Transport Canada recall 2019567
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2019567 |
| Manufacturer's number | R1917 / R1921 / R1916 / R1920 |
| Reported | 2019-11-11 |
| Component | Brakes |
| Notification type | Safety TC |
| Units potentially affected | 42447 |
What is wrong
Issue:
On certain vehicles, the antilock brake system (ABS) actuator pump may leak brake fluid and malfunction. This would cause the ABS warning lamp to turn on. If this problem is not fixed, damage to the ABS actuator could result in a short circuit.
Note: This is a replacement and expansion of Transport Canada recall 2018-486. All vehicles that did not have the ABS actuator pump replaced under that recall require this repair.
Safety Risk:
A short circuit could increase the risk of a fire, even while parked.
Corrective Actions:
The company will notify owners by mail with an interim notice. A final repair is not yet available. If the ABS warning light stays on for 10 seconds or longer, you should park your vehicle outdoors away from other vehicles or structures. You should also call Nissan or Infiniti Roadside assistance to have your vehicle towed to a dealer for repair. A second notice will be sent to you once the final repair parts are available. This letter will advise you to take their vehicle to a dealer to replace the ABS actuator.
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| NTB19-042F | 2025-02-25. Service bulletin. AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions: • When contamination or foreign material adhere to the lane camera viewing window on the windshield. • When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield. • When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information: • Refer to the following pages. • Use the search keyword “blinking” in the ESM. |
|---|---|
| NTB19-033G | 2025-02-25. Service bulletin. INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual |
| NTB10-145B | 2023-04-06. Service bulletin. ABS/VDC CAN DIAGNOSIS INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB14114A | 2021-05-10. Service bulletin. IF YOU CONFIRM All "hands free" functions of the Intelligent Key (I-Key) do not work. For example, the doors will not lock or unlock when pressing either front door request switch. NOTE: - The issue of all I-Key "hands free" functions not working may occur intermittently or all the time. - The message "No Key Detected" or similar may show on the Vehicle Information Display (located in the combination meter). - All I-Key remote button functions (door lock/unlock, etc.) WILL work normally when all I-Key "hands free" functions are NOT working. ACTION 1. Inspect the I-Key?s battery on its negative contact side. 2. If excessive scratching is found, replace the battery. 3. Verify all I-Key functions (both "hands free" and remote) work properly after battery replacement. NOTE: Do NOT replace the BCM, I-Key, or other parts for the issue described under IF YOU CONFIRM, if it should occur. See this bulletin for further detail. |
| NTB13088A | 2021-05-10. Service bulletin. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail. |
| NTB15060 | 2021-05-10. Service bulletin. SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail. |
| NTB15012A | 2021-05-10. Service bulletin. SERVICE INFORMATION After replacing a BCM in an Applied Vehicle the TPMS must be configured with the correct "DATA PART NO." to complete the repair or a DTC C1769 (CONFIGURATION SETTING) may be set. Use C-III plus through Manual Configuration to do this. The configuration setting is based on the vehicle?s tire pressure (see Table A below for vehicle tire pressures). Please see this bulletin for further details. |
| NTB18-054 | 2018-08-20. Service bulletin. 2018 MURANO; BRAKE BOOSTER DESIGN CHANGE SERVICE INFORMATION A change has been made to the brake booster assembly (booster) and brake booster supply hose (supply hose) for the Applied Vehicles built on or after the Applied Date. - Vehicles built on or after the Applied Date will have the booster?s vacuum supply check valve installed onto the booster (style B) instead of being part of the supply hose. - Vehicles built before the Applied Date will continue to use style A. Visually confirm which style of booster is original equipment for the vehicle before ordering replacement parts. IMPORTANT: Style B booster and supply hose are not interchangeable with style A parts, and cannot be used on vehicles built before the Applied Date. If the vehicle was manufactured in February 2018, visually confirm if style A or style B parts are present before ordering replacement parts. - Refer to the Parts Information below for style specific part numbers. IMPORTANT: Style A and style B parts cannot be interchanged. |
| ITB00-024h | 2018-05-14. Service bulletin. BRAKE NOISE/JUDDER/PEDAL FEEL DIAGNOSIS AND REPAIR This bulletin has been amended. The publication date has been revised to include the latest models and years. No other changes have been made. Please discard previous versions of this bulletin. |
| ITB18-005a | 2018-05-07. Service bulletin. ADAS SYSTEM DTC C1A03, C1A04, AND/OR C1B01 SERVICE INFORMATION This bulletin has been amended. The Applied Vehicles section has been revised. No other changes have been made. Please discard previous versions of this bulletin. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.