Service bulletin 07-005-18-3485
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10143963 |
| Published by NHTSA | 2018-08-20 |
| Manufacturer's number | 07-005-18-3485 |
| Manufacturer's date | 2018-06-15 |
| NHTSA component | EQUIPMENT:APPLIANCE:AIR CONDITIONER |
NHTSA's summary
Some customers may complain about an unpleasant odor (such as one may notice with a home freezer) coming from the A/C in hot weather (95°F / 35°C or above). This could be caused by improper control logic for the climate control unit that leaves the A/C compressor on too long and results in a frozen evaporator and an unpleasant odor. To correct this issue, the control logic for the climate control unit has been modified. NOTE: This TSB is not for musty/mildew odors. For those types of odors, refer to TSB for AIR CONDITIONING MUSTY / MILDEW ODOR.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Equipment and accessories, Heating and air conditioning
| MAZDA MAZDA3 | 2017, 2018 |
|---|---|
| MAZDA MAZDA6 | 2017 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| SA-027-24 | 2024-05-04. Service bulletin. Some customers may complain about infotainment center display. Peeling, spider cracks and white dots. |
|---|---|
| SA-008-24 | 2024-03-06. Service bulletin. Use the symptom troubleshooting tables below to diagnose MAZDA CONNECT concerns. |
| 01-007-23a | 2023-12-05. Service bulletin. The Mazda DCA-8000 is required for all warranty battery testing. If the Mazda DCA-8000 is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code. |
| SA-032-23a | 2023-11-02. Service bulletin. If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. |
| 09-032-23 | 2023-10-05. Service bulletin. SERVICE BULLETIN 09-031/20 ISSUED ON 09/21/20 IS NO LONGER VALID. IT IS SUPERCEDED BY RECALL 6023G (“2014-2018 MAZDA3 AND 2016-2021 CX-3 - REARVIEW IMAGE MAY NOT DISPLAY PROPERLY”). |
| 09-031-20b | 2023-08-04. Service bulletin. Some vehicles may exhibit a distorted image or no image from the rear mount camera when shifted into reverse. Due to friction, the coating of camera socket terminals may wear out, creating high electrical resistance. NOTE: The icons and the messages are displayed normally. |
| 09-031/20a | 2023-08-04. Service bulletin. Be advised that TSB "09-031/20 - REAR MOUNT CAMERA IMAGE NOT CLEAR/NO IMAGE ON SCREEN" is no longer valid and has been superseded by "RECALL 6023G - 2014-2018 MAZDA3 AND 2016-2019 CX-3 - REARVIEW IMAGE MAY NOT DISPLAY PROPERLY". Use the link below to view the recall: RECALL 6023G - 2014-2018 MAZDA3 AND 2016-2019 CX-3 - REARVIEW IMAGE MAY NOT DISPLAY PROPERLY |
| SA-036-23 | 2023-07-05. Service bulletin. Interior parts made of resin have antistatic coating to prevent dust from sticking on the surfaces, and depending on the conditions of use, the antistatic components may crystallize slightly, giving an appearance of white stains on the surface. To remove the stains, wipe the stained surface with a towel soaked with water mixed with a small portion of a neutral detergent. If the white stains reappear again, simply wipe them again in the same way. NOTE: The antistatic effect does not deteriorate with this procedure. |
| SA-012-23 | 2023-04-04. Service bulletin. Some customers may report an odor or water in the HVAC system and upon inspection, the cabin air filter may be found to be wet. |
| SA-016-23 | 2023-04-04. Service bulletin. There are currently 2 methods for cutting a new auxiliary key blank. A. Auxiliary Key Trace Cut Method. B. Auxiliary Key Code Cut Method |