Warranty extension 26-01-040H DCS
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Warranty extension |
|---|---|
| NHTSA id | 11032527 |
| Published by NHTSA | 2026-05-08 |
| Manufacturer's number | 26-01-040H DCS |
| Manufacturer's date | 2026-04-24 |
| Campaign id or software version | LA19 |
| NHTSA component | EXTERIOR LIGHTING |
NHTSA's summary
Certain Tucson (NX4A) vehicles have a crack on the left-hand side of the “inside rear combination lamp assembly" due to interference with the tailgate panel. Technical Service Bulletin (TSB) 26-01-040H provides instructions to replace the “inside rear combination lamp assembly".
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Lighting
| HYUNDAI TUCSON | 2026 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2026308 | 2026-06-24. Lights And Instruments |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 26-01-040H-1 TSB | 2026-09-02. Warranty extension. Certain Tucson (NX4A) vehicles equipped with bulb type "inside rear combination lamp assembly" may have a crack on the left-hand side. This bulletin provides instructions to inspect the "inside rear combination lamp assembly" and replace it if a crack is found, or to install washers to prevent a crack from developing. |
|---|---|
| 26-01-040H TSB | 2026-05-08. Warranty extension. Certain Tucson (NX4A) vehicles have a crack on the left-hand side of the “inside rear combination lamp assembly” due to interference with the tailgate panel. This bulletin provides instructions to replace the “inside rear combination lamp assembly.” |
| 26-AD-001H TSB | 2026-03-07. Service bulletin. Some 2019MY and newer vehicles equipped with a front view camera may illuminate certain warning lights and trigger DTC C272246 fault code for the front camera. In the following cases, the front camera auto-calibration range may be exceeded while driving: • If the front camera is not properly installed and is completely or partially detached. • In case of excessive changes affecting the vehicle's balance (e.g., loading excessively heavy cargo in a specific location of the vehicle, or significant under-inflation of the tires). • Specific road conditions affecting the vehicle's balance (e.g., excessive road crown) This TSB provides instructions on how to service the vehicle when the front camera related warning light(s) are triggered due to system out of calibration (DTC_C272246). |
| 25-BD-012H TSB | 2025-11-12. Service bulletin. This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation. |