Service bulletins for the 2019 Bentley Bentayga
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
629 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
| 2052853/6 | 2020-08-06. Service bulletin. STEERING; SERVICE BRAKES; SUSPENSION:FRONT:CONTROL ARM:LOWER ARM. Clicking noises from front corner(s). Customer statement/workshop findings Clicking noise from front corner(s) Technical background In order to accurately diagnose and repair customer reported clicking noises from the front corner(s) the Measure section of this TPI consists of three individual sections, each section describes the symptom and the remedy which should be applied Symptoms and descriptions regarding clicking noises can appear to be very similar when described, where possible the customer should demonstrate the reported symptom to enable correct diagnosis |
|---|---|
| 2058477/3 | 2020-08-06. Service bulletin. ENGINE. Bentayga - Button Module For Driving Profile Selection. Customer statement / workshop findings: Button Module For Driving Profile Selection requires replacement. Technical background: There is an ongoing factory investigation into failures of the Button Module For Driving Profile Selection. Any Button Module For Driving Profile Selection that is removed due to a fault is to be returned fully assembled using the Warranty parts return process. |
| 2054084/2 | 2020-08-06. Service bulletin. STRUCTURE. Bullseye air outlets - chrome finisher detached. Customer statement / workshop findings: Air vent chrome finisher has detached from vane. Technical background: It is possible that using aftermarket clip on devices such as mobile phone holders, air freshener holders or chewing gum dispensers may result in the chrome air vent finisher becoming detached from the vane. Measure: Please advise the Customer that the use of aftermarket clip on devices is not recommended and continued use may result in repeat failures. Damage caused by the use of aftermarket clip on devices will not be covered under vehicle warranty. |
| 2046299/6 | 2020-08-06. Service bulletin. SERVICE BRAKES, HYDRAULIC. Bentayga - 1.2 - 1.4KHz rear brake squeal. Customer statement / workshop findings: Squeal from the rear of the vehicle at low speed while braking. Technical background: While braking at low speed, a vibration of 1.2 to 1.4 KHz can be produced by the friction between the rear brake pad and disc resulting in a complaint of brake noise from the customer |
| 2053177/12 | 2020-08-06. Service bulletin. ELECTRICAL SYSTEM. All Vehicle Variants - Spurious DTC List Condition: Customer will not be aware of any fault codes. Workshop may discover spurious fault codes whilst running a Diagnostic Trouble Code (DTC) log as part of other investigations on the vehicle. Technical Background: The attached document contains all of the current known Spurious DTCs for all vehicle variants. Should a particular TPI be listed as Archived within the attached document the TPI can no longer be viewed within Elsa pro, in this case please refer to the instructions with the attached document regarding the DTC description and actions (if any) which should be conducted |
| 2053177/11 | 2020-08-06. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. Customer statement / workshop findings Customer will not be aware of any fault codes. Workshop may discover spurious fault codes whilst running a Diagnostic Trouble Code (DTC) log as part of other investigations on the vehicle. All Vehicle Variants - Spurious DTC List Technical background The attached document contains all of the current known Spurious DTCs for all vehicle variants. Should a particular TPI be listed as Archived within the attached document the TPI can no longer be viewed within Elsa pro, in this case please refer to the instructions with the attached document regarding the DTC description and actions (if any) which should be conducted |
| 2028808/4 | 2020-08-05. Service bulletin. ENGINE AND ENGINE COOLING. Engine oil. Specific oil type and oil consumption reference. Customer statement / workshop findings: Engine oil level requires to:p up between services. Technical background The use of the correct oil for each engine type is critical for its continued performance, reliability and ultimately warranty. The workshop manual should always be the first point of reference, ensuring the correct lubricant is used for each specific model year and engine type Should oil be required the parts catalogue must be referred to ensuring the correct VIN is always used when ordering |
| 2057841/2 | 2020-08-05. Service bulletin. STRUCTURE. Windscreen replacement criteria whilst under manufacturers warranty. Customer statement / workshop findings: Windscreen cracked/damaged Technical background: Please refer to the instructions within the Measure section of this TPI in the event that a windscreen is cracked/damaged |
| 2055036/3 | 2020-08-05. Service bulletin. ELECTRICAL SYSTEM. My Bentley - Connected services. Customer statement / workshop findings: Complaints relating to My Bentley connected services. Technical background: Most queries and complaints regarding My Bentley connected services can be resolved by contacting My Bentley Support rather than raising a DISS technical query. |
