Service bulletins for the 2019 Bentley Bentayga
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
629 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Brakes are shown. Show all
| 2075034/4 | 2026-06-04. Service bulletin. ELECTRICAL SYSTEM; SERVICE BRAKES; STRUCTURE:BODY. EPB Warning light in DIP - Front door/s power latch system intermittent - DTC U112300 within Address 03 and Address 46. Customer statement / workshop findings: One or a combination of the following is evident within the DIP (Figure 1) • Electronic parking brake warning And/or • Drivers door power latch intermittent operation warning |
|---|---|
| 2052785/10 | 2025-11-04. Service bulletin. SERVICE BRAKES. Brake noise identification |
| 2075034/3 | 2025-07-30. Service bulletin. SERVICE BRAKES; ELECTRICAL SYSTEM; STRUCTURE:BODY; BACK OVER PREVENTION: WARNINGS. EPB Warning light in DIP - Front door/s power latch system intermittent - DTC U112300 within Address 03 and Address 46. Condition: One or a combination of the following is evident within the DIP • Electronic parking brake warning And/or • Drivers door power latch intermittent operation warning |
| 2060726/4 | 2025-03-07. Service bulletin. WHEELS; SERVICE BRAKES. Bentayga - Winter Wheel and Tyre For CSiC Braking Systems. Technical Background: When opting to use Winter Tyres on vehicles specified with Ceramic brake rotors, the only permissible wheel rim option is 21 Inch 7 Twin spoke –36A 601 025Q. |
| 2052785/9 | 2025-03-07. Service bulletin. SERVICE BRAKES. Brake noise identification. Technical Background: Brake noises can be attributed to many causes, the most common causes are as follows: • Brake discs or pads are close to their wear limit • New brake pads and/or discs have not been properly bedded in after installation • Aftermarket pads or discs are installed • There is debris such as small stones, grit, road salt or sand between the brake disc and pad • Discs are covered in rust. Rust can form when the vehicle has been stationary for long periods of time |
| 2071730/4 | 2025-01-07. Service bulletin. SERVICE BRAKES. Bentayga rear brake noise/squeal - Repair method depending on the brake noise frequency (Iron brakes only). |
| 2075034/2 | 2024-11-01. Service bulletin. BACK OVER PREVENTION: WARNINGS; STRUCTURE:BODY; ELECTRICAL SYSTEM; SERVICE BRAKES; BACK OVER PREVENTION: REARVIEW SYSTEM BRAKING. EPB Warning light in DIP - Front door/s power latch system intermittent - DTC U112300 within Address 03 and Address 46. Customer statement / workshop findings: One or a combination of the following is evident within the DIP • Electronic parking brake warning And/or • Drivers door power latch intermittent operation warning |
| 2071730/3 | 2024-08-07. Service bulletin. SERVICE BRAKES. Bentayga rear brake noise/squeal - Repair method depending on the brake noise frequency (Iron brakes only). Scenario 1 Vibration of 1.2 to 1.4 KHz is produced from the rear brakes whilst braking at low speed Whilst braking at low speed, a vibration of 1.2 to 1.4 KHz or 5 KHz can be produced from friction between the rear brake pad and disc resulting in rear brake noise/squeal Scenario 2 Vibration of 3.4 KHz is produced from the rear brakes While braking at low speed a vibration of 3.4 KHz can be produced during brake application at low speed resulting in rear brake noise/squeal Scenario 3 Vibration of 5 KHz is produced from the rear brakes whilst braking at low speed Whilst braking at low speed, a vibration of 5 KHz can be produced from friction between the rear brake pad and disc resulting in rear brake noise/squeal. |
| 2052785.8 | 2023-11-08. Service bulletin. SERVICE BRAKES, HYDRAULIC; UNKNOWN OR OTHER. Brake Noise Identification: Customer Statement: -Noise/squeal complaint from the braking system Technical Background: -The noise/squeal can be reproduced and clearly assigned to the braking system |
| 2060723.2 | 2022-12-08. Service bulletin. SERVICE BRAKES; WHEELS. Bentayga- Winter Wheel and Tyre for CSiC Braking Systems Technical Background: -When opting to use winter tyres on vehicles specified with ceramic brake rotors, the only permissible wheel rim option is 21 inch 7 twin spoke - 36A601025Q |
| 2055883.2 | 2022-12-08. Service bulletin. LATCHES/LOCKS/LINKAGES; PARKING BRAKE; ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. EPB Warning light in the DIP - Front door/s power latch system intermittent - DTC U112300 within Address 03 and Address 46 Customer Statement: -Electronic parking brake warning evident within the DIP |
