WenmarOpen by Wenmar Pro

Service bulletins for the 2010 Audi A5

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

892 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
37 13 08 20341632022-05-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM:SOFTWARE. Software error in the transmission control module. Customer may report that the transmission does not work correctly. ? Shortly after a cold start, the following message appears in the instrument cluster display: ?Gearbox Malfunction! Journey can be continued?. The gearbox is in limp mode until the key is cycled. ? The issue is very sporadic and cannot be reproduced with a test drive. ? DTC P17E1 (Gear positioner 2 mechanical malfunction) with DFCC 9473 is stored in the transmission control module, J743 (address word 02). ? The DFCC is the 4-6 digit code that is typically listed before the fault code (Figure 1).
37 13 07 20336582022-05-02. Service bulletin. SERVICE BRAKES. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine electronic control system software. As a result, application of the brake and accelerator pedals at the same time (brake pedal with left foot and accelerator pedal with right foot) results in the following: ? Brake pedal function (normal at all times) overrides any throttle application. ? Diagnostic Trouble Codes (DTCs) will not be stored. ? When the brake pedal is applied while the accelerator is depressed, engine RPMs will return to idle speeds of 1400 RPMs after approximately two seconds. ? When the accelerator is applied while the brake pedal is depressed, the vehicle accelerates slower than usual (reduced engine torque).
37 12 75 20298082022-05-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). New software in the Transmission Control Module (J217) addressed the condition.
34 13 14 20267192022-05-02. Service bulletin. EQUIPMENT; POWER TRAIN:MANUAL TRANSMISSION. Improved 5th and 6th shift fork and gearshift unit.
34 13 13 20286502022-05-02. Service bulletin. POWER TRAIN. Customer states constant howling, droning, or scraping noises heard from the front of the vehicle when accelerating lightly. The ball bearing for the left flange shaft spins in the gearbox housing because of a gap between the outer bearing ring and the support bracket. This can result in grinding marks and swarf (Figure 1, Figure 2).
30 13 18 20282292022-05-02. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION; ELECTRICAL SYSTEM. There may be clutch mechanism wear. Customer may report that the vehicle does not start or only starts when the clutch pedal is pressed very firmly. The message ?Press clutch pedal to start vehicle? may appear in the instrument cluster.
28 13 22 20284192022-05-02. Service bulletin. SEAT BELTS; STEERING. Before a replacement electronic steering column lock control unit, J764, is installed, the software of the access start authorization control unit, J393, must be updated due to a diagnostic software error that prevents the DTC from being cleared.
28 13 21 20175552022-05-02. Service bulletin. ELECTRICAL SYSTEM. It is possible that objects have been inserted into the ignition lock, which causes the slide of the ignition lock to become stuck in the rear part of the lock (S-contact position). The stuck slide is not allowed to return to the starting point (0-position).
27 14 24 20253602022-05-02. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY; ELECTRICAL SYSTEM. This TSB provides basic diagnosis steps for discharged batteries, general tips for working with batteries, and system verification steps to ensure that the vehicle is configured correctly. For additional information on known current draw issues, refer to the following TSBs: ? 2014127: 27 Battery dead or low after returning to the vehicle (2007 A6, A8, Q7) ? 2019143: 27 Battery discharged on some vehicles with Advanced Key (2005 - 2008 A6, Q7)
27 13 18 20232822022-05-02. Service bulletin. EQUIPMENT. Battery testing and charging for vehicles equipped with a Battery Data Manager (BDM - J367). When the InCharge 940 is used as a battery charger in auto mode, it performs a battery condition test and may prematurely fail the battery if the charging takes place at the jumper posts in the engine compartment. This is due to the added resistance in the system between the battery and jumper posts. When the InCharge 940 is used as a battery charger in manual mode, the battery condition test is not performed.
26 13 18 20279452022-05-02. Service bulletin. ENGINE AND ENGINE COOLING. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
26 13 17 20279452022-05-02. Service bulletin. BACK OVER PREVENTION. Humming or metallic rattling noise from under the vehicle, heard most consistently during engine idle or slow acceleration. Initial inspection indicates that the noise is coming from the exhaust system. Relative movements in the rear mounting of the exhaust system (rear silencer).
24 14 50 20382122022-05-02. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS. Possible incorrect function on the sensor elements of the air mass meter.
DC_202203292022-04-05. Service bulletin. EQUIPMENT. Dealer Communication: Vehicle Sales Reporting, Reinstatement, and Audit Policy
A4022372024318112022-04-05. Service bulletin. SUSPENSION:FRONT:WHEEL BEARING. This bulletin describes the proper procedure to address a clicking or clacking noise from the wheel bearing
A1722172060750_32022-04-05. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin contains instructions for using the UV additive to find engine oil leaks.
A4622282051095_52022-03-04. Service bulletin. EQUIPMENT:ELECTRICAL. This informational bulletin contains instructions on how to download and use the Audi Frequency App.
A0122162033001262022-03-04. Service bulletin. ENGINE. This bulletin provides instructions on how to clean the secondary air ports if they have too much carbon and cause a restriction.
A9122752024323_92022-03-04. Service bulletin. ELECTRICAL SYSTEM:ADAS:PARKING ASSIST:SOFTWARE; ELECTRICAL SYSTEM:ADAS:PARKING ASSIST:SENSORS; ELECTRICAL SYSTEM:ADAS:PARKING ASSIST:WARNING. This bulletin contains technical information regarding when the parking aid sporadically warns of obstacles that don't exist or it is inoperative/constant warning.
A4622262022584112022-02-04. Service bulletin. SERVICE BRAKES. This informational bulletin provides diagnostic information for brake conditions.
A1922282025303132022-02-04. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. This bulletin contains instructions for identifying and mixing factory fill coolants.
A1922272025303122022-02-04. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM; EQUIPMENT. This bulletin contains instructions for identifying and mixing factory fill coolants.
A4021312024318_12022-01-05. Service bulletin. WHEELS. This technical service bulletin provides instructions for correcting a clicking sound from the wheel bearing(s).
A4021302023187_62022-01-05. Service bulletin. STEERING. This information bulletin provides an explanation for squeaking noises heard when the steering wheel is turned or maneuvered.
A0021552011732122022-01-05. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This bulletin contains general instructions for software updates.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.