Recalls that may apply to the 2003 Autocar WX
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 05V295000 | 2005-06-21. BACK OVER PREVENTION:WARNINGS:EXTERNAL/PEDESTRIAN ALERT. ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS, THE BACKUP ALARM MOTION SENSOR MAY NOT HAVE BEEN INSTALLED CORRECTLY AND MAY NOT SENSE WHEN THE VEHICLE MOVERS BACKWARDS UNDER ANY CIRCUMSTANCES. Built 2003-07-23 to 2005-05-31. |
|---|---|
| 05V032000 | 2005-02-03. SERVICE BRAKES, AIR:ANTILOCK:ABS WARNING LIGHT. ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH BENDIX AUTOMATIC BRAKE SYSTEMS (ABS), THE BRAKES MAY HAVE A SYSTEM FAULT THAT MAY NOT BE DETECTED BY THE ABS ELECTRONIC CONTROL UUNIT (ECU) AND THEREFORE WILL NOT GENERATE AN ABS WARNING LIGHT ON THE DASH OF THE TRUCK. Built 2003-07-01 to 2004-12-31. |
| 04V390000 | 2004-08-10. WHEELS:LUGS/NUTS/BOLTS/STUDS. ON CERTAIN TRUCKS EQUIPPED WITH ACCURIDE 22.5 X 9.00 - HUB PILOT H.D. STEEL WHEEL RIMS, THE REAR AXLE WHEEL STUDS ARE TOO SHORT. THESE STUDS MAY NOT BE ABLE TO RETAIN THE WHEEL NUT TORQUE AND COULD LOOSEN ALLOWING THE LOSS OF A WHEEL. Built 2003-12-09 to 2004-07-20. |
| 03V493000 | 2003-11-26. POWER TRAIN. ON CERTAIN TRUCKS EQUIPPED WITH ALLISON HEAVY DUTY TRANSMISSIONS, THE BOLTS FASTENING THE PROPSHAFT TO THE TRANSMISSION YOKE WERE NOT TIGHTENED SUFFICIENTLY. LOOSE BOLTS CAN CAUSE DISLOCATION OF THE PROPSHAFT. Built 2002-01-14 to 2003-11-18. |
| 2005024 | 2005-02-01. Brakes. On certain vehicles, testing procedures designed to verify that the ABS brakes are wired correctly and that all hardware is operational were not performed properly during vehicle assembly. As a result, the ABS brakes may have a system fault that may not be detected by the ABS electronic control unit and therefore will not illuminate the ABS warning light on the dash. Correction: Dealers will perform a complete diagnostic test on the ABS braking system to ensure all components and wiring are functioning as designed. |
|---|---|
| 2004434 | 2004-12-10. Suspension. On certain vehicles, the air suspension height control valve may not be plumbed through an air pressure protection valve. In the event of a suspension air bag failure or rupture of the air line, there would be a loss of air pressure in the "B" system air reservoir that supplies air pressure for the front steer axle brakes. This condition would increase stopping distance of the vehicle and under certain conditions could result in a crash. Correction: Dealers will install an air pressure protection valve in the "B" system air tank. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.