Transport Canada recall 2021748
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2021748 |
| Manufacturer's number | Y94 |
| Reported | 2021-12-10 |
| Component | Lights And Instruments |
| Notification type | Compliance Mfr |
| Units potentially affected | 734 |
What is wrong
Issue:
On certain vehicles, the odometer may not display properly after reaching 21,472 km. This error could lead you not to know how far the vehicle has travelled. As a result, an owner could miss or delay important vehicle maintenance.
Note: Only the Wrangler 4xe model is affected by this recall.
Safety Risk:
Missed or delayed vehicle maintenance could lead to a part failure and increase the risk of a crash.
Corrective Action:
FCA Canada will notify owners by mail and instruct you to bring your vehicle to a dealer to inspect, and if necessary, update the instrument panel cluster software. If your vehicle has over 21,472 km, and the odometer does not display, the instrument panel cluster will be replaced.
| 2021 JEEP WRANGLER |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 0300224 | 2024-03-18. Service bulletin. Front and Rear Axle Sensor Kit **Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) has been set: ? C1451-11 - Service Axle Locker System** Customers may also comment on a Service Axle Locker message displayed in the Electronic Vehicle Information Center (EVIC) for this condition. |
|---|---|
| 2300424 | 2024-03-18. Service bulletin. Headlamp Condensation Clearing Procedure Some customers may report that on occasion, vehicle exterior head lamp assemblies are fogged with a light layer of condensation on the inside of the lenses. |
| 0824923 | 2024-01-16. Service bulletin. Flash: Battery Pack Control Module (BPCM) Diagnostic and System Update Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set: ? P0607-00 - ECU Internal Performance. ? P0C78-00 - Hybrid/EV Battery System Precharge Time Too Long. This bulletin involves updating the BPCM with the latest available software. |
| 2302923 | 2024-01-02. Service bulletin. Headlamp Condensation Clearing Procedure Some customers may report that on occasion, vehicle exterior head lamp assemblies are fogged with a light layer of condensation on the inside of the lenses (Fig. 1) . This bulletin is to communicate the procedure for head lamp condensation clearing. |
| 0804823 | 2024-01-02. Service bulletin. Flash: Battery Pack Control Module (BPCM) Diagnostic and System Updates Customers may experience a false Malfunction Indicator Lamp (MIL) illumination related to PHEV battery: ? P1A21-00 - HV Battery Contactor Control Sequence Incorrect. ? P0B3E-00 - Hybrid/EV Battery Voltage Sense 1 Circuit High. ? P0607-00 - ECU Internal Performance. ? P1E1B-00 - Hybrid/EV Battery Side Voltage System Isolation. ? P0AA4-00 - Hybrid Battery Negative Contactor Circuit Stuck Closed. ? P1C00-00 - Hybrid/EV Battery Voltage Sense 1 Out Of Range Low. ? P1C01-00 - Hybrid/EV Battery Voltage Sense 1 Out Of Range High. ? P1A9B-00 - Hybrid/EV Battery Temperature Sensor 1 Out Of Range High. ? P0BBD-00 - Hybrid Battery Pack Voltage Variation Exceeded Limit. ? P167B-00 - Controlled System Shutdown. ? U1885-00 - Battery Energy Control Module Lost Communication With HCP. ? P0EDD-00 - Hybrid/EV Battery Pack B Deterioration. ? U0111 - Lost Communication With Hybrid Battery Pack Sensor Module. ? P0CA7-00 - Hybrid/EV Battery Discharging Current High. ? P1A0C-00 - Battery Energy Control Module System Voltage Low. This bulletin involves updating the BPCM with the latest available software. NOTE: Additional module flashes are required for this update to be effective, the following modules are all to be updated along with this BPCM update: ? Powertrain Control Module (PCM). ? Integrated Dual Charging Module (IDCM). ? Transmission Control Module (TCM). ? Battery Pack Control Module (BPCM). ? Hybrid Control Processor (HCP), Auxiliary Hybrid Control Processor (AHCP) also known as the Power Inverter Module (PIM). |
