Transport Canada recall 2019369
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2019369 |
| Manufacturer's number | 3919G |
| Reported | 2019-07-29 |
| Component | Visual System |
| Notification type | Safety Mfr |
| Units potentially affected | 6791 |
What is wrong
Issue:
On certain cars, the interior rearview mirror glass was not properly attached and could fall off.
Safety Risk:
If interior rearview mirror glass suddenly falls off, the driver’s rear visibility will be decreased. This could increase the risk of a crash.
Corrective Actions:
Mazda will notify owners by mail and instruct them to take their car to a dealer to replace the interior rearview mirror.
| 2019 MAZDA MAZDA3 |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SA-043-26 | 2026-08-04. Service bulletin. This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-063/24 09/06/24 DESCRIPTION The Blind Spot Monitoring (BSM) system can malfunction with the following symptoms if the rear side radar sensors are installed facing the wrong direction. |
|---|---|
| SA-025-25 | 2025-06-05. Service bulletin. Some vehicles may exhibit wiper blade contact with the A-pillar trim, with or without a chattering noise. This condition may be caused by worn or contaminated wiper blades. It can also be caused by bent wiper arms, or loose wiper arm retaining nuts due to improper handling. Improper handling occurs when pulling on or forcing the wiper arms. Technicians should be aware that while replacement of the wiper blade may resolve some cases, correction of bent components or repositioning of the wiper arms, particularly when the retaining nut is loose, requires additional steps to ensure proper alignment and function. |
| SA-039-23a | 2023-10-05. Service bulletin. Some vehicles may experience exterior trim heat damage when parked near a glass building or Low-E windows. This may be caused by the sun's reflection. |
| 09-030-23 | 2023-08-03. Service bulletin. Some customers may experience “Ultrasonic sensor malfunction” warning message displayed in the instrument cluster when driving or at a stop. The warning message continues until the ignition is turned off. Upon inspection, one or more of following DTC are detected in the parking assist unit (ultrasonic). |
| 09-014-23a | 2023-08-03. Service bulletin. Some vehicles may experience white-streak stains appearing on the front door that look like they seeped out from under the outer mirror base. This is caused by water intruding from gaps of the outer mirror body and/or the hinge of the outer mirror, and corrosion occurring on the aluminum die-cast inner base in the outer mirror. Water, including white-salty corrosion, may drip out from gaps under the outer mirror base resulting in white stains on the front door. To eliminate this concern, the front outer mirror inner base has been modified. |
| 09-025-23 | 2023-07-05. Service bulletin. Some customers may complain that the frequency of replenishing the window washer liquid is higher than expected, or they may complain of leakage at or around the washer motor (1). This is caused by a crack that may occur at the joint section of the washer motor housing due to an inappropriate assembly process. To eliminate this concern, the design of the washer motor has been modified to not have a joint section. This is caused by a crack that may occur at the joint section of the washer motor housing due to an inappropriate assembly process. To eliminate this concern, the design of the washer motor has been modified to not have a joint section. |
| 09-021-23 | 2023-06-04. Service bulletin. Some vehicles may experience a gap between the glass and the rear door glass run-channel due to run-channel deformation. This causes poor appearance and wind noise when driving at high speed. This concern is due to the incorrect shape of the glass run-channel. |
| 09-018-23a | 2023-06-04. Service bulletin. Some vehicles may exhibit the glass run channel of the front door interfering with the rear door garnish. This is caused by the front door glass run channel not being fixed strongly enough to the door for the following situations where the cycles of door operation may result in interference and lead to damage on the rear door garnish. When the front door glass is closed, the glass run channel may be forced to move to the B pillar side. During very hot weather, the glass run channel may expand to the B pillar side. To eliminate this concern, the design of the front door glass run channel has been changed to be fixed stronger to the door. |
| SA-012-23 | 2023-04-04. Service bulletin. Some customers may report an odor or water in the HVAC system and upon inspection, the cabin air filter may be found to be wet. |
| SA-010-23 | 2023-03-03. Service bulletin. Some customers may experience one or more electrical malfunctions after a vehicle body repair. The newly painted fender stay (2) may be causing a poor front harness (1) ground connection. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.