Service bulletin 07-002-15
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10148573 |
| Published by NHTSA | 2018-11-19 |
| Manufacturer's number | 07-002-15 |
| Manufacturer's date | 2015-01-07 |
| NHTSA component | ENGINE |
NHTSA's summary
Idler Pulley Noise During Cold Start This bulletin involves replacing the idler pulley. The customer may describe a loud high frequency noise that happens within 20 seconds of engine startup and lasts about 90 seconds intermittently during a cold engine start, approximately 0 degrees C (32 degrees F) and below.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Engine
| CHRYSLER 200 | 2011, 2012, 2013, 2014 |
|---|---|
| CHRYSLER 300 | 2011, 2012, 2013, 2014 |
| DODGE CARAVAN | 2011 |
| DODGE CARAVAN | 2013 to 2014 |
| DODGE CARGO VAN | 2012 |
| DODGE CHALLENGER | 2011, 2012, 2013, 2014 |
| DODGE CHARGER | 2011, 2012, 2013, 2014 |
| DODGE DURANGO | 2011, 2012, 2013, 2014 |
| DODGE JOURNEY | 2011, 2012, 2013, 2014 |
| JEEP CHEROKEE | 2014, 2015 |
| JEEP GRAND CHEROKEE | 2011, 2012, 2013, 2014 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2023338 | 2023-06-08. Engine |
|---|---|
| 23V411000 | 2023-06-08. ENGINE AND ENGINE COOLING |
| 2020544 | 2020-11-12. Engine |
| 20V699000 | 2020-11-12. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:GAS RECIRCULATION VALVE (EGR VALVE) |
| 2020371 | 2020-08-13. Engine |
| 20V475000 | 2020-08-13. ENGINE AND ENGINE COOLING:ENGINE:DIESEL |
| 2018269 | 2018-05-17. Engine |
| 15V676000 | 2015-10-19. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM |
| 2015475 | 2015-10-16. Engine |
| 15V431000 | 2015-07-07. ENGINE AND ENGINE COOLING:ENGINE |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| U67 Combo Rev11 | 2026-07-02. Warranty extension. Emissions Recall U67 - Catalytic Converter Efficiency - Dealer Notification (Revision 11) |
|---|---|
| 112191 | 2026-05-28. Service bulletin. COOLER - ENGINE OIL |
| 112192 | 2026-05-28. Service bulletin. COOLER - ENGINE OIL |
| 18-044-26 | 2026-03-25. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P0111-00 - Intake Air Temperature Sensor 1 Circuit Range Performance Bank 1. (In Active or Stored status) ● P0071-00 - Ambient Air Temperature Sensor Performance. (In Active or Stored status) ● P0072-00 - Ambient Air Temperature Sensor Circuit "A" Low. (In Active or Stored status) ● P0073-00 - Ambient Air Temperature Sensor Circuit "A" High. (In Active or Stored status) ● P0011-00 - Bank 1 Camshaft 1 Position Timing Over Advanced Or. (In Active or Stored status) ● P25E4-00 - B Camshaft Position - Unable To Achieve Locked Position Bank 1. (In Active or Stored status) ● P05BD-00 - Stop-Start Mode Switch Range/Performance. (In Active or Stored status) ● P0116-00 - Engine Coolant Temperature Sensor 1 Performance. (In Active or Stored status) ● P062B-00 - Internal Control Module Fuel Injector Control Performance. (In Active or Stored status) ● P0604-00 - Internal Control Module Random Access Memory Ram Error. (In Active or Stored status) ● P060C-00 - Internal Control Module Main Processor Performance. (In Active or Stored status)** ● P018B-00 - Fuel Pressure Sensor "B" Circuit Range/performance. **(In Active or Stored status)** ● P1CEA-00 - Boost Side EVAP Purge System Performance. **(In Active or Stored status)** ● P06DD-00 - Engine Oil Pressure Control Circuit Performance/Stuck Off. **(In Active or Stored status)** ● P00C6-00 - Fuel Rail Pressure Too Low - Engine Cranking. **(In Active or Stored status)** ● P0300-00 - Multiple Cylinder Misfire. **(In Active or Stored status)** Customers may also experience one or more of the following: ● **Oil Level High Warning in the Instrument Panel Cluster (IPC).** ● Fully Autonomous Parking Assist (FAPA) is not deactivated when accelerator pedal is pressed. ● Vehicle is not heating up fast enough at freezi |
| 9100639 | 2025-08-13. Service bulletin. Verify Reman part number availability. Order the "R" part number for all orders: Warranty, Mopar, customer pay and service contract. Order "68" part number for New unsold units only. |
| 103617 | 2025-04-01. Service bulletin. STARTER - ENGINE |
| 09-018-24 | 2024-09-04. Service bulletin. "2.4L Excessive Oil Consumption XB1 Warranty Extension The customer may describe one or more of the following: ● Oil pressure low indicator lamp illumination between oil changes. ● Excessive oil consumption. This bulletin involves performing an oil consumption verification test and possibly replacing the long block." |
| S1408000384 REV.F | 2024-07-02. Service bulletin. "Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On " |
| 9100279 | 2024-01-16. Service bulletin. COOLER Engine Oil Please be aware that the oil cooler seal is serviceable as a standalone part and should be considered for replacement as a remedy for fluid leak. |
| 9003357A | 2024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY review and follow instructions from the latest STAR Online S1809000007 available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA. |