Service bulletin NTB17-084

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10120568
Published by NHTSA	2017-10-25
Manufacturer's number	NTB17-084
Manufacturer's date	2017-07-24
NHTSA component	STRUCTURE:BODY:DOOR

NHTSA's summary

2014-2017 ROGUE AND ROGUE HYBRID; SQUEAK OR RATTLE FROM FRONT DOOR FINISHER IF YOU CONFIRM While driving, a squeak noise is heard from either front door finisher in the areas shown in Figure 1, and The noise stops when the area is pressed, and The VIN begins with 5N1. or The VIN begins with KNM and was built before KNMAT2M(**)GP 605885 // October 1, 2015. AND/OR A rattle noise is heard when either front door outside handle is operated, and The VIN begins with 5N1 and was built before 5N1AT2M(**)HC 830035 // May 1, 2017. ACTION - If applicable, apply felt tape to repair front door finisher squeak noise. See page 2. - If applicable, apply felt tape to repair front door handle noise. See page 4.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Body and frame

Vehicles listed
NISSAN ROGUE	2014, 2015, 2016, 2017

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
2016165	2016-04-15. Structure
16V219000	2016-04-15. STRUCTURE:BODY:HATCHBACK/LIFTGATE:SUPPORT DEVICE/STRUT
2015334	2015-07-23. Structure

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
NTB09-131C	2026-04-29. Service bulletin. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
NTB09-131C	2026-04-29. Service bulletin. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
NTB13-028H	2023-03-07. Service bulletin. REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB09-081J	2023-03-07. Service bulletin. WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB15062A	2021-05-10. Service bulletin. IF YOU CONFIRM There is a popping noise from either the right or the left front coil springs when turning to the right or left. NOTE: Electronic chassis ears may be helpful in isolating this type of noise. ACTION Replace both front coil springs, strut mount bearings, and all other parts listed under PARTS INFORMATION. Position the coil springs as shown on pages 2-5. Check the front end alignment, adjust to factory specifications as needed. NOTE: Refer to the Electronic Service Manual (ESM), section FSU Front Suspension, for strut coil spring removal, installation, and alignment information. IMPORTANT: The Coil Spring Installation Guidelines section in this bulletin MUST be followed in order for a correct repair to be performed.
NTB15070	2021-05-10. Service bulletin. IF YOU CONFIRM An oil leak from the Adapter Case Oil Seal or the O-ring (see Figure 1). ACTION NOTE: DO NOT replace the Transfer Case for a leak from the Adapter Case Oil Seal or the O-ring. Reseal the Adapter Case with the seals listed in PARTS INFORMATION and shown in Figure 1. * Please see this bulletin for further details.
NTB14105	2021-05-10. Service bulletin. IF YOU CONFIRM: The carpet is wet on the driver and/or front passenger floor (see Figure 1). - A "sloshing" type noise may be heard while driving AND the source of the wetness is not caused by the air conditioning system. ACTION: 1. Determine if the leak is from the kick panel and/or cowl end area. 2. If confirmed, apply body sealant to the incident areas as outlined in this bulletin. See this bulletin for further detail.
PC315	2021-05-10. Service bulletin. Nissan is conducting a dealer service action of the rear lift gate hinge mounting bolt torque on 1,372 specific 2014 Rogue vehicles identified in SERVICE COMM.
NTB14047	2021-05-10. Service bulletin. IF YOU CONFIRM: The "front door power window and door lock/unlock switch (RH) finisher" (switch finisher) has a loose fit, causting an excessive gap. See Figure 1. ACTION: 1. Remove the passenger front door finisher (door finisher). - Refer to the Electronic Service Manual (ESM), section INT-Interior, for removal procedure. 2. Install a foam block where shown in SERVICE PROCEDURE. - Use the foam block listed in PARTS INFORMATION. 3. Install the door finisher with a new switch finisher listed in PARTS INFORMATION. - Refer to the ESM, section INT-Interior, for installation procedure. See this bulletin for further detail.
PC255	2021-05-10. Service bulletin. Nissan is conducting a Dealer Service Action to inspect for water leaks at the rear liftgate glass on certain specific 2014 Nissan Rogue vehicles currently in dealer inventory.