Service bulletins for the 2013 Audi Q7
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1239 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| Dealer Letter - | 2017-11-17. Service bulletin. FUEL SYSTEM, OTHER; ENGINE. Due to Illinois state tax incentives for biofuels, biodiesel blends of B5 or less may not be available in the State of Illinois. Because Audi supports the development and use of renewable fuels (such as biodiesel fuel blends), customers with 2009-2013 MY Audi TDI® Clean Diesel Engine vehicles registered in the State of Illinois only will receive a communication on or about February 21, 2013 regarding the use of biodiesel fuel blends in their vehicles. Audi will continue to honor the terms and conditions of Audi Limited Warranties that came with these vehicles. Please refer to Warranty Policies & Procedures Bulletin AWA 13-01 for additional information. |
|---|---|
| AWA-13-01 | 2017-11-17. Service bulletin. FUEL SYSTEM, DIESEL. This Warranty Bulletin is applicable to certain 2009MY and forward Audi TDI® Clean Diesel Engine vehicles (with Engine Codes CATA, CBEA, or CNRB) registered in the State of Illinois only. |
| A941303 2029194- | 2017-11-17. Service bulletin. EXTERIOR LIGHTING; EXTERIOR LIGHTING:HEADLIGHTS. Supersedes Technical Service Bulletin Group 94 number 12-99 dated November 30, 2012. Only vehicles with Xenon headlights can be affected by this condition. The customer complains the high beams do not function on one side or one of the low beams flickers intermittently. In addition to this, an "Adaptive Headlight Defective" warning can be present in the cluster if the vehicle has the Prestige trim level. One of the following DTCs are set in the 09 - Central Electric Control Unit or in the 55 - Headlamp Range Control Unit depending on the trim level of the vehicle. Vehicles with the Premium Plus option package can have the DTC set in the 09 module. Vehicles with the Prestige option package can have the DTC set in the 55 module. One or more of the connectors inside the headlamp housing are disconnected fully or partially from the factory. |
| A911374 2024323- | 2017-11-17. Service bulletin. BACK OVER PREVENTION: CAMERA SYSTEM. Supersedes Technical Service Bulletin Group 91 number 12-61 dated October 1, 2012. Parking aid sporadically warns of obstacles when none exist. Parking aid is inoperative or provides constant warning. Various parking aid sensor fitting issues. Environmental conditions. |
| A851313 2032579- | 2017-11-17. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; EQUIPMENT ADAPTIVE/MOBILITY. Supersedes Technical Service Bulletin Group 85 number 13-12 dated January 22, 2013. The air distribution fins in either of the outer instrument panel vents do not adjust. The fins may be broken or loose and cause a rattling sound. The fins may also be missing. This condition arises due to a tolerance issue with the components in the mechanism during production. |
| A571382 2017082- | 2017-11-17. Service bulletin. LATCHES/LOCKS/LINKAGES; EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 57 number 11-55 dated August 22, 2011. Central locking via remote control does not work either sporadically or permanently. The locks can still be operated manually. Missing synchronization between the remote control key and vehicle because the battery has been disconnected or the battery of the remote control has been replaced. If other senders operate in the same frequency range (mobile phones, TV stations, wireless headphones, baby monitors, other vehicle remote controls, etc.), the remote control key may have been temporarily switched off because a clear identification of the remote control key is not possible. This is necessary to prevent an unintentional unlocking of the vehicle by other unrelated senders. |
| A441337 2030275- | 2017-11-17. Service bulletin. SUSPENSION; STEERING. Supersedes Technical Service Bulletin Group 44 number 12-34 dated November 13, 2012. Customers may report the following conditions on vehicles with less than 6000 miles. In some cases these conditions may be noticed at PDI. Vehicle pulls - left or right. Steering wheel not leveled or off-center. If the alignment concern is due to outside influence (e.g. accident), this TSB does not apply. |
| A441336 2022563- | 2017-11-17. Service bulletin. SUSPENSION. Supersedes Technical Service Bulletin Group 44 number 13-35 dated January 18, 2013. Customer feels vibration from 55 - 80 mph (88 - 128 km/h) in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not result in any handling concerns or loss of vehicle control. |
