Transport Canada recall 2019573
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2019573 |
| Manufacturer's number | V62 |
| Reported | 2019-11-14 |
| Component | Fuel System |
| Notification type | Safety Mfr |
| Units potentially affected | 34764 |
What is wrong
Issue:
On certain vehicles, the fuel pump relay could fail. A fuel pump relay failure can result in a no-start condition or cause a sudden loss of engine power while driving.
Note: Vehicles that had a fuel pump relay replaced as part of a Transport Canada Recall No. 2014-386 (FCA Recall No. P54) or 2015-085 (R09) require a second repair under this recall.
Safety Risk:
A sudden loss of engine power could increase the risk of a crash.
Corrective Actions:
FCA will notify owners by mail and instruct you to take your vehicle to a dealer to replace the fuel pump relay, mounting bracket and related wiring.
| 2011 DODGE DURANGO | |
|---|---|
| 2012 DODGE DURANGO | |
| 2013 DODGE DURANGO | |
| 2011 JEEP GRAND CHEROKEE | |
| 2012 JEEP GRAND CHEROKEE | |
| 2013 JEEP GRAND CHEROKEE |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 105038 | 2025-05-20. Service bulletin. TUBE - FUEL INJECTOR SUPPLY & GASKET - NONE |
|---|---|
| 105039 | 2025-05-16. Service bulletin. TUBE - FUEL INJECTOR SUPPLY & GASKET - NONE |
| 102812 | 2025-03-05. Service bulletin. RAIL - FUEL |
| 9100494 | 2025-01-30. Service bulletin. FUEL PUMP/LEVEL UNIT MODULE For vehicles with Saddle Fuel Tanks, need to determine if there are any DTCs in wiTECH. Follow Service Diagnostics published prior to making any changes. Review any existing SOL or TSBs published for customer complaint issue. Only the Fuel Pump Module should be replaced if there are DTCs associated with the Fuel Level Sensor number 1. Only the Auxiliary Level Sender should be replaced if there are DTCs associated with the Fuel Level Sensor number 2. If there is a mixture of DTCs between the Fuel Pump Module and the Auxiliary Level Sensor, then investigate if there is a Jumper Harness or circuit issue between the Level Sender and the PCM. Verify fuel transfer between auxiliary tank and the primary tank by monitoring the auxiliary level sensor to verify it drops after driving. |
| 0900214REVB | 2022-09-26. Service bulletin. MIL Illumination: P0300, P0302, P0304 or P0306 (X56 Warranty Extension) This bulletin involves checking for excessive cylinder leakage and replacing the cylinder head if necessary. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that any the following Diagnostic Trouble Codes have been set: P0300- Multiple Cylinder Misfire P0302- Cylinder 2 Misfire P0304- Cylinder 4 Misfire P0306- Cylinder 6 Misfire |
| 9003694 | 2022-08-08. Service bulletin. Oil Pump Assembly If error code P06DD present on any Pentastar V6 application, please inspect oil pump for relief valve failure. See photo attached. If valve is found out of place please call Bob Jackson (248) 944-0466 bob.jackson@fcagroup.com, or Joe Lovell (734) 309-6467 joe.lovell@fcagroup.com before proceeding. If unable to reach after 15 minutes record the following information and proceed with oil pump replacement and hold part for return to FCA via Fastrack system |
| 18-039-20 | 2020-05-26. Service bulletin. Possible Driveability Issues due to the Winter-Blend Fuel into the Warmer Season |
| S2008000063 | 2020-05-26. Service bulletin. Malfunction Indicator Lamp (MIL) on. Diagnostic Trouble Codes (DTCs) P2463 ? Diesel Particulate Filter Soot Accumulation, and P2453 ? Diesel Particulate Filter Differential Pressure Sensor Circuit Performance Set. |
| 21-033-14 | 2018-06-11. Service bulletin. FLASH: MIL Illumination For P0730 And Transmission Shift Enhancements This bulletin involves selectively erasing and reprogramming the Transmission Control Module (TCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may find that Diagnostic Trouble Code (DTC) P0730 Incorrect Gear Ratio is setting erroneously. In addition to correcting the DTC, the following Transmission Control Module (TCM) calibration improvements are now available. These updates are broken down by vehicle line and engine category.WK, WD, JK and LC Vehicles equipped with a 3.6L engine (Sales Code ERB) Hanging in gear during HOT ambient temperature conditions while vehicle is loaded or towing. Delayed downshift during acceleration at speeds above 48 kph. (Taiwan, Japan, and China market only). Delayed downshift when driving at altitudes higher than 2500 feet. Inconsistent shifting when towing or while driving up or down steep hills. Delayed upshift while driving in 4 low Intermittent delayed shift. Delayed engagement when shifting from drive to reverse while in 4 low. (JK Rubicon only) Delayed shift from second gear while towing or driving on steep grades. (JK Rubicon only) Intermittent delayed engagement from reverse to drive. Less than desired shift quality in AutoStick mode. (LC vehicles only) Fuel economy improvements. (LC vehicles only)LC Vehicles equipped with a 5.7L engine (Sales Codes EZH or EZC) Hanging in gear during HOT ambient temperature conditions while vehicle is loaded or towing. Bump sensation felt during deceleration or braking. Fuel economy improvements.LC and WK Vehicles equipped with a 6.4L engine (Sales Codes ESH or ESG) Bump sensation felt during deceleration or braking. (LC only) Inconsistent downshift during Wide Open Throttle (WOT) accelerations at highway speeds (i.e. passing). Transmission enhancements to improve acceleration while in reverse going uphill on steep |
| 09-002-14 REV. A | 2018-06-11. Service bulletin. MIL Illumination: P0300, P0302, P0304 or P0306 (X56 Warranty Extension) This bulletin involves checking for excessive cylinder leakage and replacing the cylinder head if necessary. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that any the following Diagnostic Trouble Codes have been set: ? P0300- Multiple Cylinder Misfire ? P0302- Cylinder 2 Misfire ? P0304- Cylinder 4 Misfire ? P0306- Cylinder 6 Misfire |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.