Service bulletin ITB-12-075
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10048359 |
| Published by NHTSA | 2012-12-18 |
| Manufacturer's number | ITB-12-075 |
| Manufacturer's date | 2014-02-06 |
| Replaces | ITB-12-075-B |
| NHTSA component | FUEL SYSTEM, OTHER:STORAGE:FUEL GAUGE SYSTEM |
NHTSA's summary
INFINITI: AFTER FILLING UP FUEL TANK, THE FUEL GAUGE WOULD REGISTER TANK IS EMPTY AND FUEL PUMP ASSEMBLY, FUEL LEVEL SENSOR UNIT, AND SPRING AND FUEL FILTER, SHOULD BE REMOVE AND REPLACED AND INSTALLED. MODELS 2009-2012 FX35, FX50. *PE UPDATED 03/14/14. *PE
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Fuel system
| INFINITI FX35 | 2009, 2010 |
|---|---|
| INFINITI FX35 | 2011 |
| INFINITI FX35 | 2012 |
| INFINITI FX50 | 2009, 2010, 2011, 2012 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| ITB13-044J | 2022-03-12. Service bulletin. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
|---|---|
| ITB12075B | 2021-05-10. Service bulletin. IF YOU CONFIRM: An applied vehicle has a fuel gauge that registers "empty" after the fuel tank has been filled up full. ACTION: 1. Remove the main fuel level sensor unit, fuel filter, and fuel pump assembly (fuel pump module). 2. Install two (2) new springs onto the fuel pump module. 3. Install the fuel pump module into the vehicle. - For repairs, refer to SERVICE PROCEDURE. See this bulletin for further detail. |
| ITB09012F | 2021-05-10. Service bulletin. SERVICE INFORMATION If one or more of these EVAP leak DTCs are stored (P0442, P0455, P0456) on a 2007 through 2011 Infiniti vehicle, a loose fuel fill cap may be the cause. Use the following resources to perform diagnostics and confirm the cause of stored DTCs. ASIST: - Appropriate Service Manual diagnostic procedures - Applicable Technical Service Bulletins (TSB). Leak Test: - With CONSULT-III plus - WORK SUPPORT >> EVAP SYSTEM CLOSE. NOTE: Use Essential Tool J-42909 or equivalent to pressurize the EVAP system. - With a "Smoke" leak detection machine. Refer to the machine's Operator's Manual for proper use. Make sure the customer is informed of the proper fuel filler cap installation. |
| ITB17-026b | 2019-01-07. Service bulletin. INFINITI; FUEL TANK IS EXTREMELY DIFFICULT TO FILL The update below was sent out to Regions and Retailers in August of this year. We are re-circulating this update to make regional and retailer personnel aware that we are re-notifying clients at this time. |
| ITB17-026b | 2018-09-17. Service bulletin. INFINITI; FUEL TANK IS EXTREMELY DIFFICULT TO FILL This bulletin has been amended. Changes have been made throughout. It is necessary for you to read this revised procedure to properly perform this action. Please discard previous versions of this bulletin. |
| ITB17-026a | 2018-09-17. Service bulletin. INFINITI; FUEL TANK IS EXTREMELY DIFFICULT TO FILL IF CUSTOMER REPORTS: Customer routinely experiences difficulty fueling the vehicle at different fuel stations (filling nozzle shuts off every few seconds while filling at multiple stations and using multiple filling pumps). IMPORTANT: - If the customer does not report the above symptoms, this bulletin does not apply. - If the customer reports intermittent (but not consistent difficulty re-fueling), this bulletin does not apply. ACTION: Perform the Inspection Procedure in this bulletin, starting on page 4, only if the customer reports symptoms as described above. NOTE: Refer to the Repair Overview on page 2. |
| ITB13-044f | 2018-09-17. Service bulletin. ALL MODEL YEAR 2012 AND NEWER INFINITI VEHICLES; EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. The publication date has been revised to include the latest models and model years, and the Service Procedure has been updated. Please discard previous versions of this bulletin. |
| ITB17-026 | 2017-08-01. Service bulletin. INFINITI; FUEL TANK IS SLOW OR DIFFICULT TO FILL IF YOU CONFIRM The fuel tank is slow or difficult to fill (filling nozzle shuts off before tank is full). IMPORTANT: Make sure this incident has been duplicated at a gas station by dealer service staff. ACTION Perform the Service Procedure in this bulletin, starting on the next page. |
| ITB-13-044 | 2013-12-07. Service bulletin. INFINITI: THE INSTRUMENT CLUSTER HAS A WARNING INDICATOR, THAT ILLUMINATES, OF A LOOSE FUEL FILL CAP. MODEL YEARS 2012 AND UP. NO MODELS LISTED. *PE |
| ITB-09-012-F | 2013-12-07. Service bulletin. INFINITI: DUE TO A LOOSE FUEL FILL CAP, THE EVAP LEAK DTCS (P0442, P0455, P0456) ARE STORED AND MAY BE THE CAUSE. MODEL YEARS 2007-2011. NO MODELS LISTED. *PE |