WenmarOpen by Wenmar Pro

Service bulletins for the 2018 BMW 320i

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

94 on file from NHTSA, as of 2026-10-19.

By type

By component

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
B1207212023-12-06. Service bulletin. ENGINE AND ENGINE COOLING. Check Control message (CCM) indicates: (ID 213): Stop, exercising due care. Voltage supply The Service Engine Soon light is on with the following DME Fault Code: 21B209 - Starter alternator / belt for 48V system (OSA_RIEMEN_RISS): Belt betweenCombustion engine and starter generator torn And/or one or more of the following other issues are also occurring: Noise in the area of the belt drive. Odor from the engine compartment. Smoke formation in the area of the belt drive. Drive belt damaged or prematurely worn. Torn drive belt.
B0114232023-12-06. Service bulletin. ENGINE AND ENGINE COOLING. PRESSURE CONTROL VALVE (PCV) EXTENDED LTD WTY 15 YEARS/150,000 MILES
B0109192023-12-06. Service bulletin. ENGINE AND ENGINE COOLING. DIESEL FUEL INJECTORS: LTD WTY EXTENSION TO 10 YEARS/120,000 MILES
SIB0119182022-07-18. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE:CRANK/CAMSHAFT POSITION SENSOR. Component specific limited warranty extension. For the eligible vehicles, BMW of North America, LLC (BMW NA) is extending the limited warranty for the vehicle Nitrogen Oxide (NOx) Sensor(s) to: 10 years/120,000 miles as determined by the vehicle original in-service date.
B1701212022-06-21. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. The quick disconnect coupling on the cylinder head coolant vent line could break at the cylinder head. This would lead to loss of coolant from the engine.
B1701212022-05-31. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. The quick disconnect coupling on the cylinder head coolant vent line could break at the cylinder head. This would lead to loss of coolant from the engine.
SIB1103172021-12-13. Service bulletin. ENGINE AND ENGINE COOLING. BMW of North America, LLC BMW NA is extending the limited warranty for the engine timing chain and oil pump drive chain modules to: 7 years/70,000 miles as determined by the vehicle's original in-service date
B1103172021-12-13. Service bulletin. ENGINE AND ENGINE COOLING. For the above-referenced vehicles, BMW of North America, LLC (BMW NA) is extending the limited warranty for the engine timing chain and oil pump drive chain modules to: 7 years/70,000 miles as determined by the vehicle's original in-service date.
B1103172021-11-08. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. BMW of North America, LLC (BMW NA) is extending the limited warranty for the engine timing chain and oil pump drive chain modules to: 7 years/70,000 miles as determined by the vehicle's original in-service date
B1101202021-08-09. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION:FILTER/SCREEN. On rare occasions during an engine oil service, the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing.
B1103212021-07-19. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; ENGINE. B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.
B1213182021-03-15. Service bulletin. ENGINE AND ENGINE COOLING. COMBUSTION CONTROL VALVE LIFT AT IDLE: The vehicle will run rough or hesitate when accelerating from a stationary position.
B1103172021-02-01. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. N20 AND N26 ENGINE TIMING CHAIN AND OIL PUMP DRIVE CHAIN: Whining noise from the lower engine area near the engine oil pump that increases frequency when increasing the engine RPM. Wear on the engine oil pump chain drive and timing chain sprockets.
B1304202020-06-15. Service bulletin. ENGINE AND ENGINE COOLING. TANK VENTILATION AND MIXTURE CONTROL FAULTS STORED IN THE DME: The Engine Malfunction Warning is illuminated and one or more of the following faults are stored in the DME. All models: FC 191C02 - Fuel tank ventilation system 2nd discharge point: malfunction FC 195014 - Differential pressure sensor tank vent valve signal: fixed FC 118001 - Mixture control: mixture too lean FC 118401 - Mixture control: mixture too lean large deviation I01 only: FC 124103 - Mixture control: mixture too lean FC 124101 - Mixture control: Mixture lean large deviation CAUSE Internal mechanical defect in the tank ventilation valve. The defect can also result in a very loud clicking noise when the valve is cycling.
B1101202020-06-15. Service bulletin. ENGINE. B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing.
B0126182020-06-15. Service bulletin. WHEELS; PARKING BRAKE; POWER TRAIN; ENGINE AND ENGINE COOLING; STEERING. EPS STEERING ELECTRIC MOTOR MOUNTING BOLTS - LTD WTY EXT TO 10 YRS/120000 MILES: There are front end noises when turning the steering wheel and/or there is limited power steering assist when maneuvering or parking the vehicle. For the basic steering gears one possible cause is that the mounting bolts for the electric motor may become loose missing and/or broken due to corrosion.
B1213182020-04-20. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. DME FC 21A02D - COMBUSTION CONTROL: VALVE LIFT AT IDLE This Service Information Bulletin (Revision 3) replaces SI B12 13 18 dated September 2019. The vehicle will run rough or hesitate when accelerating from a stationary position.
B1233142020-03-16. Service bulletin. ENGINE AND ENGINE COOLING. Fault Code 1D2008 Stored in DME: This Service Information Bulletin (Revision 5) replaces SI B12 33 14 dated February 2016. The Service Engine Soon light is on. There may also be a complaint of low heat output with lower outside temperatures. CAUSE During the engine warm-up the engine coolant does not reach operating temperature within the DME's allowable time limits. This is caused by either a faulty thermostat inside the transmission oil heat exchanger or a faulty engine characteristic map thermostat.
B1101202020-03-16. Service bulletin. ENGINE AND ENGINE COOLING. ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1).
B1204182018-10-09. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING. BUZZING NOISE FROM VALVETRONIC MOTOR BEFORE OR AFTER ENGINE OPERATION: Buzzing noise may be heard from the Valvetronic motor when the vehicle is unlocked, before the engine is started, or after the engine is turned off.
B7102182018-08-06. Service bulletin. EQUIPMENT:OTHER:LABELS; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. VOLUNTARY EMISSIONS RECALL CAMPAIGN 18E-A02: REPLACE UNDER HOOD EMISSIONS LABEL

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.