| 2056582/3 | 2020-08-05. Service bulletin. STRUCTURE. Interior trim - Creak and rattle - Noise identification. Customer statement / workshop findings: Noise complaint from the interior Workshop findings: The noise can be reproduced and clearly assigned to the interior Prior to starting the instructions within this TPI, the Retailer must check and confirm the vehicle is in standard factory condition and has not had any non-approved aftermarket modifications conducted Should any aftermarket modifications be found, the Retailer must make Product Support aware by raising a DISS query to report the details of the modification, you must then await feedback from Product Support before conducting any further work |
| 2053492/6 | 2020-08-05. Service bulletin. SUSPENSION:REAR:SPRINGS. Air spring fault finding. Customer statement / workshop findings: The front and/or rear suspension appears to have dropped. Technical background: The list of Bentley vehicles below are fitted with air springs as part of the suspension system. Should air leak from the air springs, this will cause the suspension to drop. However, the dropping of the suspension does not necessarily mean that the air spring is faulty. TheMeasure section of this TPI describes how and where to check for air leaks on the front and rear air springs, the air pump compressor, pipes, valve unit and air reservoirs. This includes potential air leak points on the air springs and also the locations of an air leak that can be repaired without the need to replace an air spring. These checks should be carried out in conjunction with the Elsapro procedure Air suspension: To check with the use of the special tool Air suspension leak tester VAS 751 001 shown in the image below as item ( 1). Refer to Elsapro, Repair Group 43, Air suspension To check. |
| 2053177/10 | 2020-07-07. Service bulletin. ELECTRICAL SYSTEM. All Vehicle Variants - Spurious DTC List Condition: Customer will not be aware of any fault codes. Workshop may discover spurious fault codes whilst running a Diagnostic Trouble Code (DTC) log as part of other investigations on the vehicle. Technical Background: The attached document contains all of the current known Spurious DTCs for all vehicle variants. Should a particular TPI be listed as Archived within the attached document the TPI can no longer be viewed within Elsa pro, in this case please refer to the instructions with the attached document regarding the DTC description and actions (if any) which should be conducted Service: During routine diagnostic interrogation of vehicle systems use the attached document to determine the course of action to be taken. |
| 2048616/7 | 2020-07-07. Service bulletin. SUSPENSION; STEERING. Creaking noise from the front suspension when manoeuvring Customer statement / workshop findings: Creaking noise from the front suspension when manoeuvring Technical background: Verify that the customer complaint matches the sound file within the Bentley Hub Reference TPI Transaction number 2048616 TIP: When listening to the sound file the noise can be heard from between 0 and 3 seconds The noise present in the sound file is caused by defective Lower suspension lever - Rear - Hydraulic mounts. In order to reproduce the noise this bush must be twisted, therefore the noise can appear in the following circumstances: When performing parking manoeuvers with the brake applied When steering from lock to lock with the vehicle in motion and the brake applied When the vehicle is moved with steering input over uneven surfaces (for e.g. a ramp or speed bump) If the customer complaint occurs in any of the above circumstances and the noise can be clearly assigned to the noise within the sound file – Refer to the instructions within the Measure section of this TPI |
| 2059379/1 | 2020-06-04. Service bulletin. ENGINE AND ENGINE COOLING. High pitched whistle from the engine - Warning light within the DIP - Engine not running smoothly - Numerous DTCs. Customer statement/Workshop findings: Emission control warning light evident within the DIP (Figure 1) Engine not running/idling smoothly High pitched whistle from the right hand side of the engine TIP: Refer to video within the Bentley Hub referencing TPI 2059379/- A selection of DTCs are evident (as per TPI Event memory entries) Technical Background: Air intake leak due to a broken one-way diaphragm valve from within the Bank 1 breather line |
| 2052853/5 | 2020-06-03. Service bulletin. SUSPENSION; SERVICE BRAKES, HYDRAULIC; WHEELS. Clicking noises from front corner(s) Customer statement / workshop findings: Clicking noise from front corner(s) Technical background: In order to accurately diagnose and repair customer reported clicking noises from the front corner(s) the Measure section of this TPI consists of three individual sections, each section describes the symptom and the remedy which should be applied Symptoms and descriptions regarding clicking noises can appear to be very similar when described, where possible the customer should demonstrate the reported symptom to enable correct diagnosis. |
