the Body Domain Controller (BDC) to the hotel setting switch is missing.
B6104192020-07-27. Service bulletin. ELECTRICAL SYSTEM. VEHICLE DOES NOT START BATTERY TOTALLY DISCHARGED: The customer's vehicle does not start due to a totally discharged battery.
B6611202020-06-15. Service bulletin. ELECTRICAL SYSTEM. REVERSING ASSISTANT LIMITATIONS: The Reversing Assistant function is not operating to customer expectations. Some possible customer concerns are: Vehicle does not avoid objects in its path tires or wheels contact the curb reversing Assistant only works for a short distance.
B6609202020-06-15. Service bulletin. ELECTRICAL SYSTEM. SURROUND VIEW WRONG VEHICLE DISPLAYED AFTER PROGRAMMING: After programming the wrong vehicle model is displayed in the Central Information Display (CID) when the Surround View is activated.
B6105202020-06-15. Service bulletin. ELECTRICAL SYSTEM. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B5113182020-06-15. Service bulletin. VISIBILITY; ELECTRICAL SYSTEM; POWER TRAIN. LIN BUS FAULTS WITH EXTERIOR REARVIEW MIRROR GLASS DAMAGE: Any or all of these conditions may be present: A. The exterior rearview mirror glass is discolored or cracked B. The power windows and folding mirrors may not operate C. One or more of the following LIN bus faults are stored in the BDC (Body Domain Controller): D90C03 LIN bus master B: short circuit - BDC D90C04 LIN bus master B: No communication - BDC D90C05 LIN bus master B: Communication failed - BDC D90D07 Operating facility switch block (LIN): Missing LIN slave D90D0A exterior rearview mirror left (LIN bus): Absent LIN slave - BDC D90D0D exterior rearview mirror right (LIN bus): Absent LIN slave - BDC 804246 exterior rearview mirror left (LIN bus): Heating or electrochrome: faulty - BDC 804256 exterior rearview mirror right (LIN bus): Heating or electrochrome: faulty - BDC 804265 exterior mirror left or right: Excess temperature - BDC 804260 exterior mirror left or right: Overvoltage - BDC 804261 exterior mirror left or right: Undervoltage - BDC Faulty exterior rearview mirror electronics have created a short on the LIN bus damaging the mirror glass and causing functional errors in power window and exterior mirror operation.
B1208202020-06-15. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING. DELIVERY STOP - STARTER MOTOR: BMW AG has issued a Delivery Stop on a small number of Model Year 2020 BMW 3 Series that were produced between March 6 2020 and March 11 2020. A starter motor nut will need to be inspected and if necessary tightened to specifications.
B8402202020-05-18. Service bulletin. ELECTRICAL SYSTEM. REMOTE 3D VIEW NOT AVAILABLE: Remote 3D View cannot be launched In the BMW ConnectedDrive App. Software error in the Advanced Telematics Module 2 (ATM2).
B8401202020-05-18. Service bulletin. ELECTRICAL SYSTEM. BMW CONNECTEDDRIVE SERVICES ARE NOT AVAILABLE: The BMW ConnectedDrive services are not available for an extended period. This may include: Calls in the BMW Assistance app (Concierge Service) Vehicle data and status in the BMW ConnectedDrive app Remote services Remote 3D View Real Time Traffic Information (RTTI) Weather News Software error in Advanced Telematics Module 2 (ATM2).
B6608202020-05-18. Service bulletin. ELECTRICAL SYSTEM. SERVICE ACTION - REPLACE RIGHT REAR SHORT RANGE RADAR SENSOR (SRR): The functionality of the right rear SRR sensor could be reduced which would display the Driving Assistance Check Control Message.
B6607202020-05-18. Service bulletin. ELECTRICAL SYSTEM. SERVICE ACTION - REPLACE LEFT REAR SHORT RANGE RADAR SENSOR (SRR): The functionality of the left rear SRR sensor could be reduced which would display the Driving Assistance Check Control Message.
B6114202020-05-18. Service bulletin. ELECTRICAL SYSTEM. DEACTIVATION OF THE INTERIOR MOVEMENT DETECTOR/TILT ALARM SENSOR IS NOT POSSIBLE: Customer complains that the interior movement detector and the tilt alarm sensor system cannot be deactivated by pressing the lock button on the remote control / BMW display key twice. The second button press on the radio remote control / BMW display key is not detected. Customer may have to press the button 3 times to deactivate the interior movement detector and tilt alarm sensor. CAUSE Software error in the control unit of the roof function center (FZD).
