Transport Canada recall 2026308
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2026308 |
| Manufacturer's number | R0312 / 61D197 |
| Reported | 2026-06-24 |
| Component | Lights And Instruments |
| Notification type | Compliance Mfr |
| Units potentially affected | 26948 |
What is wrong
Issue:
On certain vehicles, a software problem could cause the instrument panel cluster to reboot while driving. As a result, you may not be able to see certain information about the vehicle, including the speedometer, fuel gauge, warning lights and malfunction tell-tales.
Note: This recall only affects hybrid (HEV) and plug-in hybrid (PHEV) models equipped with a heads-up display.
Safety Risk:
Warnings, tell-tales and gauges that don't display could increase the risk of a crash.
Corrective Actions:
Hyundai will notify owners in writing and send a wireless over-the-air software update to eligible vehicles to update the instrument panel cluster software. Alternatively, you may schedule an appointment to have the update performed at a Hyundai dealership.
| 2025 HYUNDAI TUCSON | |
|---|---|
| 2026 HYUNDAI TUCSON |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 26-01-040H-1 TSB | 2026-09-02. Warranty extension. Certain Tucson (NX4A) vehicles equipped with bulb type "inside rear combination lamp assembly" may have a crack on the left-hand side. This bulletin provides instructions to inspect the "inside rear combination lamp assembly" and replace it if a crack is found, or to install washers to prevent a crack from developing. |
|---|---|
| 26-01-040H DCS | 2026-05-08. Warranty extension. Certain Tucson (NX4A) vehicles have a crack on the left-hand side of the “inside rear combination lamp assembly" due to interference with the tailgate panel. Technical Service Bulletin (TSB) 26-01-040H provides instructions to replace the “inside rear combination lamp assembly". |
| 26-01-040H TSB | 2026-05-08. Warranty extension. Certain Tucson (NX4A) vehicles have a crack on the left-hand side of the “inside rear combination lamp assembly” due to interference with the tailgate panel. This bulletin provides instructions to replace the “inside rear combination lamp assembly.” |
| 26-AD-001H TSB | 2026-03-07. Service bulletin. Some 2019MY and newer vehicles equipped with a front view camera may illuminate certain warning lights and trigger DTC C272246 fault code for the front camera. In the following cases, the front camera auto-calibration range may be exceeded while driving: • If the front camera is not properly installed and is completely or partially detached. • In case of excessive changes affecting the vehicle's balance (e.g., loading excessively heavy cargo in a specific location of the vehicle, or significant under-inflation of the tires). • Specific road conditions affecting the vehicle's balance (e.g., excessive road crown) This TSB provides instructions on how to service the vehicle when the front camera related warning light(s) are triggered due to system out of calibration (DTC_C272246). |
| 25-BD-012H TSB | 2025-11-12. Service bulletin. This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.