| 2046299/5 | 2020-06-03. Service bulletin. SERVICE BRAKES, HYDRAULIC. Bentayga - 1.2 - 1.4KHz rear brake squeal Condition: Squeal from the rear of the vehicle at low speed while braking. Technical Background: While braking at low speed, a vibration of 1.2 to 1.4 KHz can be produced by the friction between the rear brake pad and disc resulting in a complaint of brake noise from the customer |
| 2059392/1 | 2020-05-06. Service bulletin. ELECTRICAL SYSTEM. PDC system not working or PDC system false detection. Customer statement/workshop findings: PDC system not working or PDC system false detection Technical background Refer to the Measure section of this TPI |
| 2055517/2 | 2020-05-06. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. HVAC control module (SC19/14). Technical background: On all affected Bentayga vehicles, incorrect software in the HVAC control module can lead to functionality issues. Remedy: On all affected vehicles the software of the HVAC control module must be updated. |
| 2059195/1 | 2020-05-06. Service bulletin. STEERING. Squeaking/droning noise from the steering column. Customer statement / workshop findings: When turning the steering wheel a squeaking/droning noise from the location shown in Figure 1 is evident. Technical background: The noise is due to a lack of grease to the intermediate steering shaft bearing which is located within the rubber insulator panel |
| 2051519/6 | 2020-05-06. Service bulletin. ELECTRICAL SYSTEM; VISIBILITY. HVAC operation issues/HVAC Motor defect DTCs logged. Customer statement / workshop findings: HVAC operation issue and HVAC motor defect (DTCs) evident within address 08 Climatronic control unit, the DTC/s can be static or sporadic, for example: B108D09: Right temperature flap positioning motor - Component defect Technical background: The HVAC motor/s can become jammed causing HVAC operation issues. |
| 2057978/3 | 2020-05-06. Service bulletin. ENGINE AND ENGINE COOLING. Engine Lubricating Oil - Replenishment. Customer statement / workshop findings: Engine lubricating oil lamp illuminated on driver instrument panel. Engine lubricating oil requires topping up between services. Technical background: In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified running-in periods consume more oil during the running-in period, and the oil consumption will stabilize after the running-in period. Refer to the Owners Manual for specific running-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, ambient temperature and road conditions. Additional factors are the amount of oil dilution from water condensation or fuel residue, and the oxidation level of the oil. Certain driving conditions may negatively influence the rate of oil consumption. This can occur while the vehicle is operated in city driving conditions, for example: stop and go traffic with extended idle periods. |
| 2057470/1 | 2020-05-06. Service bulletin. ELECTRICAL SYSTEM. Bentayga Hybrid - Bentley Home Charging Unit - Not Functioning. Condition High voltage system - Bentley Home Charging Unit (Low version) does not function, the following indicator lights are illuminated in red. Bentley Home Charging Unit is connected to an un-earthed power supply. Technical Background Certain mains power supplies use an un-earthed infrastructure, in these specific circumstances it is necessary to deactivate Protective Earth (PE) conductor monitoring on the Bentley Home Charging Unit. |
| 2058764/1 | 2020-04-04. Service bulletin. ELECTRICAL SYSTEM; FUEL SYSTEM, GASOLINE. Bentayga - Control Unit for Fuel Pump (SC 20/05) Technical background Fuel pump control unit 4M0 906 093K has been superseded by fuel pump control unit 4M0 906 093N, however, this change is not currently applicable to Bentley. A small quantity of N level control units were mistakenly issued as spare parts and have subsequently been fitted to Customer vehicles. On vehicles with the N level part installed the Customer may complain of noise from the rear seat area, it is possible that fuel pumps may become noisy during operation. At present no other symptoms or faults are expected. Remedy Correct level fuel pump control unit(s) should be installed 4M0 906 093K. |
| 2059124/1 | 2020-04-03. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM; POWER TRAIN. Technical background: New Continental GT Software update required to the engine control module and transmission control module Bentayga Software update required to the transmission control module Please ensure the operative uses the applicable SVM code for the correct vehicle type Remedy: Software update required for the applicable control modules depending on vehicle type |
| 2058484/1 | 2020-04-03. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE; ELECTRICAL SYSTEM. Customer statement / workshop findings: Check Engine Lamp illuminated on Driver Instrument Panel (DIP) Diagnostic Trouble Code (DTC) P310B00 Low Fuel Pressure Regulation stored in the Engine Control Unit (ECU). DTC P014800 Fuel Delivery Error stored in the ECU. Misfire DTC stored in the ECU. Technical background: There may be multiple DTCs and symptoms present due to fuel pressure regulation or fuel supply issues, use the information contained within the Measure section to determine the correct analysis and repair procedure. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.