Service bulletin SSM 55218
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 11038166 |
| Published by NHTSA | 2026-10-06 |
| Manufacturer's number | SSM 55218 |
| Manufacturer's date | 2026-10-06 |
| NHTSA component | POWER TRAIN; UNKNOWN OR OTHER |
NHTSA's summary
For 20202026 vehicles equipped with the 10R140 transmission, a new Transmission Clutch Circuit Leak Test has been introduced in the Ford Diagnosis and Repair System (FDRS). This test utilizes the pressure and vacuum transducer (PVT) when available. Workshop Manual (WSM) updates related to this diagnostic procedure are planned for release in Q4 2026. The new test improves the accuracy of detecting leaks within transmission fluid circuits and replaces the previous air check method. The previous air check procedure has been shown to produce a high rate of false positives, which may lead to unnecessary repairs when no actual leak is present. Accordingly, the air check procedure is not to be used for diagnosing internal transmission hydraulic leaks or as justification for transmission replacement.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Transmission and driveline
| FORD F-250 SD | 2020, 2021, 2022, 2023, 2024, 2025, 2026 (the catalog's model; the bulletin names a series or trim of it) |
|---|---|
| FORD F-350 SD | 2020, 2021, 2022, 2023, 2024, 2025, 2026 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-450 SD | 2020, 2021, 2022, 2023, 2024, 2025, 2026 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-550 SD | 2020, 2021, 2022, 2023, 2024, 2025, 2026 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-650 SD | 2024, 2025, 2026 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-750 SD | 2024, 2025, 2026 (the catalog's model; the bulletin names a series or trim of it) |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2026097 | 2026-03-03. Powertrain |
|---|---|
| 26V119000 | 2026-03-03. POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT |
| 2025688 | 2025-12-12. Powertrain |
| 25V866000 | 2025-12-12. POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT |
| 2025396 | 2025-07-25. Powertrain |
| 2025133 | 2025-03-14. Powertrain |
| 25V163000 | 2025-03-14. POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL) |
| 23V758000 | 2023-11-09. WHEELS:LUGS/NUTS/BOLTS/STUDS; POWER TRAIN:AXLE HUBS |
| 2023508 | 2023-09-12. Powertrain |
| 23V625000 | 2023-09-08. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:PARK PAWL |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| TSB 26-2375 v2 | 2026-10-13. Service bulletin. NOTE: This bulletin has been updated, refer to the change log at the bottom for details. Issue: Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: • Poor shift quality • Illuminated powertrain malfunction (wrench) indicator with DTCs P2704 and P0771 stored in the PCM / TCM . This may be due to a calibration in the TCM and/or wear between the input shaft and the E clutch hub causing theinput shaft O-rings to become damaged resulting in an open E clutch circuit. Action: For vehicles that meet all of the criteria in the Issue and Model statements, follow the Service Procedure toreprogram the PCM / TCM and/or replace the E clutch hub and input shaft O-rings |
|---|---|
| TSB 26-2088 v2 | 2026-10-05. Service bulletin. This bulletin supersedes 24-2249. Reason for update: update the claim quantity of the torque converter nuts, part number and claim quantity of the front support assembly bolt washers, and part number change of the fluid pan from the Parts List. Reissued 01-Oct-2026 - Added LC3Z-7G091-B to the part list |
| TSB 26-2406 | 2026-09-12. Service bulletin. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: Poor shift quality Illuminated powertrain malfunction (wrench) indicator with diagnostic trouble codes (DTCs) P2704 and P0771 stored in the powertrain control module (PCM)/transmission control module (TCM) This may be due to sticking valves in the main control valve body and/or damaged E clutch friction plates and/or E clutch steel plates. Additional model information: 6.7L Diesel Engine 7.3L Gas Engine 10R140 Automatic Transmission |
| TSB 26-2252 | 2026-09-12. Service bulletin. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: Poor shift quality Illuminated powertrain malfunction (wrench) indicator with diagnostic trouble codes (DTCs) P2704 and P0771 stored in the powertrain control module (PCM)/transmission control module (TCM) This may be due to the software in the TCM (diesel only) and/or sticking valves in the main control valve body and/or damaged E clutch friction plates and E clutch steel plates. Additional model information: 6.7L Diesel Engine 7.3L Gas Engine 10R140 Automatic Transmission |
| TSB 26-2375 | 2026-08-19. Service bulletin. This article supersedes TSB 26-2050 to increase the labor operation allowance of labor operations A and B. Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: Poor shift quality Illuminated powertrain malfunction (wrench) indicator with diagnostic trouble codes (DTC) P2704 and P0771 stored in the PCM/TCM. This may be due to a calibration in the TCM and/or wear between the input shaft and the E clutch hub causing the input shaft O-rings to become damaged resulting in an open E clutch circuit. Additional model information: 6.7L Diesel Engine 2022-2024 F-550 or F-600 F-Super Duty vehicles built on or before 15-May-2024 with over 5,000 miles (8,000km) |
| SSM 54976 | 2026-07-07. Service bulletin. Some 2023-2026 F-53 Motorhome Chassis/F-59 Commercial Stripped Chassis and 2024-2026 F-650/F-750/E-Series vehicles equipped with a 6R140 transmission may be limited to 5th gear and reverse gear only. Additionally, the driver will be able to shift back to park. Diagnostic trouble codes (DTC) P2701, P2704, P0757, and/or P0733 may be stored in the powertrain control module (PCM). This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SOC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. Inform the customer that the condition has no impact on tr |
| SSM 54975 | 2026-07-07. Service bulletin. Some 2023-2026 F-Super Duty vehicles equipped with a 10R100 or 10R140 transmission may exhibit an intermittent failure to engage forward or reverse gears and/or a loud whining noise. Additionally, the driver will be able to shift back to park. This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SoC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. Inform the customer that the condition has no impact on transmission durability. For claiming, use causal part 12A650 and labor operations 12650D, 12650D45, and 12650D81. |
| SSM 54900 | 2026-06-09. Service bulletin. Some 2023-2026 F-Super Duty vehicles equipped with a 10R100 or 10R140 transmission may exhibit an intermittent failure to engage forward or reverse gears and/or a loud whining noise. Additionally, the driver will be able to shift back to park. This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SoC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. Inform the customer that the condition has no impact on transmission durability. For claiming, use causal part 12A650 and labor operations 12651D, 12651D45, and 12651D80. |
| SSM 54899 | 2026-06-09. Service bulletin. Some 2023-2026 F-53 Motorhome Chassis/F-59 Commercial Stripped Chassis and 2024-2026 F-650/F-750/E-Series vehicles equipped with a 6R140 transmission may be limited to 5th gear and reverse gear only. Additionally, the driver will be able to shift back to park. Diagnostic trouble codes (DTC) P2701, P2704, P0757, and/or P0733 may be stored in the powertrain control module (PCM). This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SOC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. |
| TSB 26-2263 | 2026-06-05. Service bulletin. This bulletin supersedes 26-2112. Reason For Update: add 2026 model year vehicles, update LV fluid XT-10-QLVC and CXT-10-LV6 description to add "Transfer Case Fluid 4WD Only", and update Step 4 to inspect/replace 7H351 and 7B177 outside of this article. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: - No upshift past second gear - Unable to achieve third gear ratio - Illuminated MIL with DTCs P0757 and P2701 This may be due to a damaged one-way clutch (OWC). |