WenmarOpen by Wenmar Pro

Service bulletin TSB-14-0068

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10055782
Published by NHTSA2014-07-17
Manufacturer's numberTSB-14-0068
Manufacturer's date2014-04-03
NHTSA componentENGINE

NHTSA's summary

FORD: THE POWERTRAIN CONTROL MODULE (PCM) MEMORY HAS A CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODE (CMDTC), P0118, STORED THAT CAUSES THE MALFUNCTION INDICATOR LIGHT (MIL) TO BE ILLUMINATED. MODEL 2013 FOCUS. *PE

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Engine

Trouble codes named

P0118

Vehicles listed
FORD FOCUS2013

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
TSB1600452021-12-20. Service bulletin. 2.0L Ecoboost - Fuel odor
TSB1600012021-12-20. Service bulletin. 49 CFR Part 579.5 Monthly Communications - March 2016 Air bag warning light illuminated with diagnostic trouble code (DTC) B141B and/or B141C
LTR37562021-12-20. Service bulletin. 49 CFR Part 579.5 Monthly Communications - January 2016
SSM 479482019-05-07. Service bulletin. SSM 47948 - 2010-2019 Various Vehicles - Turbocharged Engines - Oil Supply Filter Replacement When Replacing The Turbocharger Or The Turbocharger Oil Supply Tube For 2010-2019 vehicles equipped with turbocharged engines, when diagnosing and/or replacing turbo related concerns, all steps within the Workshop Manual (WSM) procedure must be followed including replacement of all mandatory discarded parts. When specified in the WSM, the turbocharger oil supply filter must be replaced whenever the turbocharger or the turbocharger oil supply tube are replaced. Turbocharger bearing failure may occur if oil starvation occurs due to a restricted filter.
SSM 476622019-01-07. Service bulletin. For 2010-2019 vehicles equipped with turbocharged engines, when diagnosing and/or replacing turbo related concerns, all steps within the Workshop Manual (WSM) procedure must be followed including replacement of all mandatory discarded parts. For all turbocharged engine applications, the turbocharger oil supply filter (6C683 gas engine/6L625 connector style or 6A968 diesel engine) must be replaced whenever the turbocharger or the turbocharger oil supply tube are replaced. Turbocharger bearing failure may occur if oil starvation occurs due to a restricted filter.
SSM 475632018-11-19. Service bulletin. Some 2011-2014 Fiesta and 2012-2014 Focus vehicles equipped with a DPS6 transmission may experience a fluid leak between the engine and transmission. Be aware that the engine oil and DPS6 transmission fluid are similar in color and texture. A transmission fluid leak at the input shaft seal can cause a buildup of fluid in the bell housing; creating the appearance of a rear main seal leak. The rear main seal should only be replaced after a rear main seal failure is confirmed through appropriate diagnostics outlined in the updated online Workshop Manual (WSM) Section 303-00 / Diagnosis and Testing with the use of Fluorescent dye (164-TP33200601).
SSM 474622018-09-24. Service bulletin. 2015-2018 Edge, Fusion, Focus, MKZ, MKC, Escape vehicles equipped with a 2.0L EcoBoost engine may exhibit coolant consumption, white smoke and/or a runs rough condition. Refer to the extended coolant pressure test and checking for combustion gases in Workshop Manual (WSM), Section 303-03A. If internal coolant loss is confirmed, further investigation of the head gasket interface is required. Carefully inspect the cylinder block and head for erosion, pitting, and flatness defects, primarily between the cylinder to cylinder bore bridges. If defects to the aluminum surface on the cylinder block and/or cylinder head are found, follow the cost cap tool for component replacement. Follow WSM, Section 303-01A for the repair procedures
SSM 460852017-08-01. Service bulletin. The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic throttle bodies (ETBs). The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.
SSM 463032017-03-15. Service bulletin. THE 2012-2017 FOCUS WORKSHOP MANUAL (WSM) PROCEDURE FOR OIL PAN AND REAR MAIN OIL SEAL INSTALLATION HAS BEEN REVISED. REFER TO WSM, SECTION 303-01 REMOVAL AND INSTALLATION. THE SEALANT APPLICATION LOCATION HAS BEEN REVISED. SPECIAL ATTENTION SHOULD BE USED AT T-JOINT LOCATIONS FOR CLEANLINESS AND SEALANT APPLICATION.
SSM 462952017-03-15. Service bulletin. TO HELP DIFFERENTIATE ENGINE OIL LEAKS FROM OTHER POSSIBLE SOURCES, A NEW WHITE-COLORED FLUORESCENT ENGINE OIL DYE IS AVAILABLE. WORKSHOP MANUAL (WSM), SECTION 303-00 HAS BEEN REVISED TO REFERENCE THE NEW WHITE-COLORED DYE. THE NEW WHITE FLUORESCENT DYE PROVIDES A DISTINCT WHITE GLOW TO IDENTIFY ENGINE OIL LEAKS. THE NEW WHITE FLUORESCENT DYE REQUIRES A PURE UV DIAGNOSTIC INSPECTION LAMP. THE WHITE-COLORED FLUORESCENT DYE AND PURE UV LAMP ARE NOW IN THE ROTUNDA CATALOG. DYE AND LAMP PART NUMBERS. GASOLINE ONLY DYE: 1 OUNCE BOTTLE 164-TP-33200601. DIESEL ONLY DYE: 8 OUNCE BOTTLE: 164-TP-3320-0008. PURE UV DIAGNOSTIC INSPECTION LAMP 164-TP8695 OR 164-R3748.