| A371392 2030370- | 2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Supersedes Technical Service Bulletin Group 37 number 12-60 dated August 6, 2012. Customer complains that the transmission malfunction warning appears in the cluster. Customer is unable to select gear. GFF scan of the vehicle finds fault P070600 (driving position sensor - implausible signal) logged in the transmission control module (diagnosis address 02). The test plan points to the F125 multi-function switch as the cause. Corrosion on the pins of the multi-function switch and its counterpart can lead to implausible signals. |
| Audi IQS Newslet | 2017-11-17. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. The topics for the Audi IQS Newsletters are chosen based on "Voice of the Customer" data and respond directly to top concerns of Audi owners. They are designed to help educate you and make an impact on customer satisfaction. Dealer Communications dealing with IQS topics are also distributed on occasion. |
| A941316 2033675- | 2017-11-17. Service bulletin. EXTERIOR LIGHTING:TAIL LIGHTS. The customer may report that the tail lamp lighting does not switch between the rear lid and the bumper when the lid is operated. DTC 03703 (Rear lid -closed- sensor) may be stored in the comfort system central control module, J393 (address word 46). |
| A481343 2015819- | 2017-11-17. Service bulletin. STEERING:ELECTRIC POWER ASSIST SYSTEM. Supersedes Technical Service Bulletin Group 48 number 11-15 dated January 10, 2011. The customer may report that the Easy Entry function of the power adjustable steering column intermittently does not work. |
| A461335 2017130- | 2017-11-17. Service bulletin. SERVICE BRAKES. Supersedes Technical Service Bulletin Group 46 number 11-16 dated December 9, 2011. Customer complains of brake squeal. |
| A431315 2033587- | 2017-11-17. Service bulletin. SUSPENSION. Self-leveling suspension cannot be adjusted during extremely cold weather. The self-leveling suspension warning light is illuminated in the instrument cluster. The self-leveling suspension operates normally again after the vehicle has been parked for a while in a garage or in the sun. DTC 20645 003 (valves for self-leveling control, mechanical fault) is present in the level control system module, J197 (address word 34). If the dryer on the air supply unit (air compressor) has taken in humidity for a long period of time, it may become saturated. As a result, the increased air humidity may get into the solenoid valve block and create condensation. In freezing temperatures, the condensation can freeze and block the valves, a condition that is recognized as a mechanical fault by the vehicle's self-diagnosis. Humidity can also enter the system if there is too much water in the air filter housing. Excess water can enter the air filter housing if the vehicle is driven in deep water or exposed to splashing water for an extended period of time (such as during off-road use). |
| A001348 2002047- | 2017-11-17. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Supersedes Technical Service Bulletin Group 00 number 11-19 dated April 8, 2011. This TSB contains information on technician preparation when calling the Audi Technical Assistance Center |
| A011378 2033379- | 2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING. DTC P164D00 (Oil pressure switch for reduced oil pressure malfunction) is stored in the engine control module, J623 (01). Red oil pressure warning light may be on. An oil filter that is too short is installed. The oil filter must be 155 mm. |
| A011380 2024344- | 2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 01 number 11-19 dated February 3, 2011. MIL on. Vehicle has reduced performance (in "limp mode"). Various entries may be logged. After recognizing that the boost pressure is too low or too high, the engine control module switches to emergency operation and the engine performance is reduced via the injected fuel quantity ("limp mode"). |
| A171338 2012913- | 2017-11-17. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 17 number 10-07 dated June 3, 2010. Oil filter cartridge requires replacement. |
| A191335 2025303- | 2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 19 number 11-19 dated February 10, 2011. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service. |
| A571385 2017082- | 2017-11-17. Service bulletin. ELECTRICAL SYSTEM; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. Supersedes Technical Service Bulletin Group 57 number 13-82 dated February 5, 2013. Central locking via remote control does not work either sporadically or permanently. The locks can still be operated manually. Missing synchronization between the remote control key and vehicle because the battery has been disconnected or the battery of the remote control has been replaced. If other senders operate in the same frequency range (mobile phones, TV stations, wireless headphones, baby monitors, other vehicle remote controls, etc.), the remote control key may have been temporarily switched off because a clear identification of the remote control key is not possible. This is necessary to prevent an unintentional unlocking of the vehicle by other unrelated senders. |