| 2048616.10 | 2022-12-08. Service bulletin. SERVICE BRAKES; SUSPENSION. Creaking noise from the front suspension when maneuvering Technical Background: -The noise present in the sound file is caused by defective lower suspension lever - rear - hydraulic mounts. In order to reproduce the noise this bush must be twisted, therefore the noise can appear in the following circumstances. -When performing parking maneuvers with the brake applied -When steering from lock to lock with the vehicle in motion and the brake applied -When the vehicle is moved with steering input over uneven surfaces (a ramp or speed bump) |
| 2064404.2 | 2022-12-08. Service bulletin. SERVICE BRAKES. Brake pedal clicking after the vehicle pulls away (following initial engine start) Customer Statement: -Complain of the brake pedal clicking shortly after vehicle start up/drive away (following engine start) once the vehicle reaches 20kmh/12mph |
| 2046299.15 | 2022-12-08. Service bulletin. SERVICE BRAKES. Bentayga - 1.2KHz-1.4KHz brake squeal Customer Statement: -Squeal from the rear of the vehicle at low speed while braking. Technical Background: -While braking at low speed, a vibration of 1.2 to 1.4 KHz can be produced by the friction between the rear brake pad and disc resulting in a complain of brake noise from the customer. |
| 2054862/9 | 2022-07-07. Service bulletin. SERVICE BRAKES, HYDRAULIC; EQUIPMENT ADAPTIVE/MOBILITY. Front brake squeal - 1.5 KHz to 2.0 KHz. Customer statement / workshop findings: Front brake squeal with a frequency of 1.5 KHz to 2.0 KHz Technical background: Modified front brake Calipers and modified front brake disc guard plates are available on receipt of a qualifying DISS query Referring to Figure 1, the replacement front calipers have a Dynamic absorber fitted (A), the brake disc guard plates (B) are pre modified to fit around the absorber. |
| 2046299/14 | 2022-07-07. Service bulletin. EQUIPMENT; SERVICE BRAKES, HYDRAULIC. Bentayga - 1.2KHz - 1.4KHz rear brake squeal. Customer statement / workshop findings: Squeal from the rear of the vehicle at low speed while braking. Technical background: While braking at low speed, a vibration of 1.2 to 1.4 KHz can be produced by the friction between the rear brake pad and disc resulting in a complaint of brake noise from the customer. Measure: 1) Follow the Brake noise identification TPI 2052785 - IMPORTANT: For frequency analysis the noise recording equipment Bentley Motors recommends is the Chassis ear tool WT 10437 2) If the sound recording produces a frequency of 1.2-1.4KHz - Remove the rear brake pads as per Repair manual Rep.Gr 46 - Rear Brake Pads - To Remove and Fit and check the actual condition of the brake pads - If the brake pads are to be refitted it will be necessary to make note of the position of the pads for installation purposes |
| 2052853/9 | 2022-06-02. Service bulletin. SUSPENSION; SERVICE BRAKES, HYDRAULIC; STEERING. Clicking noises from the left and/or right front corner(s). Customer statement / workshop findings: Clicking noises from the left and/or right front corner(s) Technical background: In order to accurately diagnose and repair customer reported clicking noises from the front corner(s) the Measure section of this TPI consists of three individual sections, each section describes the symptom and the remedy which should be applied. Symptoms and descriptions regarding clicking noises can appear to be very similar when described, where possible the customer should demonstrate the reported symptom to enable correct diagnosis. |
| 2054862/8 | 2022-05-06. Service bulletin. SERVICE BRAKES, HYDRAULIC. Front brake squeal - 1.5 KHz to 2.0 KHz. Customer statement / workshop findings Front brake squeal with a frequency of 1.5 KHz to 2.0 KHz Technical background: Modified front brake Callipers and modified front brake disc guard plates are available on receipt of a qualifying DISS query. Referring to Figure 1, the replacement front callipers have a Dynamic absorber fitted (A), the brake disc guard plates (B) are pre modified to fit around the absorber. |
| 2052785/7 | 2022-04-08. Service bulletin. SERVICE BRAKES, HYDRAULIC. Brake noise identification. Customer statement: Noise complaint from the braking system. Workshop findings: The noise can be reproduced and clearly assigned to the braking system. Service: Note: For correct diagnosis and repair the attached Flowchart must be followed. 1. Check the overall condition of the brakes to determine if the brake noise can be attributed to one of the causes listed in the Technical Background section of this TPI. If the noise is not a result of one these causes, proceed with point 2. 2. Record the noise and frequency For the frequency analysis and the noise recording we recommend using the Chassis Ear Tool WT 10437. To record the noise and measure the frequency using WT 10437 Chassis Ear Tool follow these instructions; Refer to File recording in the WT 10437 user instructions. |
