WenmarOpen by Wenmar Pro

Service bulletins for the 2022 Bentley Bentayga

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

636 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Body and frame are shown. Show all

Bulletins, newest first
2069554.12023-04-07. Service bulletin. EQUIPMENT; STRUCTURE. Unable To Open The Glovebox When Using the Key or The Key Does Not Enter The Lock Fully Customer Statement: -Unable To Open The Glovebox When Using The Key or The Key Does Not Enter The Lock Fully
2069014.12023-03-06. Service bulletin. STRUCTURE. Wind Noise From the Lower A Pillar (Rain Deflector Area) Technical Background: -Profile deviation between the front wing and front wing mounting bracket can contribute to wind noise from the lower A pillar (rain deflector area)
2068064.22023-02-03. Service bulletin. STRUCTURE:BODY:DOOR; STRUCTURE. Front Door Clash Condition with the Rear Door Brightware or Clash Between the Front and Rear Door Brightware Customer Statement: -The front door inner panel hem is clashing with the rear door lower brightware during the closing operation of the front door. -The rear door lower brightware is clashing with the front door brightware.
2068829.12023-02-03. Service bulletin. STRUCTURE:BODY:TRUNK LID; STRUCTURE. Rear lid or boot - Water Ingress Diagnosis Customer Statement: -Water ingress within the rear lid -Water dripping from the rear lid -Water ingress is evident within the boot -Water in some isolated cases may be heard moving/sloshing from inside of the rear lid
2065760.22023-02-03. Service bulletin. STRUCTURE. Rear Jacking Point - Sill damage found during PDI Customer Statement: -Damage found around the rear sill jacking point during PDI -Raise a DISS query
2062622.22023-02-03. Service bulletin. STRUCTURE. Water Leak/Wind Noise Diagnosis Customer Statement: -Water leak/wind noise evident -The instructions within this TPI should be followed to assist in the diagnosis of water leaks or wind noise.
2068321.32023-01-06. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES. Driver/Passenger door creak on close - Bentayga - 22 Model Year Onwards Customer Statement: -Driver and/or passenger door creak during the (Power Close) function
2054210.42023-01-06. Service bulletin. VISIBILITY; STRUCTURE; VISIBILITY:SUN/MOON ROOF ASSEMBLY. Noises from Panoramic Sun Roof Customer Statement: -Noises from the panoramic sun roof when driving. The noises occur mainly when the sun roof is closed
2055540.32022-12-08. Service bulletin. STEERING; STRUCTURE. Rumble noise and/or floor pan/steering column vibration Customer Statement: -Floor pan or steering column/steering wheel vibration when maneuvering/steering at slow speeds with steering wheel input
2065197.22022-12-08. Service bulletin. STRUCTURE; SUSPENSION. Squeaking/creaking noises from the front axle and/or leaks at the lower ball joint/s Customer Statement: -A leak is visible at the boot of the lower ball joint (grease emerging) however the boot does not show any damage
2068064.12022-11-08. Service bulletin. STRUCTURE; UNKNOWN OR OTHER. Front Door Clash Condition with the Rear Door Brightware (left and/or right hand side) Customer Statement: -The front door inner panel hem is clashing with the rear door lower brightware during the closing operation of the front door.
2067489/12022-10-07. Service bulletin. STRUCTURE; VISIBILITY. Window side glass - Identification - Standard (STD) or Privacy (PRV) Customer Statement: - Incorrect side glass fitted - Standard (STD) not Privacy (PRV) or visa versa and/or Defects are evident within the glass Technical Background: -The instructions within the Measure section MUST only be followed if the glass is to be replaced
2067740/12022-08-31. Service bulletin. STRUCTURE. Tailgate interior trim - Specification guidelines Customer Statement: -Suspected tailgate lower trim surface damage issues Technical Background: -The complaint could be received for the right and/or left hand side -Refer to the Measure section for further clarification
2064482/22022-08-05. Service bulletin. STRUCTURE. Audible creak from the lower/central A Post when opening and/or closing the front door/s. Customer statement / workshop findings Audible creak coming from the lower/central A post in the vicinity of the check strap fixing point (Figure 1) during the opening and/or closing of the driver/passenger door. Technical background To confirm the issue is as described within the Customer statement refer to the video on the Bentley Hub referencing TPI 2064482/- In the event that the noise is as shown within the video the instructions within the Measure section should be followed.
2067488/12022-08-05. Service bulletin. STRUCTURE. Veneer/trim mismatch - DISS query requirements. Customer statement / workshop findings: In the event that a trim mismatch is detected for example: - Piano black veneer is supplied although the customer ordered walnut veneer Or - The interior trim colour is incorrect for example: Cricket ball interior trim is supplied although the customer ordered Hotspur The operative should refer to the Technical background section
2067274/12022-07-06. Service bulletin. STRUCTURE. Front/rear towing eye cover - missing at PDI. Customer statement / workshop findings: Front and/or rear towing eye cover missing at PDI Technical background: Towing eye cover/s found to be missing whilst carrying out the Pre Delivery Inspection
2066738/12022-06-03. Service bulletin. STRUCTURE. Underfloor paint drain hole check (SC22/14). Technical background: Due to a process change within manufacturing, the paint drain hole (Figure 1) which is located on the left hand side of the floor pan may not have been sealed/covered IMPORTANT: No other cavities or drain holes are affected. Remedy: Refer to the instructions within the Work section
2066738/22022-06-03. Service bulletin. STRUCTURE. Underfloor paint drain hole check (SC22/14). Technical background: Due to a process change within manufacturing, the paint drain hole (Figure 1) which is located on the left hand side of the floor pan may not have been sealed/covered IMPORTANT: No other cavities or drain holes are affected. Remedy: Refer to the instructions within the Work section.