B6113202020-05-18. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM. SERVICE ACTION - CHECKING THE DUAL STORAGE SYSTEM AND REPLACE IF NECESSARY: In the event of an accident the two-battery Dual Storage System (DSS) is disconnected from the electrical system via an internal relay. In some cases the relay is stuck closed and a fault is set. In these circumstances: A crash shutdown of the DSS does not occur The power distribution box is supplied with power until the DSS is fully discharged
B8402142020-04-27. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY. CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.
B6631192020-04-27. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM; POWER TRAIN:MANUAL TRANSMISSION:SHIFT PATTERN INDICATOR. REARVIEW CAMERA: SPORADICALLY NO IMAGE IS DISPLAYED: This Service Information Bulletin (Revision 2) replaces SI B66 31 19 dated February 2020. When reverse gear is selected or the rear view camera is activated sporadically no image is displayed on the Central Information Display (CID). If the ignition is cycled off and back on the function is restored. Software error between the head unit and the rear-view camera.
B6603202020-04-27. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM. DIAGNOSTIC HINT: DRIVING ASSISTANCE SUPPORT REDUCED CHECK CONTROL MESSAGE DISP: Driving Assistance support reduced Check Control Message (CCM) is displayed sporadically. All or some of the system functions maybe inoperative.
B6508202020-04-20. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM; EQUIPMENT. DISPLAYS SPORADICALLY REACT VERY SLOWLY WHEN SCROLLING IN THE AUDIO MENU: Sporadically the reaction time of the display in the instrument cluster the head-up display or in the CID (Central Information Display) is very long. This can occur when browsing/scrolling through lists in the audio menu switching radio stations or albums. Software in the Head Unit High (HU-H3).
B6631192020-03-16. Service bulletin. BACK OVER PREVENTION; ELECTRICAL SYSTEM. REARVIEW CAMERA. SPORADICALLY NO IMAGE IS DISPLAYED: This Service Information Bulletin (Revision 1) replaces SI B66 31 19 dated October 2019. When reverse gear is selected or the rear view camera is activated sporadically no image is displayed on the Central Information Display (CID). If the ignition is cycled off and back on the function is restored. Software error between the head unit and the rear-view camera.
B6105202020-03-16. Service bulletin. ELECTRICAL SYSTEM. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER. A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B6104202020-03-16. Service bulletin. STEERING; ELECTRICAL SYSTEM. COMFORT ACCESS & COMFORT GO DO NOT WORK SPORADICALLY IN WARM TO HOT TEMPERATURE: At warm to hot outside temperatures (above 60C° F) the customer may complain that the Comfort Access and Comfort Go sporadically don't work. Vehicle can be opened by pressing the remote control unlock buttons and- Engine start is possible by placing the remote control key on the steering column ring antenna. The situation corrects itself after the vehicle goes to sleep or cools down. At warm to hot outside temperatures there may be a temporary interruption in communication between the comfort access functions in the BDC. This leads to sporadic operating failure of the comfort access function.
B6101202020-03-16. Service bulletin. ELECTRICAL SYSTEM. ACCESSORIES DO NOT POWER ON: Customer is not able to power accessories using the 12 volt power socket. Design change to reduce short circuits and blown fuses.
B8404162020-02-18. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. SOS MALFUNCTION DISPLAYED This Service Information Bulletin (Revision 1) replaces SI B84 04 16 dated September 2016. One or all the following may be experienced in the vehicle: An SOS malfunction is seen in the Kombi (aka instrument cluster) When pressing the E-Call/SOS button in the overhead console nothing happens Fault code B7F33C (internal ECU error) is stored in the Telematics control unit (ATM/TCB2) There are 2 known causes for this failure. They are as follows: Software file missing from the ATM/TCB2 control module Water leak at the "shark fin" roof antenna (aka roof aerial) leading to corrosion in the ATM/TCB2 control module.
B8402202020-02-18. Service bulletin. ELECTRICAL SYSTEM. REMOTE 3D VIEW NOT AVAILABLE: Remote 3D View cannot be launched In the BMW ConnectedDrive App. Software error in the Advanced Telematics Module 2 (ATM2).

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.