Transport Canada recall 2022636
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2022636 |
| Manufacturer's number | 22C27 |
| Reported | 2022-11-04 |
| Component | Visual System |
| Notification type | Compliance Mfr |
| Units potentially affected | 3200 |
What is wrong
Issue:
Under certain conditions when the vehicle is operated in 4WD-Low (4L) mode, the rearview camera image could reappear on the display after shifting out of reverse.
Note: This recall only affects certain vehicles equipped with an 8-inch display.
Safety Risk:
A rearview camera image that displays when the vehicle is not in reverse may confuse or distract the driver. This could increase the risk of a crash.
Corrective Actions:
Ford will notify owners by mail and send a wireless over-the-air software update for the SYNC module to each vehicle. Alternatively, you may schedule an appointment to have the update performed at a Ford dealership.
| 2021 FORD BRONCO | |
|---|---|
| 2022 FORD BRONCO |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 54961 | 2026-06-29. Service bulletin. Some 2021-2023 Bronco vehicles may exhibit a condition where short drop windows, window bounce-back, and/or one-touch close does not operate properly. This may be due to loss of window initialization. Replacement or reprogramming of the DDM, PDM, and/or any other components may not resolve these conditions.The short drop windows feature may be restored by performing a reset procedure as described in the Digital Owner's Manual > Windows > Using Short Drop Windows > Resetting Short Drop Windows. If the customer is experiencing an inability to fully close the window due to repeated bounce-back events, the window bounce-back feature may be overridden by performing an override procedure as described in the Digital Owner's Manual > Windows > Window Bounce-Back > Overriding Windows Bounce-Back. The one-touch feature may be restored by performing a reset procedure as described in the Digital Owner's Manual > Windows > Opening and Closing the Windows > Resetting One-Touch Close. These symptoms may return after a successful reset/override of the feature. Show the customer where they can find these procedures in the Digital Owner’s Manual so they can have the option to perform the procedures on their own should any of these symptoms return. Inform customers that engineering is aware of these conditions and working on a solution which is expected to be available by the end of Q4 2026. Monitor Professional Technician System (PTS) for additional information. |
|---|---|
| TSB 26-2298 | 2026-06-29. Service bulletin. This article supersedes 25-2551. Reason for update: to correct the descriptions for the liftgate glass weather seals. Some of the vehicles listed in the model statement above may exhibit paint wearing along on the top inner edge of the tailgate where the rear window weather strip contacts the tailgate. This may be due to the accumulation of dirt between the rear window seal and tailgate. |
| SYNC-25.1.7.10.1 Bronco | 2026-04-02. Over-the-air update. "25S49 Recall Remedy: -Infotainment software update to address frozen screens" |
| SYNC-25.2.1.6.5.2 Bronco | 2026-02-25. Over-the-air update. Quality Improvements Include: - Bug Fixing and Feature improvements. - Resolves black screen issue caused when there is no SiriusXM disk space. |
| SSM 53981 | 2025-07-02. Service bulletin. Some 2021-2024 Bronco vehicles may exhibit a rattle from the front windows with the windows placed in the partially down position and driving over rough roads and/or bumps. This may be due to the interface between the window glass and the body mounted glass run. To correct this condition, replace the body mounted glass runs using the body mounted glass run kit (3 door: M2DZ-9821597-E, and 5 door: M2DZ-7821597-F) which contains updated seals for improved sealing performance. For claiming, use causal part 9821597/7821597 and labor operations 23943A and 23943A19 in Section 12 of the Service Labor Time Standards (SLTS) Manual. |
| SSM 53962 | 2025-06-24. Service bulletin. Some 2021-2025 Bronco vehicles may exhibit a water leak from the A-pillar, overhead console/upfitter switches and/or sun visors. If a leak is identified from this area, refer to Workshop Manual (WSM), Section 501-18 Pinpoint Test (PPT) G for water leak diagnosis. If the PPT leads to the replacement of the header seal, a revised header seal has been released for service (M2DZ-7803110-H) which contains a thicker consistent bead of butyl across the entire length of the seal. The header seal will need to be firmly depressed and massaged to make sure all of the butyl that is across the entire header seal will properly adhere to the body, creating a water-tight seal. For claiming, use causal part 7803110 and labor operation 03110A in Section 12 of the Service Labor Time Standards (SLTS) Manual. |
| SSM 53814 | 2025-05-27. Service bulletin. Some 2021-2024 Bronco vehicles may exhibit a water leak from the a-pillar, overhead console/upfitter switches and/or sun visors |
| TSB 25-2212 | 2025-05-21. Service bulletin. Some of the vehicles listed in the Model statement above may exhibit a repeat loss of window initialization which results in a loss of short drop and/or one-touch up and one-touch down feature operation. This may be due to a recent short drop enhancement that is contained in the driver door module (DDM) and passenger door module (PDM) software. |
| 23B35 | 2023-12-05. Service bulletin. Certain 2021-2023 Model Year Bronco Vehicles - Wiper Motor Software Update |
| 23-PU0813-DORUP2 | 2023-10-03. Service bulletin. "Priority Update 23-PU0813-DOR-UP2 for 2022 Bronco vehicles is now available. Quality Improvements include: -Update the strategy to learn window travel hard stop at top and bottom to reduce unintended window bounce back and to prevent loss of one touch function." |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.