Service bulletin NTB17-048b
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10153005 |
| Published by NHTSA | 2019-02-19 |
| Manufacturer's number | NTB17-048b |
| Manufacturer's date | 2019-01-10 |
| NHTSA component | AIR BAGS |
NHTSA's summary
TAKATA INFLATOR FIELD QUALITY PARTS COLLECTION INITIATIVE 2013 AND 2015 ALTIMA Parts Collection Initiative ID #s PC553, PC554, PC555, and PC556 are No Longer Active. - Repair orders opened after January 10, 2019 are no longer eligible for reimbursement under Parts Collection Initiative ID #s PC553, PC554, PC555, and PC556. - Please discard previous versions of NTB17-048.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Air bags
| NISSAN ALTIMA | 2013 |
|---|---|
| NISSAN ALTIMA | 2015 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 16V911000 | 2016-12-19. AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION |
|---|---|
| 2016630 | 2016-12-15. Airbag |
| 16V244000 | 2016-04-26. AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION |
| 2015491 | 2015-10-20. Airbag |
| 15V681000 | 2015-10-20. AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION; AIR BAGS:FRONTAL |
| 2014093 | 2014-03-25. Airbag |
| 14V138000 | 2014-03-25. AIR BAGS:FRONTAL; ELECTRICAL SYSTEM:SOFTWARE |
| 2013079 | 2013-03-14. Airbag |
| 13V069000 | 2013-03-01. AIR BAGS |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| NTB19-071D | 2024-10-22. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page) |
|---|---|
| NTB19-071C | 2023-04-10. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB19-071B | 2022-06-03. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB00042D | 2021-05-10. Service bulletin. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail. |
| NTB14111 | 2021-05-10. Service bulletin. SERVICE INFORMATION The OCS (Occupant Classification System) sensors for the Applied Vehicles are now available as service parts. See this bulletin for further detail. |
| NTB08055C | 2021-05-10. Service bulletin. SERVICE INFORMATION Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic Service Manual (ESM) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail. |
| NTB13007 | 2021-05-10. Service bulletin. SERVICE INFORMATION If you confirm there is a need to replace the steering wheel switches on an Applied Vehicle for any reason: - Do not replace the driver air bag module. The steering wheel switches are now available as a separate service part. - Refer to the Service Procedure in this bulletin for steering wheel switch removal and installation instructions. See this bulletin for further detail. |
| NTB13059 | 2021-05-10. Service bulletin. IF YOU CONFIRM: The Malfunction Indicator Light (MIL) is "ON" with DTC P062F (Internal Control Module EEPROM Error) stored in the Transmission Control Module (TCM). and " No drivability symptoms are present. ACTION: 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the TCM. See this bulletin for further detail. |
| NTB13049 | 2021-05-10. Service bulletin. SERVICE INFORMATION If the door mirror corner finisher of either front door has to be removed or replaced for any reason, make sure to remove it as noted in the picture (see bulletin). NOTE: The front door finisher must be removed prior to door mirror corner finisher removal. Refer to the L DRIVER CONTROLS>MIR Mirrors section of the Electronic Service Manual (ESM). See this bulletin for further detail. |
| NTB13013 | 2021-05-10. Service bulletin. IF YOU CONFIRM: DTC C1197 is stored in the ABS actuator and electric unit (ABS control unit). NOTE: The brake warning light may be on. ACTION: 1. Refer to page 4, step 8 in the SERVICE PROCEDURE to confirm this bulletin pertains to an applied vehicle that you are working on. 2. If this bulletin applies, reprogram the ABS control unit. |