| A911380 2032706- | 2017-11-17. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. Supersedes Technical Service Bulletin Group 91 number 13-73 dated January 25, 2013. Customer complains of a "popping" noise from the radio followed by 10-15 seconds of no audio. The concern can happen in any audio source. Vehicle is equipped with MMI 3G or MMI 3G+ infotainment systems. Vehicle is not equipped with Bose or Bang & Olufsen sound systems. An ignition cycle is not required for audio to resume.The problem originates in the HD radio code, which can create a "resetting" within the radio unit. Because the tuner is always active in the background, the problem can occur regardless of the audio source or if the HD radio is on or off. It can also occur at any point that the MMI is on, but not necessarily active. For example, the customer opens a door and the MMI starts up. Even though the system is not ?on? because the ignition is not active, the tuner is running and can create the effect. |
| A941310 2029194- | 2017-11-17. Service bulletin. EXTERIOR LIGHTING; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 94 number 13-03 dated February 1, 2013. Only vehicles with Xenon headlights can be affected by this condition. The customer complains the high beams do not function on one side or one of the low beams flickers intermittently. In addition to this, an "Adaptive Headlight Defective" warning can be present in the cluster if the vehicle has the Prestige trim level. One of the following DTCs are set in the vehicle electrical system control module, J519 (09), or in the headlamp range control module, J431 (55), depending on the trim level of the vehicle. Vehicles with the Premium Plus option package can have the DTC set in the J519 (09) module. Vehicles with the Prestige option package can have the DTC set in the J431 (55) module. One or more of the connectors inside the headlamp housing are disconnected fully or partially from the factory. |
| A941311 2028277- | 2017-11-17. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. Supersedes Technical Service Bulletin Group 94 number 13-01 dated January 2, 2013. There is considerable moisture present in the headlamp. The moisture disappears only after extended drives (greater than 10 minutes). There is no external damage to the headlamp which could introduce moisture. |
| Email Mandatory | 2017-11-17. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This document contains the important email to all Audi dealership personnel in regards to the immediate madatory stop-sale order that is in effect to all vehicles from 20110-2015 that have a 2.0L TDI engine. |
| A961501 2019260- | 2017-11-17. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 96 number 13-67 dated July 10, 2013. The customer may report that the handheld transmitter cannot be programmed to the garage door opener control module, J530. The customer?s door opener system may not be compatible with J530. The battery in the handheld transmitter may be too weak for a good signal. The battery charge may be sufficient to operate the garage door opener, but not enough to program the remote transmitter to the vehicle system. The battery in the handheld transmitter may be too weak for a good signal. The battery charge may be sufficient to operate the garage door opener, but not enough to program the remote transmitter to the vehicle system. In A4 model years 2005?2006 and A3 model year 2009, the actual location of the garage door opener control module differs from the location shown in the owner's manual (opposite side of front bumper). The customer may misunderstand the programming procedure, particularly if the customer?s HomeLink® opener system is using an alternate code. The handheld transmitter?s programming function may become inoperative, or the transmitter is too far away from J530. Interference prevents the communication between handheld transmitter and J530. Interference prevents the communication between handheld transmitter and J530. If the vehicle flashes during the programming of a handheld transmitter, this does not necessarily indicate that the programming was successful; it only indicates that the vehicle has recognized and saved a signal. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.