WenmarOpen by Wenmar Pro

Service bulletin 17-NA-316

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10190283
Published by NHTSA2021-04-15
Manufacturer's number17-NA-316
Manufacturer's date2017-10-01
NHTSA componentVISIBILITY:REAR WINDOW WIPER/WASHER

NHTSA's summary

Rear Window Washer Inoperative Condition Customer may comment on finding the rear window washer inoperative. In some cases, they may also comment on hearing a fluid noise coming from the driver side A-pillar area. Cause The cause of the condition may be the rear washer hose may have been pinched in driver the A-pillar area during installation. The sunroof drain hose routed alongside the washer hose has an offset clip retainer which may create too much interference and possibly kink/pinch the washer hose. Correction Verify the condition and replace the original sunroof drain hose offset retainer with a new non-offset retainer, following the steps in the Service Procedure below

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Glass, wipers and mirrors

Vehicles listed
CHEVROLET TRAVERSE2018

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
21-NA-0432025-02-12. Service bulletin. This bulletin advises the dealers to maintain the vehicle stock on hand by doing a full inspection on the vehicles before being sold (prepping) to the customer.
PI0754G2024-08-17. Service bulletin. This PI provides information on Rear and Side Tempered Glass Spots (Quench Marks) and that they are a normal characteristic.
16-NA-3422024-08-13. Service bulletin. This service bulletin provides a procedure to check the rearview mirror coax connector for looseness by disconnecting and reconnecting the electrical connector to correct the customers concern for the rearview mirror video screen displaying blue.
16-NA-3422024-07-16. Service bulletin. This service bulletin provides a procedure to check the rearview mirror coax connector for looseness by disconnecting and reconnecting the electrical connector to correct the customers concern for the rearview mirror video screen displaying blue.
24-NA-0032024-02-10. Service bulletin. This technical bulletin provides a procedure to correct the condition Sunroof Wind / Air Deflector Inoperative.
PIT5099G2023-12-26. Service bulletin. This Preliminary Information communication provides information to the technician about vehicles that the Heater-Vent-Air Conditioning blows warm air. Before calling General Motors Technical Assistance Center technician will need to have high and low pressures, outside temperature, humidity, and vent temperature.
PI0754F2023-03-03. Service bulletin. This PI provides information on Rear and Side Tempered Glass Spots (Quench Marks) and that they are a normal characteristic.
PIP5540J2023-01-30. Service bulletin. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIC5260F2022-07-25. Service bulletin. This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.
PIT5099F2022-07-25. Service bulletin. This Preliminary Information communication provides information to the technician about vehicles that the Heater-Vent-Air Conditioning blows warm air. Before calling General Motors Technical Assistance Center technician will need to have high and low pressures, outside temperature, humidity, and vent temperature.