Service bulletin 00-004-18-3515
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10144324 |
| Published by NHTSA | 2018-09-10 |
| Manufacturer's number | 00-004-18-3515 |
| Manufacturer's date | 2018-08-10 |
| NHTSA component | LANE DEPARTURE |
NHTSA's summary
In support of the new Mazda MX-5 and CX-3, Mazda will make available for loan on a "as-needed" basis, a Special Service Tool (SST) to allow for the radar aiming of the blind spot monitoring (BSM) system. The(BSM) radar aiming is performed whenever the (BSM) control module, the (BSM) bracket or the rear bumper is replaced. The tool is available for loan by contacting DAG.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance
| MAZDA !MX-5 | 2019 |
|---|---|
| MAZDA CX-3 | 2016, 2017, 2018, 2019 |
| MAZDA MX-5 | 2016, 2017, 2018 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 23V487000 | 2023-07-14. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 09-005-26 | 2026-02-03. Service bulletin. If the right-side Blind Spot Monitoring (BSM) control module is replaced for any reason, it is also necessary to replace the left-side BSM control module in order to complete the radar aiming procedure. If the right-side BSM control module is replaced alone, "Automatic Configuration" and "BSM Radar Aiming" cannot be completed due to a programming error in the module. In most cases, if the left-side BSM control module is replaced alone, "Automatic Configuration" and "BSM Radar Aiming" can be completed without any problem (See CAUTION below for more details). Other possible symptoms that may be found if the right-side BSM module is replaced alone: BSM aiming fails “BSM OFF" indicator ON Center Display warning message BSM failsafe (No operation) DTC U3000:54 stored in memory DTC U1A4B:54 stored in memory (CX-3, MX-5 only) NOTE: Since a new BSM control module does not retain the vehicle specification information, it is necessary to acquire and store the vehicle specification information transmitted via CAN communication from the combination meter through automatic configuration after replacement. |
|---|---|
| 09-032-23 | 2023-10-05. Service bulletin. SERVICE BULLETIN 09-031/20 ISSUED ON 09/21/20 IS NO LONGER VALID. IT IS SUPERCEDED BY RECALL 6023G (“2014-2018 MAZDA3 AND 2016-2021 CX-3 - REARVIEW IMAGE MAY NOT DISPLAY PROPERLY”). |
| 00-001-23 | 2023-08-03. Service bulletin. In support of the new Mazda MX-5 and CX-3, Mazda will make available for loan on an “as-needed” basis, a Special Service Tool (SST) to allow for the radar aiming of the blind spot monitoring (BSM) system. The BSM radar aiming is performed whenever the BSM control module, the BSM bracket or the rear bumper is replaced. |
| System | 2022-06-06. Service bulletin. Blind spot monitoring (BSM) system change |
| 0904515A | 2022-06-06. Service bulletin. Rattle noise from header panel of coinvertible top |
| 0904515 | 2022-06-06. Service bulletin. Rattle noise from header panel of coinvertible top |
| 0901316 | 2022-06-06. Service bulletin. Excessive condensation or water within the headlamp assembly caustion |
| 0500316 | 2022-06-06. Service bulletin. Grinding Noise from clutch pedal when depressing |
| 00-003/22 | 2022-04-05. Service bulletin. In support of the new Mazda MX-5 and CX-3, Mazda will make available for loan on as-needed basis, a Special Service Tool (SST) to allow for the radar aiming of the blind spot monitoring (BSM) system. The BSM radar aiming is performed whenever the BSM control module, the BSM bracket or the rear bumper is replaced. |
| SA-001/22 | 2022-02-04. Service bulletin. Symptom troubleshooting tables to diagnose MAZDA CONNECT concerns. No. 1 Blank Screen No. 2. Rear View Camera is not displayed No. 3 Rebooting No. 4 Infotainment System Has No Sound No. 5 Commander Switch Does Not Work No. 6 Bluetooth device will not pair No. 7 Incorrect GPS position No. 8 Voice Recognition Does Not Work No. 9 Cannot Make a Hands-Free Call No. 10 Cannot Play Bluetooth Audio No. 11 Other Symptoms No. 12 How to update the Navigation SD Card Map No. 13 How to Check Navi SD Card VIN Lock |