WenmarOpen by Wenmar Pro

Transport Canada recall 2022408

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2022408
Manufacturer's numberZ50
Reported2022-07-28
ComponentLights And Instruments
Notification typeCompliance Mfr
Units potentially affected3735

What is wrong

Issue:

Certain vehicles may have been built with a damaged side marker in the left and/or right tail lamp(s). As a result, the side marker lamp(s) may not work.

Safety Risk:

Driving with a side marker lamp that does not work could make the vehicle less visible and increase the risk of a crash.

Corrective Actions:

FCA Canada will notify owners by mail and instruct you to take your vehicle to a dealership to inspect and replace the body-mounted tail lamp assemblies, as required.

Vehicles this campaign lists
2021 JEEP GRAND CHEROKEE
2022 JEEP GRAND CHEROKEE

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
S2308000120 REV.B2024-06-24. Service bulletin. Rain Sensing Auto Wipers and Auto on Head Lamps Inoperative
23004242024-03-18. Service bulletin. Headlamp Condensation Clearing Procedure Some customers may report that on occasion, vehicle exterior head lamp assemblies are fogged with a light layer of condensation on the inside of the lenses.
08012242024-03-18. Service bulletin. Flash: Battery Pack Control Module (BPCM) Diagnostic and System Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set: ? P0AA4-00 - Hybrid Battery Negative Contactor Circuit Stuck Closed. ? P0AA1-00 - Hybrid/EV Battery Positive Contactor ?A? Stuck Closed. Customers may also experience the following: ? The vehicle will not start. This bulletin involves updating the BPCM with the latest available software.
08031232024-01-16. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates **Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC) has been set in the Hybrid Control Processor (HCP) module: ? P16F0-00 - SPI Comm Hardware Fault. Customer may experience one or more of the following: ? Unexpected engine start during a crank (customer is expecting EV mode but the gas engine starts).** ? ?Service Charging System? popup when keying the vehicle to off while still in drive. ? Engine must be started twice to achieve drive ready (at low temperatures around 30°C, 22°F) when the vehicle was entered and started quickly. ? Radiator fan cycling while in park and with vehicle operational. May be described as ?breathing? sound from the front of the vehicle. ? "Performance Limited, Service Fuel System? popup while driving. ? Radiator fan spinning at max speed while charging. The vehicle is providing max cooling when the charging module reaches high temperature. May be described as a loud sound that disappears when the vehicle is unplugged. ? Poor cabin heat in electric mode. ? Temporary loss of cabin cooling (<5s) while driving in electric mode. ? State of Charge (SoC) dropping lower than expected while in eSave Battery Charge mode. ? Turtle mode while refueling in hot ambient. ? Unable to enter electric mode driving while FORM is active. This bulletin involves reprogramming the HCP and AHCP or also known as Power Inverter Module (PIM) with the latest available software. NOTE: Additional module flashes are required for this update to be effective. The following modules are all to be updated along with this HCP and AHCP update: ? Powertrain Control Module (PCM). ? Transmission Control Module (TCM).
23029232024-01-02. Service bulletin. Headlamp Condensation Clearing Procedure Some customers may report that on occasion, vehicle exterior head lamp assemblies are fogged with a light layer of condensation on the inside of the lenses (Fig. 1) . This bulletin is to communicate the procedure for head lamp condensation clearing.
S23080000192024-01-02. Service bulletin. Auto High Beams Characteristics, Auto High Beams Not Turning on When Enabled
S23080001202023-10-30. Service bulletin. Rain Sensing Auto Wipers and Auto on Head Lamps Inoperative
S22230000752023-10-02. Service bulletin. Front Fascia Cover Gaps And Or Poor Fitment Near Headlight.
S23230000632023-10-02. Service bulletin. Outer Tail Lamp Front Edge Has A Gap To The Quarter Panel Or Tail Lamp Appears Loose.
S21080001942023-09-25. Service bulletin. High Beam Headlamps Cannot be Turned on with the Headlamp Switch Set to ?AUTO?

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.