2066502/12022-04-07. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM. Charging starts and stops when using a public charging unit. Customer statement / workshop findings: When using a public charging unit to charge the high voltage battery, charging starts and is then interrupted/stops Workshop findings The following DTC is also evident: P33E800: Charge socket A, charge connector lock mechanical malfunction passive/sporadic. Measure: 1) Referring to Rep.Gr 93 - Carry out an Inspection and classification of the Hybrid battery unit AX1 VERY IMPORTANT: In the event that the classification result of the battery is Normal the operative should conduct the remaining steps of this TPI from step 2 However If the classification result of the battery is either Danger or Warning then move the car to the quarantine area and raise a DISS immediately, the operative MUST NOT continue with any other work unless instructed via the open DISS query 2) Check the operation of the charging system using the customers and the retailers own charging equipment 3) Run a full diagnostic log and check if the DTC within the Technical background section are evident.
2065760/12022-02-05. Service bulletin. STRUCTURE; EQUIPMENT. Rear Jacking point - Sill damage found during PDI. Customer statement / workshop findings: Damage found around the rear sill Jacking point during PDI (Figure 1). Measure: In the event the issue is as described, please raise a technical DISS query ensuring clear photographs are attached The operative MUST await feedback from Product Support before conducting any further work Note to Product Support: The DISS query should be second levelled to the applicable Senior Engineer for review before responding to the retailer Technical product information Rear Jacking point - Sill damage found during PDI Transaction No.: 2065760/1
2057988/62022-01-08. Service bulletin. EQUIPMENT; STRUCTURE. Bentayga Hybrid - Accessory Embargo. Customer statement / workshop findings Customer request to install fixed sill steps, deploying sill steps or Illuminated tread plates to Bentayga Hybrid vehicle. Technical background Due to the routing and proximity of high voltage cables it is strictly prohibited to install the following accessories on Bentayga Hybrid vehicles. - Fixed sill steps. - Deploying sill steps. - Illuminated tread plates NOTE: Tow bars cannot be fitted to Bentayga Hybrid vehicles due to certification IMPORTANT: Bentayga Styling Specification MUST NOT be fitted to Bentayga Hybrid vehicles from 19 to 20 Model year due to certification reasons However From 21 Model year onwards the Bentayga Styling specification can be fitted Note: Failure to observe these instructions may invalidate certain aspects of the vehicle warranty. In all instances, when placing an order for spare parts or accessories please refer to the electronic parts catalogue (ETKA)
2051045/42022-01-06. Service bulletin. EQUIPMENT; STRUCTURE. Night vision camera - Washer jet leaking. Customer statement / workshop findings: Washer fluid dripping/leaking from the night vision camera washer jet. Technical background: Please note: The photographs shown within this TPI are based on a New Continental GT/C vehicle however the process is similar regardless of vehicle type Referring to Figure 1 - In the event the afore mentioned symptom is evident the operative should refer to the Measure section of this TPI to replace the night vision washer jet (short link hose -Circled) which connects the night vision camera washer jet (A) to the washer jet supply hose connector (B)
2064824/32021-12-07. Service bulletin. STRUCTURE; ENGINE AND ENGINE COOLING; EQUIPMENT. Bentayga Hybrid - Left hand rear jacking block replacement and coolant pipe check (SC 21/38). Technical background Due to possible a clash condition between the high voltage system coolant pipe and the left hand rear jack block - Figure 1 (point A) the original left hand rear jack block must be replaced. Remedy - The left hand jack block requires replacement - A visual inspection of the high voltage system coolant pipe (situated adjacent to the left hand jack block) is required NOTE: Depending on the outcome of the inspection, the coolant pipe may require replacement (Refer the Work section)
2064824/12021-12-07. Service bulletin. EQUIPMENT; STRUCTURE; ENGINE AND ENGINE COOLING. Bentayga Hybrid - Left hand rear jacking block replacement and coolant pipe check (SC 21/38). Technical background: Due to possible a clash condition between the high voltage system coolant pipe and the left hand rear jack block - Figure 1 (point A) the original left hand rear jack block must be replaced. Remedy: - The left hand jack block requires replacement - A visual inspection of the high voltage system coolant pipe (situated adjacent to the left hand jack block) is required NOTE: Depending on the outcome of the inspection, the coolant pipe may require replacement (Refer the Work section)
2064779/12021-11-05. Service bulletin. SUSPENSION; STRUCTURE. Customer statement: Creaking/squeak noise from the front suspension. Workshop findings: Defective upper inner lever bush. Technical background Verify that the customer complaint matches the sound file within the Bentley Hub Reference TPI Transaction number 2064779/-. The noise present in the sound file is caused by defective upper inner lever bush/bushes, the noise can appear in the following possible scenario. -When the vehicle is moved with steering input over uneven surfaces (for e.g. a ramp or speed bump). If the customer complaint occurs in any of the above circumstances and the noise can be clearly assigned to the noise within the sound file Refer to the instructions within the Measure section of this TPI. VERY IMPORTANT NOTE FOR HYBRID VEHICLES: -Hybrid vehicles use a High voltage system and MUST only be worked on by suitably qualified personnel. -Please ensure all guidelines within the repair manual are strictly followed before and whilst conducting any work on vehicles with a High voltage system

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.