| 2054862/7 | 2022-04-07. Service bulletin. SERVICE BRAKES. Front brake squeal - 1.8 KHz to 1.9 KHz. Customer statement / workshop findings: Front brake squeal with a frequency of 1.8 KHz to 1.9 KHz Technical background: Modified front brake Calipers and modified front brake disc guard plates are available on receipt of a qualifying DISS query Referring to Figure 1, the replacement front calipers have a Dynamic absorber fitted (A), the brake disc guard plates (B) are pre modified to fit around the absorber. |
| 2066580/1 | 2022-04-06. Service bulletin. SERVICE BRAKES. Odour emanating from the front wheel arches/front wheels - Odour is also evident within the cabin. Customer statement / workshop findings: - Undesirable odour emanating from the front wheel arches, the issue occurs after the vehicle has reached normal operating temperature - The odour can also be evident within the cabin Technical background: HINT: The issue described is mainly evident on low mileage/low use vehicles with iron brakes In the event the symptoms are as described, please conduct the instructions within the Measure section of this TPI |
| 2065197/1 | 2021-12-03. Service bulletin. SERVICE BRAKES, HYDRAULIC; POWER TRAIN; SUSPENSION; STEERING. Squeaking/creaking noises from the front axle and/or leaks at the lower ball joint/s. Customer statement / workshop findings: Squeaking/creaking noises when steering/manoeuvring or when the suspension compresses and/or: A leak is visible at the boot of the lower ball joint (grease emerging) however the boot does not show any damage Workshop findings: Noises: The noises can be assigned to the lower ball joint on the left and/or right side (Figure 1 - item 20). Leak (grease emerging): Leak at the boot of the lower ball joint on the left and/or right side (Figure 1- item 20) is visible however the boot is undamaged. Technical background: In the event the symptom is as described, the operative should carry out the instructions within the Measure section Make sure that the production date of the new ball joint is 36/19 or later (see date code example circled in Figure 2 - Week 36 of 2019). |
| 2052853/8 | 2021-12-03. Service bulletin. STEERING; SERVICE BRAKES, HYDRAULIC; SUSPENSION. Clicking noises from the left and/or right front corner(s). Customer statement / workshop findings: Clicking noises from the left and/or right front corner(s) Technical background: In order to accurately diagnose and repair customer reported clicking noises from the front corner(s) the Measure section of this TPI consists of three individual sections, each section describes the symptom and the remedy which should be applied Symptoms and descriptions regarding clicking noises can appear to be very similar when described, where possible the customer should demonstrate the reported symptom to enable correct diagnosis. |
| 2052785/6 | 2021-10-05. Service bulletin. SERVICE BRAKES, HYDRAULIC. Brake noise identification. Customer statement / workshop findings: Noise complaint from the braking system. Workshop findings: The noise can be reproduced and clearly assigned to the braking system. Technical background Brake noises can be attributed to many causes. Eight of the most common causes are: - Brake discs or pads are close to their wear limit. - New brake pads and/or discs have not been properly bedded in after installation. - Aftermarket pads or discs are installed. - There is debris such as small stones, grit, road salt or sand between the brake disc and pad. - Discs are covered in rust. Rust can form when the vehicle has been stationary for long periods of time (Figure 1). |
| 2064404/1 | 2021-10-04. Service bulletin. SERVICE BRAKES, HYDRAULIC. Brake pedal clicking after the vehicle pulls away (following initial engine start). Customer statement / workshop findings: Complaint of the brake pedal clicking shortly after vehicle start up/drive away (following engine start) once the vehicle reaches 20kmh/12mph Technical background: Refer to the video on the Bentley Hub referencing TPI 2064404/- The noise is the ABS control unit performing a self-test diagnostic routine If the complaint noise is as shown in the video, the customer should be advised that this is normal and expected behaviour |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.