Service bulletin NTB11044A
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10192100 |
| Published by NHTSA | 2021-05-10 |
| Manufacturer's number | NTB11044A |
| Manufacturer's date | 2012-12-21 |
| NHTSA component | WHEELS |
NHTSA's summary
SERVICE INFORMATION To increase tire/wheel assembly balancing accuracy, proper steps should be followed - Make sure to use the correct size wheel centering collet (do not use a cone). - Make sure to use a flange plate and stud set to secure the tire/wheel assembly on the balancer (do not use a cup). - Perform proper wheel mounting and centering checks. See this bulletin for further detail.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Wheels
| NISSAN 370Z | 2011, 2012, 2013 |
|---|---|
| NISSAN ALTIMA | 2011, 2012, 2013 |
| NISSAN ARMADA | 2011, 2012, 2013 |
| NISSAN CUBE | 2011, 2012, 2013 |
| NISSAN FRONTIER | 2011, 2012 |
| NISSAN GT-R | 2011, 2012, 2013 |
| NISSAN JUKE | 2011, 2012, 2013 |
| NISSAN LEAF | 2011, 2012 |
| NISSAN MAXIMA | 2011, 2012, 2013 |
| NISSAN MURANO | 2011, 2012, 2013 |
| NISSAN NV | 2012, 2013 |
| NISSAN PATHFINDER | 2011, 2012, 2013 |
| NISSAN QUEST | 2011, 2012, 2013 |
| NISSAN ROGUE | 2011, 2012, 2013 |
| NISSAN SENTRA | 2011, 2012, 2013 |
| NISSAN TITAN | 2011, 2012, 2013 |
| NISSAN VERSA | 2011, 2012, 2013 |
| NISSAN XTERRA | 2011, 2012 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| NTB17-110A | 2024-10-22. Service bulletin. 2004 - 2015 TITAN; VIBRATION AT 40 – 50 MPH This bulletin is no longer active. Please discard previous versions of NTB17-110. |
|---|---|
| NTB10-126C | 2023-03-07. Service bulletin. WHEEL BEARING COLLISION DAMAGE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB16023 | 2021-05-10. Service bulletin. IF YOU CONFIRM A customer concern of while turning the steering wheel or when driving at low speed (straight or turning), a high pitch power steering noise can be heard. * Only while seated inside the vehicle And * With all of the windows up NOTE: If the audio and/or HVAC systems are turned ON it may be difficult to hear this issue. ACTION Install an Insulator onto the end of the power steering pump motor housing with the Service Procedure starting on the next page. Please see this bulletin for further details. |
| NTB13088A | 2021-05-10. Service bulletin. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail. |
| NTB12055E | 2021-05-10. Service bulletin. IF YOU CONFIRM: Customers concern of a "clicking" noise coming from either left or right front/rear CV-type axles during take-off/acceleration. ACTION: Apply Molykote M77 grease (P/N 44003-7S000) to the hub bearing surfaces. NOTE: * Do not remove the axle from the hub or transmission for this bulletin * Refer to the Electronic Service Manual (ESM) for model specific torque specifications. - For 2007-2013 Versa and 2013 LEAF vehicles, see the Service Procedure torque specifications on page 4. See this bulletin for further detail. |
| NTB15060 | 2021-05-10. Service bulletin. SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail. |
| NTB15043 | 2021-05-10. Service bulletin. SERVICE INFORMATION The appearance of painted alloy wheels can be damaged if acidic cleaners are used. DO NOT use Chrome Wheel Cleaner on Painted Wheels. Many chrome wheel cleaners have acidic ingredients. Make sure to follow all instruction in the Appearance and Care Section of the Owner?s Manual. Damage to wheel appearance due to the use of inappropriate chemicals or cleaning products is not covered under warranty. See this bulletin for further detail. |
| NTB15025 | 2021-05-10. Service bulletin. SERVICE INFORMATION Some of the wheel alignment specifications listed in the Front Suspension (FSU) and Rear Suspension (RSU) sections of the 2013-2015 Altima Sedan Electronic Service Manuals are incorrect. Updated Electronic Service Manuals will be distributed to the field as quickly as possible. Until the updated ESMs are made available, please use the updated service information hyperlinked in this bulletin. |
| NTB14088B | 2021-05-10. Service bulletin. IF YOU CONFIRM: There is a noise (clunking, popping, or bumping) when the steering wheel is turned AND the noise is coming from the top of either front strut assembly. NOTE: The location of the noise can be determined by using Essential Tool J39570 (Chassis Ear), positioning a clamp on each front strut spring, and then turning the steering wheel back and forth. ACTION: Install a spacer in both the left front and right front strut assemblies where shown in this bulletin. - Refer to the Electronic Service Manual (ESM), section FSU- Front Suspension for removal and installation instructions. See this bulletin for further detail. |
| NTB10112E | 2021-05-10. Service bulletin. SERVICE INFORMATION For vehicles delivered to the dealers with wheel protector covers - Do not remove the wheel protector covers during Pre-Delivery Inspection (PDI) - Wheel protector covers help prevent cosmetic rotor corrosion. See this bulletin for further detail. |