Transport Canada recall 2018222
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2018222 |
| Manufacturer's number | U42 |
| Reported | 2018-05-01 |
| Component | Suspension |
| Notification type | Safety Mfr |
| Units potentially affected | 66 |
What is wrong
On certain vehicles, the front suspension lower control arm(s) may have been improperly welded during the manufacturing process, causing the welds to fracture. Fractured welds on the front suspension lower control arm(s) could result in a loss of vehicle stability, increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will inspect, and if necessary, replace the front lower control arms.
| 2018 JEEP COMPASS |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 9004338 Rev 1 | 2026-04-15. Service bulletin. Servicing the stabilizer bar links for Jeep Compass: If bar links need to be replaced, make sure both ends are metal. Do not mix metal and plastic ends on same bar. If replacing existing metal end, only that end can be replaced with new metal end. |
|---|---|
| 9004338 | 2026-04-15. Service bulletin. Jeep Compass built prior to Jan 4, 2021, when servicing the stabilizer bar links. If bar links need to be replaced, make sure both ends are metal. Do not mix metal and plastic ends on same bar. If replacing existing metal end, only that end can be replaced with new metal end. |
| 9100229 | 2023-10-30. Service bulletin. LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect. |
| 9004022 | 2020-01-21. Service bulletin. Air Suspension Components Star Parts Catalog has been updated to show individual service parts for the compressor assembly. This will allow service technicians to repair the root cause without over repairing the system. Replace only the part deemed failed by the diagnostics performed. Individual parts include: - Compressor - Valve block - Individual hoses - Temp sensor - Shield - Air line clips NOTE: in most situations when a new compressor is needed, the compressor as a separate part is the correct repair, and the assembly would not be required. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.