| 0804723 | 2024-01-02. Service bulletin. Flash: Integrated Dual Charging Module (IDCM) Enhancements Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following DTCs have been set: ? **B22A9-16 - ECU Internal Performance-Circuit Voltage Below Threshold. ? B22A9-17 - ECU Internal Performance-Circuit Voltage Above Threshold. ? B22A9-19 - ECU Internal Performance-Overcurrent.** ? B22A9-64 - ECU Internal Performance-Signal Plausibility Failure. ? P0D27-00 - Battery Charger 1 Input Voltage Too Low. Customer may also experience the following: ? **Unable to charge the vehicle with level 2 charger.** ? Vehicle would not charge and the charge station circuit breaker in the house / receptacle trips when its plugged into the vehicle. This bulletin involves reprogramming the IDCM with the latest software available. NOTE: Additional module flashes are required for this update to be effective, the following modules are all to be updated along with this IDCM update: ? Powertrain Control Module (PCM). ? Integrated Dual Charging Module (IDCM). ? Transmission Control Module (TCM). ? Battery Pack Control Module (BPCM). ? Hybrid Control Processor (HCP), Auxiliary Hybrid Control Processor (AHCP) also known as the Power Inverter Module (PIM). |
| S2025000001 | 2024-01-02. Service bulletin. Malfunction Indicator Lamp Illumination (MIL). Diagnostic Trouble Code (DTC) P203E ? Reductant Level Sensor 1 Circuit Intermittent-Erratic Set. |
| 2302923 | 2023-04-17. Service bulletin. Headlamp Condensation Clearing Procedure Some customers may report that on occasion, vehicle exterior head lamp assemblies are fogged with a light layer of condensation on the inside of the lenses (Fig. 1) . This bulletin is to communicate the procedure for head lamp condensation clearing. |
| 0804823 | 2023-04-17. Service bulletin. Flash: Battery Pack Control Module (BPCM) Diagnostic and System Updates Customers may experience a false Malfunction Indicator Lamp (MIL) illumination related to PHEV battery: ? P1A21-00 - HV Battery Contactor Control Sequence Incorrect. ? P0B3E-00 - Hybrid/EV Battery Voltage Sense 1 Circuit High. ? P0607-00 - ECU Internal Performance. ? P1E1B-00 - Hybrid/EV Battery Side Voltage System Isolation. ? P0AA4-00 - Hybrid Battery Negative Contactor Circuit Stuck Closed. ? P1C00-00 - Hybrid/EV Battery Voltage Sense 1 Out Of Range Low. ? P1C01-00 - Hybrid/EV Battery Voltage Sense 1 Out Of Range High. ? P1A9B-00 - Hybrid/EV Battery Temperature Sensor 1 Out Of Range High. ? P0BBD-00 - Hybrid Battery Pack Voltage Variation Exceeded Limit. ? P167B-00 - Controlled System Shutdown. ? U1885-00 - Battery Energy Control Module Lost Communication With HCP. ? P0EDD-00 - Hybrid/EV Battery Pack B Deterioration. ? U0111 - Lost Communication With Hybrid Battery Pack Sensor Module. ? P0CA7-00 - Hybrid/EV Battery Discharging Current High. ? P1A0C-00 - Battery Energy Control Module System Voltage Low. This bulletin involves updating the BPCM with the latest available software. NOTE: Additional module flashes are required for this update to be effective, the following modules are all to be updated along with this BPCM update: ? Powertrain Control Module (PCM). ? Integrated Dual Charging Module (IDCM). ? Transmission Control Module (TCM). ? Battery Pack Control Module (BPCM). ? Hybrid Control Processor (HCP), Auxiliary Hybrid Control Processor (AHCP) also known as the Power Inverter Module (PIM). |
| 0804723 | 2023-04-17. Service bulletin. Flash: Integrated Dual Charging Module (IDCM) Enhancements Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following DTCs have been set: ? **B22A9-16 - ECU Internal Performance-Circuit Voltage Below Threshold. ? B22A9-17 - ECU Internal Performance-Circuit Voltage Above Threshold. ? B22A9-19 - ECU Internal Performance-Overcurrent.** ? B22A9-64 - ECU Internal Performance-Signal Plausibility Failure. ? P0D27-00 - Battery Charger 1 Input Voltage Too Low. Customer may also experience the following: ? **Unable to charge the vehicle with level 2 charger.** ? Vehicle would not charge and the charge station circuit breaker in the house / receptacle trips when its plugged into the vehicle. This bulletin involves reprogramming the IDCM with the latest software available. NOTE: Additional module flashes are required for this update to be effective, the following modules are all to be updated along with this IDCM update: ? Powertrain Control Module (PCM). ? Integrated Dual Charging Module (IDCM). ? Transmission Control Module (TCM). ? Battery Pack Control Module (BPCM). ? Hybrid Control Processor (HCP), Auxiliary Hybrid Control Processor (AHCP) also known as the Power Inverter Module (PIM). |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.